Acid red 18 removal from aqueous solution by nanocrystalline granular ferric hydroxide (GFH); optimization by response surface methodology & genetic-algorithm.

The need for fresh water is more than before by population growth, and industrial development have affected the quality of water supplies, one of the important reason for water contamination is synthetic dyes and their extensive use in industries. Adsorption has been considered as a common methods for dye removal from waters. In this study, Acid Red18 removal in batch mode by using Granular Ferric Hydroxide (GFH) was investigated. The GFH characterized by XRD, FESEM and FTIR analysis. Experiments were designed using RSM-CCD method. The maximum removal efficiency was obtained 78.59% at pH = 5, GFH dosage = 2 g/l, AR18 concentration = 77.5 mg/l and 85 min of contact time. Optimization with RSM and Genetic Algorithm carried out and is similar together. The non-linear adsorption Isotherm and kinetic fitted with Freundlich (R2 = 0.978) and pseudo-second-order (R2 = 0.989) models, respectively. Thermodynamic studies showed that the AR18 adsorption is endothermic process and GFH nature was found spontaneous.

Modeling and optimizing parameters affecting hexavalent chromium adsorption from aqueous solutions using Ti-XAD7 nanocomposite: RSM-CCD approach, kinetic, and isotherm studies.

BACKGROUND: Due to the high toxicity of chromium, particularly as Hexavalent chromium Cr (VI), it is removed from industrial effluents before their discharge into the environment by a variety of methods, including loading catalysts onto the polymeric supports. This study focused on the removal of Cr(VI) from aqueous solutions using Amberlite XAD7 resin loaded titanium dioxide (Ti-XAD7). METHODS: Ti-XAD7 was synthesized using Amberlite XAD-7 impregnated with titanium tetraethoxide. The prepared Ti-XAD7 was characterized by using Fourier transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM) and X-ray diffraction (XRD). Isotherms and kinetic studies were carried out to describe the adsorption behavior of adsorbent for the removal of Cr(VI) ions. Quadratic models considering independent variables, i.e. the initial Cr(VI) concentration, adsorbent dosage, time, and pH, were evaluated and optimized to describe the behavior of Cr(VI) adsorption onto the Ti-XAD7 using RSM based on a Five-level-four-factor CCD approach. RESULTS: The accuracy and the fitting of the model were evaluated by ANOVA with R2 > 0.725 and P value = 5.221 × 10-5. The optimum conditions for the adsorption process were an initial Cr(VI) concentration 2750 ppb, contact time of 51.53 min, pH of 8.7, and Ti-XAD7 dosage of 5.05 g/L. The results revealed that the Langmuir and Sips isotherm models with R2 = 0.998 and 0.999 were the best models fitting the experimental data. The adsorption capacity of Ti-XAD7 and RL constant were 2.73 mg/g and 0.063-0.076 based on the Langmuir isotherm, respectively. Kinetic studies also indicated that the adsorption behavior of Cr(VI) was acceptably explained by the Elovich kinetic model with a good fitting (R2 = 0.97). CONCLUSIONS: Comparison of the Ti-XAD7 and XAD7 yield in chromium adsorption showed that modified XAD7 had higher removal efficiency (about 98%) compared to XAD7 alone.

The effect of continuous ELF-MFs on the level of 5-HIAA in the raphe nucleus of the rat.

The aim of this study was to investigate the effect of continuous extremely low frequency magnetic fields (ELF-MFs) with a frequency of 10 Hz and an intensity of 690-720 µT on the level of 5-hydroxyindolacetic acid (5-HIAA) in adult male Wistar rats. A total of 24 adult Wistar male rats were used, and after exposure with an ELF-MF for 15 successive days, all rats in each test were anesthetized with chloral hydrate. Then, they were placed in a stereotaxic frame for surgery and a microdialysis process. Dialysate samples were analyzed to measure the amount of 5-HIAA by high performance liquid chromatography (HPLC) using electrochemical detection. Results showed that ELF-MF exposure for 15 days, 1 h daily, was not effective in altering the level of 5-HIAA. However, ELF-MF exposure for 15 days, 3 h daily, decreased the level of the 5-HIAA in the raphe nucleus. It can be concluded that ELF-MFs affect the serotonergic system and may be used to treat nervous system diseases. This study is an initial step towards helping cure depression using ELF-MFs.

Physicochemical characteristics of citrus seed oils from kerman, iran.

Recently, there has been a great deal of attention on usage, byproducts, and wastes of the food industry. There have been many studies on the properties of citrus seeds and extracted oil from citrus grown in Kerman, Iran. The rate of oil content of citrus seeds varies between 33.4% and 41.9%. Linoleic acid (33.2% to 36.3%) is the key fatty acid found in citrus seeds oil and oleic (24.8% to 29.3%) and palmitic acids (23.5% to 29.4%) are the next main fatty acids, respectively. There are also other acids found at trivial rates such as stearic, palmitoleic, and linolenic. With variation between 0.54 meg/kg and 0.77 mgq/kg in peroxide values of citrus seed oils, acidity value of the oil varies between 0.44% and 0.72%. The results of the study showed that citrus seeds under study (orange and sour lemon grown in Kerman province) and the extracted oil have the potential of being used as the source of edible oil.