Fast pyrolysis of microalgae remnants in a fluidized bed reactor for bio-oil and biochar production.

In this study, pyrolysis of microalgal remnants was investigated for recovery of energy and nutrients. Chlorella vulgaris biomass was first solvent-extracted for lipid recovery then the remnants were used as the feedstock for fast pyrolysis experiments using a fluidized bed reactor at 500 °C. Yields of bio-oil, biochar, and gas were 53, 31, and 10 wt.%, respectively. Bio-oil from C. vulgaris remnants was a complex mixture of aromatics and straight-chain hydrocarbons, amides, amines, carboxylic acids, phenols, and other compounds with molecular weights ranging from 70 to 1200 Da. Structure and surface topography of the biochar were analyzed. The high inorganic content (potassium, phosphorous, and nitrogen) of the biochar suggests it may be suitable to provide nutrients for crop production. The bio-oil and biochar represented 57% and 36% of the energy content of the microalgae remnant feedstock, respectively.

A dye binding method for measurement of total protein in microalgae.

Protein is a large component of the standing biomass of algae. The total protein content of algae is difficult to measure because of the problems encountered in extracting all of the protein from the cells. Here we modified an existing protein assay to measure total protein in microalgae cells that involves little or no extraction of protein from the cells. Aliquots of fresh or pretreated cells were spotted onto filter paper strips. After drying, the strips were stained in a 0.1% (w/v) solution of the protein stain Coomassie Brilliant Blue R-250 for 16 to 24 h and then destained. The stained protein spots were cut out from the paper, and dye was eluted in 1% (w/v) sodium dodecyl sulfate (SDS). Absorbance at 600 nm was directly proportional to protein concentration. Cells that were recalcitrant to taking up the dye could be either heated at 80°C for 10 min in 1% SDS or briefly sonicated for 3 min to facilitate penetration of the dye into the cells. Total protein measured in Chlorella vulgaris using this method compared closely with that measured using the total N method. Total protein concentrations were measured successfully in 12 algal species using this dye binding method.

Remediation of PCB contaminated soils using iron nano-particles.

In this study, iron nano-particles were used to remediate PCB contaminated soil and an attempt was made to maximize PCB destruction in each treatment step. The results show that nano-particles do aid in the dechlorination process and high PCB destruction efficiencies can be achieved. The destruction efficiency during the preliminary treatment (mixing of soil and iron nano-particles in water) can be increased by increasing the water temperature. The maximum thermal destruction (pyrolysis/combustion of soil after preliminary treatment) of soil-bound PCBs occurs at 300 degrees C in air. A minimum total PCB destruction efficiency of 95% can be achieved by this process. The effect of changing treatment parameters such as type of mixing, time of mixing and mixing conditions and application of other catalysts like iron oxide and V(2)O(5)/TiO(2) was also investigated. It was found that at 300 degrees C in air, iron oxide and V(2)O(5)/TiO(2) are also good catalysts for remediating PCB contaminated soils.

Comparison of volatile aldehydes present in the cooking fumes of extra virgin olive, olive, and canola oils.

Emissions of low molecular weight aldehydes (LMWAs) from deep-frying of extra virgin olive oil, olive oil, and canola oil (control) were investigated at two temperatures, 180 and 240 degrees C, for 15 and 7 h, respectively. The oil fumes were collected in Tedlar bags and then analyzed by gas chromatography-mass spectrometry. Seven alkanals (C2-C7 and C9), eight 2-alkenals (C3-C10), and 2,4-heptadienal were found in the fumes of all three cooking oils. The generation rates of these aldehydes were found to be dependent on heating temperature, showing significant increases with increases in temperature. The LMWA emissions from both kinds of olive oils were very similar and were lower than those observed from canola oil under similar conditions. These results suggest that frying in any type of olive oil, independent of its commercial category, will effectively decrease the generation of volatile aldehydes in the exhaust. This fact is important because less expensive refined olive oil is usually used for deep-frying operations, whereas extra virgin olive oil is usually used as salad dressing.

Form1ation and destruction of chlorinated pollutants during sewage sludge incineration.

The limitations facing land filling and recycling and the planned ban on sea disposal of sludge leads to the expectation that the role of sludge incineration will increase in the future. The expected increase in sludge incineration will also increase scrutiny of the main drawbackto sewage sludge incineration--the formation of hazardous air pollutants (HAPs). Despite the extensive body of knowledge available on sewage sludge combustion, very few studies have been conducted on the formation of HAPs during sludge combustion. In this work, the interactions between sewage sludge pyrolysis products and sludge ash were investigated using a dual chamber flow reactor system and a horizontal laboratory scale reactor. The results of this study shows that sludge ash can catalyze oxidation and chlorination of organics. In the absence of HCl in the gas stream, sludge ash acts as an oxidizing catalyst, but in the presence of HCl, sludge ash acts as a chlorination catalyst producing high yields of organochloride compounds.