Coronary Intravascular Lithotripsy Effectiveness and Safety in a Real-World Cohort.

Background: Coronary artery calcification is a predictor of adverse outcomes after percutaneous coronary intervention (PCI). Intravascular lithotripsy (IVL) is a promising tool for the treatment of calcified lesions. The aim of this study was to assess the effectiveness and safety of IVL. Methods: A single-center observational study of PCI procedure, with assessment of the outcomes of patients undergoing PCI using IVL, was performed. Angiographic procedural success was used as the primary effectiveness endpoint. The primary safety endpoint was defined as a composite of cardiac death, myocardial infarction and target vessel revascularization within 30 days. Results: A total of 111 patients were included. Indications for PCI spanned the spectrum of chronic (53.2%) and acute coronary syndromes (43%). Lesion preparation before IVL was performed with non-compliant (42%), cutting or OPN (14.4%) balloons and with atherectomy techniques in 11% of procedures. Intravascular imaging was used in 21.6% of procedures. The primary effectiveness endpoint was achieved in 100% and the primary safety endpoint in 3.6% of procedures. Peri-procedural complications were minimal and successfully resolved. Conclusions: IVL was an effective and safe technique for the treatment of calcified coronary lesions. These findings contribute to the growing body of evidence supporting the use of IVL in the management of these challenging scenarios.

Three-dimensional simulation for interventional cardiology procedures: Face and content validity.

INTRODUCTION AND OBJECTIVES: Three-dimensional (3D) model simulation provides the opportunity to manipulate real devices and learn intervention skills in a realistic, controlled, and safe environment. To ensure that simulators provide a realistic surrogate to real procedures they must undergo scientific validation. We aimed to evaluate the 3D-printed simulator SimulHeart® for face and content validity to demonstrate its value as a training tool in interventional cardiology (IC). METHODS: Health professionals were recruited from sixteen Portuguese IC units. All participants received a 30-minute theoretical introduction, 10-minute demonstration of each task and then performed the intervention on a 3D-printed simulator (SimulHeart®). Finally, a post-training questionnaire focusing on the appearance of the simulation, simulation content, and satisfaction/self-efficacy was administered. RESULTS: We included 56 participants: 16 "experts" (general and interventional cardiologists), 26 "novices" (cardiology residents), and 14 nurses and allied professionals. On a five-point Likert scale, the overall mean score of face validity was 4.38±0.35 and the overall mean score of content validity was 4.69±0.32. There was no statistically significant difference in the scores provided by "experts" and "novices". Participants reported a high level of satisfaction/self-efficacy with 60.7% considering it strongly improved their skills. The majority (82.1%) "agreed" or "strongly agreed" that after the simulation they felt confident to perform the procedure on a patient. CONCLUSION: The 3D-printed simulator (SimulHeart®) showed excellent face and content validity. 3D simulation may play an important role in future IC training programs. Further research is required to correlate simulator performance with clinical performance in real patients.

Intravascular imaging modalities in coronary intervention: Insights from 3D-printed phantom coronary models.

INTRODUCTION AND OBJECTIVES: Several studies comparing optical coherence tomography (OCT) and intravascular ultrasound (IVUS) have revealed that OCT consistently provides smaller area and diameter measurements. However, comparative assessment in clinical practice is difficult. Three-dimensional (3D) printing offers a unique opportunity to assess intravascular imaging modalities. We aim to compare intravascular imaging modalities using a 3D-printed coronary artery in a realistic simulator and to assess whether OCT underestimates intravascular dimensions, exploring potential corrections. METHODS: A standard realistic left main anatomy with an ostial left anterior descending artery lesion was replicated using 3D printing. After provisional stenting and optimization, IVI was obtained. Modalities included 20 MHz digital IVUS, 60 MHz rotational IVUS (HD-IVUS) and OCT. We assessed luminal area and diameters at standard locations. RESULTS: Considering all coregistered measurements, OCT significantly underestimated area, minimal diameter and maximal diameter measurements in comparison to IVUS and HD-IVUS (p<0.001). No significant differences were found between IVUS and HD-IVUS. A significant systematic dimensional error was found in OCT auto-calibration by comparing known reference diameter of guiding catheter (1.8 mm) to measured mean diameter (1.68 mm±0.04 mm). By applying a correction factor based on the reference guiding catheter area to OCT, the luminal areas and diameters were not significantly different compared to IVUS and HD-IVUS. CONCLUSION: Our findings suggest that automatic spectral calibration method for OCT is inaccurate, with a systematic underestimation of luminal dimensions. When guiding catheter correction is applied the performance of OCT is significantly improved. These results may be clinically relevant and need to be validated.

Cardiovascular Three-Dimensional Printing in Non-Congenital Percutaneous Interventions.

Three-dimensional (3D) printing technology is emerging as a potential new tool for the planning of medical interventions. In the last few years, increasing data have accumulated on its ability to guide interventional cardiology procedures, going beyond initial reports in congenital heart disease settings. In fact, there is compelling evidence on the advantages of a 3D-printed guided strategy for left atrial appendage closure, suggesting a high success rate with optimal device selection and lower radiation load. Furthermore, there is emerging experience in aortic root printing, which may improve the success rate and safety of transcatheter aortic valve replacement and may be of particular interest for targeting low-risk populations. Additionally, there are stimulating reports in mitral valve intervention, setting the tone for this new field in cardiovascular percutaneous intervention. In this clinically oriented paper, we will review current 3D printing use in interventional cardiology and we will address future directions, with a focus on procedural planning and medical simulation.

Disruption of bioresorbable vascular scaffold struts due to loss of radial integrity: insights from optical coherence tomography.

Strut disruption of bioresorbable vascular scaffold is a known potential concern, although uncommon when adequate lesion preparation is achieved and nominal size of the scaffold is respected. It is usually difficult to detect with angiography and/or intravascular ultrasound. Three-dimensional reconstructions of optical coherence tomography facilitates understanding of complex luminal anatomy and configuration of stent struts, providing evaluation of stent integrity immediately after deployment and therefore optimization of the complex revascularization procedure. The present article reports a case where this image modality enabled successful use of a drug-eluting stent inside a bioresorbable vascular scaffold to restore the luminal integrity, jeopardized by struts disruption. This case highlights the need to better characterize coronary atherosclerotic disease complexity before considering bioresorbable vascular scaffold implantation. Optical coherence tomography imaging could be a useful tool for accurate selection of the most suitable lesions for bioresorbable stents and to guide the revascularization process, so that in the event of stent fracture it may be detected and managed in a timely fashion.

Heart transplant coronary artery disease: Multimodality approach in percutaneous intervention.

Coronary artery disease is the most important cause of late morbidity and mortality after heart transplantation. It is usually an immunologic phenomenon termed cardiac allograft vasculopathy, but can also be the result of donor-transmitted atherosclerosis. Routine surveillance by coronary angiography should be complemented by intracoronary imaging, in order to determine the nature of the coronary lesions, and also by assessment of their functional significance to guide the decision whether to perform percutaneous coronary intervention. We report a case of coronary angiography at five-year follow-up after transplantation, using optical coherence tomography and fractional flow reserve to assess and optimize treatment of coronary disease in this challenging population.

Fractional flow reserve of non-culprit vessel post-myocardial infarction: is it reliable?

BACKGROUND: Multi-vessel disease is frequent in patients presenting with myocardial infarction and have an important prognostic impact. The decision to proceed to revascularization in non-culprit vessels can be postponed until ischemia is proven in non-invasive stress tests. On the other hand, there is an increasing evidence to support the role of fractional flow reserve (FFR) in acute coronary syndrome setting. CASE PRESENTATION: We report a case in which a FFR-guided strategy for non-culprit vessels, 3 weeks after an ST-segment elevation myocardial infarction, was followed by a short-term sub-occlusion of the evaluated vessel. CONCLUSION: The timing of the coronary microcirculation recovery post-myocardial infarction, avoiding a possible false negative FFR, and the diagnostic gaps between ischemia and plaque vulnerability are under discussion. An FFR-guided strategy in this setting should be interpreted with caution.

Clinical use of multimodality imaging in the assessment of dilated cardiomyopathy.

Learning objectives: =To understand the use of cardiovascular imaging for diagnosis, evaluation of prognosis and for supporting treatment decisions and monitoring therapy in patients with dilated cardiomyopathy by providing morphologic, functional and etiologic information, including refined assessment of ventricular function. =To provide to the clinical cardiologist the information on what to expect from each imaging modality and how to work together with the cardiovascular imaging expert to fully explore the potential of complementary imaging techniques. = To provide a look into the future role of new imaging modalities such as molecular imaging.

Post-catheterisation arterial thrombosis in children--pathophysiology, prevention, and treatment.

Lower limb ischaemia is the most frequent complication of cardiac catheterisation in children. It is often overlooked, but it can cause significant disability and may limit arterial access sites to repeat diagnostic or interventional catheterisations. A narrative review of the literature on arterial access site thrombosis in children was carried out with a special focus on current evidence that supports preventive and treatment strategies. Anticoagulation, thrombolysis, and thrombectomy have been used successfully to treat arterial access site thrombosis. However, it is not completely established which is the role of each treatment modality and what is the most appropriate timing to deliver it. Therefore, diagnostic and therapeutic strategies have to be prospectively investigated, particularly for clarifying the role of new pharmacologic interventions and of percutaneous and surgical thrombectomy in the current era.

The vulnerable plaque: current concepts and future perspectives on coronary morphology, composition and wall stress imaging.

Cardiovascular imaging plays an important role in the identification and characterization of the vulnerable plaque. A major goal is the ability to identify individuals at risk of plaque rupture and developing an acute coronary syndrome. Early recognition of rupture-prone atherosclerotic plaques may lead to the development of pharmacologic and interventional strategies to reduce acute coronary events. We review state-of-the-art cardiovascular imaging for identification of the vulnerable plaque. There is ample evidence of a close relationship between plaque morphology and patient outcome, but molecular imaging can add significant information on tissue characterization, inflammation and subclinical thrombosis. Additionally, identifying arterial wall exposed to high shear stress may further identify rupture-prone arterial segments. These new modalities may help reduce the individual, social and economic burden of cardiovascular disease.