Discriminatory behavior of a rhodamine 6G decorated mesoporous silica based multiple cation sensor towards Cu2+ and Hg2+vis-à-vis Al3+, Cr3+ and Fe3+: selective removal of Cu2+ and Hg2+ from aqueous media.

Selective identification of metal ions as well as their removal is possible when a sensing unit is anchored to a solid support. In this paper, functionalized mesoporous silica with a pendant rhodamine 6G moiety (R6FMS) has been obtained by successive grafting of an aldehyde derivative of bisphenol A followed by rhodamine 6G over a 3-aminopropyl anchored mesoporous silica framework. The materials have been characterized by powder X-ray diffraction, nitrogen sorption and electron microscopy studies, FT-IR and solid state MAS NMR spectral studies, and thermal analysis. In ethanol, the colorless silica material gives pink coloration in the presence of Al3+, Cr3+, Fe3+ and Cu2+ which is also clearly evident from the generation of an absorption peak at 525 nm. Upon excitation at 500 nm, the fluorescence intensity of the probe increases by 36-, 17-, 40- and 89-fold in the presence of Al3+, Cr3+, Fe3+ and Cu2+ ions, respectively. This suggests that R6FMS is a colorimetric and fluorescent chemosensor for these cations in ethanol. However, when the solvent is changed from ethanol to water, it becomes a selective chemosensor only for Cu2+ and Hg2+, by the generation of a pink color and strong fluorescence at ca. 550 nm, thereby discriminating the trivalent cations. Cations induce the opening of the spirolactam ring resulting in pink coloration and strong fluorescence. The quantum yield and lifetime of the probe have been increased considerably in the presence of these cations in ethanol as well as in aqueous media. The detection limit values for these cations range from 10-6 to 10-8 M. R6FMS has been used to remove Hg2+ and Cu2+ from their aqueous solution with a maximum adsorption capacity of 35 mg g-1 and 148 mg g-1 for Cu2+ and Hg2+, respectively.

The big effect of a small change: formation of CuO nanoparticles instead of covalently bound Cu(ii) over functionalized mesoporous silica and its impact on catalytic efficiency.

Two different heterogeneous catalysts, one with Cu(ii) covalently bonded to functionalized mesoporous silica (FMS-Cu(II)) and another with CuO nanoparticles immobilized over the same silica (FMS-CuO-np), have been synthesized by a common route but with a minor alteration in the sequence of addition of reagents. It is interesting to find that by merely changing the order of the addition of reagents Cu(ii) can be incorporated into the framework in two different forms. In one case Cu(ii) binds to the N and O donor centers present in the functionalized material whereas in the other case CuO nanoparticles are generated in situ. The materials have been thoroughly characterized by powder X-ray diffraction, nitrogen adsorption/desorption, transmission electron microscopy, thermal analysis, FT-IR spectroscopy, solid state MAS-NMR spectroscopy and atomic absorption spectrophotometric studies. The synthesized products have been examined for their catalytic efficiencies in the oxidation of olefins, as a model case. Styrene, α-methyl styrene, cyclohexene, trans-stilbene and cyclooctene have been used as substrates in the presence of tert-butyl hydroperoxide as the oxidant in acetonitrile medium under mild conditions. The products of the catalytic reactions have been identified and estimated by gas chromatography and gas chromatography-mass spectrometry. The rate of conversion of the substrates for both the catalysts is high and the selectivity is also good. But from comparative studies, it is found that FMS-CuO-np which contains CuO nanoparticles shows better efficiency than FMS-Cu(II). The catalysts have been recycled for five catalytic cycles without showing much decrease in their catalytic activity.

Mesoporous silica based recyclable probe for colorimetric detection and separation of ppb level Hg2+ from aqueous medium.

Functional mesoporous silica probes, MCM-TFM and SBA-TFM, have been synthesized with varying pore sizes and having S-donor sites judiciously selected to bind soft metal centers. The soft S-donor centers are contributed by the thiol functional groups that are introduced into the silica matrices by functionalization with tris(4-formylphenyl)amine followed by 2-aminothiophenol. The materials rapidly and selectively detect Hg2+ colorimetrically and the change in color profile can be perceived through bare eyes. The probes can decontaminate the pollutant heavy metal from aqueous medium at ppb level and the materials are recyclable and reusable for several separation cycles.

One Step Synthesis of a Gold/Ordered Mesoporous Carbon Composite Using a Hard Template Method for Electrocatalytic Oxidation of Methanol and Colorimetric Determination of Glutathione.

Ordered mesoporous carbon-supported gold nanoparticles (Au/OMC) have been fabricated in one step through a hard template method using gold nanoparticle-intercalated mesoporous silica (GMS) to explore two different catalytic properties, for example, electrocatalytic oxidation of methanol and colorimetric determination of glutathione (GSH). The catalytically inert but conducting nature of mesoporous carbon (OMC) and promising catalytic activity of gold nanoparticles (AuNPs) has inspired us to synthesize Au/OMC. The as-prepared Au/OMC catalyst was characterized by powder X-ray diffraction, N2 adsorption-desorption, scanning electron microscopy, transmission electron microscopy, energy-dispersive X-ray analysis-elemental mapping, and X-ray photoelectron spectroscopy. The characterization results indicate that AuNPs are uniformly distributed on the surface of OMC. The conducting-OMC framework with a high surface area of Au/OMC provides superior transport of electrons through the porous surface of carbon matrix and resulted in its high efficiency and stability as an electrocatalyst for the oxidation of methanol in comparison to CMK-3, SBA-15, and GMS in alkaline medium. The efficiency of Au/OMC toward methanol oxidation in alkaline medium is much higher in comparison to that in acidic medium. The lower value of I f/I b in the acidic medium in comparison to that in the alkaline medium clearly indicates that the oxidation process with Au/OMC as a catalyst is much more superior in alkaline medium with better tolerance toward the accumulation of intermediate CO species on the active surface area. Furthermore, the Au/OMC catalyst is successfully utilized for the detection and quantification of GSH spectrophotometrically with a limit of detection value of 0.604 nM.