Simulated and measured piezoelectric energy harvesting of dynamic load in tires.

From 2007 in US and from 2022 in EU it is mandatory to use TPMS monitoring in new cars. Sensors mounted in tires require a continuous power supply, which currently only is from batteries. Piezoelectric energy harvesting is a promising technology to harvest energy from tire movement and deformation to prolong usage of batteries and even avoid them inside tires. This study presents a simpler method to simultaneous model the tire deformation and piezoelectric harvester performance by using a new simulation approach - dynamic bending zone. For this, angular and initial velocities were used for rolling motion, while angled polarization was introduced in the model for the piezoelectric material to generate correct voltage from tire deformation. We combined this numerical simulation in COMSOL Multiphysics with real-life measurements of electrical output of a piezoelectric energy harvester that was mounted onto a tire. This modelling approach allowed for 10 times decrease in simulation time as well as simpler investigation of systems parameters influencing the output power. By using experimental data, the simulation could be fine-tuned for material properties and for easier extrapolation of tire deformation with output harvested energy from simulations done at low velocity to the high velocity experimental data.

High magnetoelectric coupling of Metglas and P(VDF-TrFE) laminates.

Magnetoelectric (magnetic/piezoelectric) heterostructures bring new functionalities to develop novel transducer devices such as (wireless) sensors or energy harvesters and thus have been attracting research interest in the last years. We have studied the magnetoelectric coupling between Metglas films (2826 MB) and poly(vinylidene fluoride-trifluoroethylene) (P(VDF-TrFE)) in a laminate structure. The metallic Metglas film itself served as bottom electrode and as top electrode we used an electrically conductive polymer, poly(3,4-ethylene-dioxythiophene):poly(styrene sulfonate) (PEDOT:PSS). Besides a direct electrical wiring via a graphite ink, a novel contactless readout method is presented using a capacitive coupling between the PEDOT:PSS layer and an electrode not in contact with the PEDOT:PSS layer. From the experimental result we determined a magnetoelectric coupling of 1445 V/(cm·Oe) at the magnetoelastic resonance of the structure, which is among the highest reported values for laminate structures of a magnetostrictive and a piezoelectric polymer layer. With the noncontact readout method, a magnetoelectric coupling of about 950 V/(cm·Oe) could be achieved, which surpasses previously reported values for the case of direct sample contacting. 2D laser Doppler vibrometer measurements in combination with FE simulations were applied to reveal the complex vibration pattern resulting in the strong resonant response.

A Micromachined Coupled-Cantilever for Piezoelectric Energy Harvesters.

This paper presents a demonstration of the feasibility of fabricating micro-cantilever harvesters with extended stress distribution and enhanced bandwidth by exploiting an M-shaped two-degrees-of-freedom design. The measured mechanical response of the fabricated device displays the predicted dual resonance peak behavior with the fundamental peak at the intended frequency. This design has the features of high energy conversion efficiency in a miniaturized environment where the available vibrational energy varies in frequency. It makes such a design suitable for future large volume production of integrated self powered sensors nodes for the Internet-of-Things.