Methylated Biochemical Fulvic Acid-Derived Hydrogels with Improved Swelling Behavior and Water Retention Capacity.

Although humic acids (HAs) have been used to prepare absorbent hydrogels, their applications in many areas, such as agriculture, wastewater treatment and hygienic products, are not satisfactory due to their low solubility in organic solvents. In this work, biochemical fulvic acid (BFA), as a kind of HA, was initially methylated for preparation of the methylated BFA (M-BFA), which contributed to enhancing the solubility in organic solvents. Then, M-BFA reacted with N,N'-methylene diacrylamide (MBA) in the N,N-Dimethylacrylamide (DMAA) solution, and the expected hydrogel (M-BFA/DMAA) was successfully obtained. XPS confirmed that there were more C=O and C-N groups in M-BFA/DMAA than in DMAA; thus, M-BFA/DMAA was able to offer more reactive sites for the water adsorption process than DMAA. The combined results of BET and SEM further demonstrated that M-BFA/DMAA possessed a larger BET surface area, a larger pore volume and a more porous structure, which were favorable for the transfer of water and accessibility of water to active sites, facilitating water adsorption and storage. In addition, the swelling ratio and water retention were investigated in deionized (DI) water at different conditions, including test times, temperatures and pHs. Amazingly, the swelling ratio of M-BFA/DMAA was 10% higher than that of DMAA with the water retention time from 100 to 1500 min. Although M-BFA/DMAA and DMAA had similar temperature sensitivities, the pH sensitivity of M-BFA/DMAA was 0.9 higher than that of DMAA. The results proved that M-BFA/DMAA delivered superior water retention when compared to the pristine DMAA. Therefore, the resultant materials are expected to be efficient absorbent materials that can be widely used in water-deficient regions.

CoAl-LDH decorated with cerium oxide as an efficient adsorbent for restoring low-concentration phosphate in wastewater.

The requirement for the removal of phosphorus (P) from wastewater has become progressively stringent, therefore, it is essential to remove low-concentration phosphate from secondary effluents through a tertiary treatment. One of the biggest challenges in removing phosphate from wastewater is the development of low-cost, green, and pollution-free adsorbents. In this study, novel, eco-friendly and low-cost CeO2 nanosphere modifying CoAl-LDH nanosheets (CoAl-LDH/CeO2) were successfully fabricated using a classical hydrothermal strategy. The microstructure and morphology of CoAl LDH/CeO2 were characterized using SEM, TEM, FTIR, XRD, TG, XPS, and BET techniques. The performance of the P adsorption from water for CoAl-LDH/CeO2 was investigated. The influences of adsorption parameters, such as adsorbent dosage, pH, phosphate concentration, adsorption time, and experimental temperature, were investigated through batch adsorption experiments. The batch adsorption experiments showed that the P removal by CoAl-LDH/CeO2 could reach 93.4% at room temperature within 60 minutes. CoAl-LDH/CeO2 showed ultrafast and high-efficiency adsorption for low concentration P contaminated wastewater. Pseudo-second order model exhibited better fitting with the kinetics of the phosphate adsorption, while the Freundlich model well-described the isotherm results (R2 > 0.999). Although Cl-, NO3-and SO42- coexisted in the solution, CoAl-LDH/CeO2 still possessed favourable selectivity for phosphates. More importantly, the adsorption capacities of CoAl-LDH/CeO2 retained over 85% after five cycles. Therefore, the low cost and sustainable utilization of CoAl-LDH/CeO2 for the phosphate removal from secondary effluent with phosphate at a low concentration highlights its potential application to alleviate eutrophication.

Ultrafine particles exposure is associated with specific operative procedures in a multi-chair dental clinic.

Air quality in dental clinics is critical, especially in light of the severe acute respiratory syndrome coronavirus-2 (SARS-CoV-2) pandemic, given that dental professionals and patients are at risk of regular exposure to aerosols and bioaerosols in dental clinics. High levels of ultrafine particles (UFP) may be produced by dental procedures. This study aimed to quantify ultrafine particles (UFP) concentrations in a real multi-chair dental clinic and compare the levels of UFP produced by different dental procedures. The efficiency of a high-volume evacuator (HVE) in reducing the UFP concentrations during dental procedures was also assessed. UFP concentrations were measured both inside and outside of a dental clinic in Shanghai, China during a 12-day period from July to September 2020. Dental activities were recorded during working hours. The mean (±standard deviation) concentrations of indoor and outdoor UFP during the sampling period were 8,209 (±4,407) counts/cm3 and 15,984 (±7,977) counts/cm3, respectively. The indoor UFP concentration was much higher during working hours (10,057 ± 5,725 counts/cm3) than during non-working hours (7,163 ± 2,972 counts/cm3). The UFP concentrations increased significantly during laser periodontal treatment, root canal filling, tooth drilling, and grinding, and were slightly elevated during ultrasonic scaling or tooth extraction by piezo-surgery. The highest UFP concentration (241,136 counts/cm3) was observed during laser periodontal treatment, followed by root canal filling (75,034 counts/cm3), which showed the second highest level. The use of an HVE resulted in lower number concentration of UFP when drilling and grinding teeth with high-speed handpieces, but did not significantly reduce UFP measured during laser periodontal therapy. we found that many dental procedures can generate high concentration of UFP in dental clinics, which may have a great health impact on the dental workers. The use of an HVE may help reduce the exposure to UFP during the use of high-speed handpieces.

Preparation of grafting copolymer of acrylic acid onto loess surface and its adsorption behavior.

Loess is a typical natural mineral particle distributed widely around the world, and it is inexpensive, readily accessible, and harmless to the environment. In this study, loess was modified by surface grafting copolymerization of functional monomers, such as acrylic acid, N-vinyl pyrrolidone, and N,N-methylenebisacrylamide as a cross-linking agent, which afforded a novel loess-based grafting copolymer (LC-PAVP). After being characterized by scanning electron microscopy, thermal gravimetric analysis and Fourier-transform infrared spectroscopy, its adsorption capacity and mechanism of removing lead ions (Pb2+) were investigated. With the study of the optimal experimental conditions, it was demonstrated that the removal rate of Pb2+ by LC-PAVP can reach up to 99.49% in 60 min at room temperature. It was also found that the kinetic characteristics of the adsorption capacity due to the pseudo-second-order kinetic model and the thermodynamics conformed well with the Freundlich model. In summary, as a lost-cost and eco-friendly loess-based adsorbent, LC-PAVP is a good potential material for wastewater treatment.

Expression of autophagy­associated proteins in rat dental irreversible pulpitis.

Autophagy serves an important role in numerous diseases, as well as in infection and inflammation. Irreversible pulpitis (IP) is one of the most common inflammatory endodontic diseases, and autophagy has been reported to regulate IP in vitro. However, the level of autophagy in the IP pathogenic process in vivo remains unknown. The aim of the current study was, thus, to investigate the levels of autophagy­associated proteins in rats with IP in vivo. A rat dental IP model was successfully constructed, and five different time points (0, 1, 3, 5 and 7 days) were investigated. The levels of the autophagy­related 5 (ATG5), ATG7, light chain 3 (LC3) and Beclin­1 proteins exhibited a time­dependent increase in rats with IP, whereas the levels of mammalian target of rapamycin and p62/sequestosome 1 were decreased. In addition, the levels of ATG proteins were specifically increased in odontoblasts and microvascular endothelial cells in pulpitis tissue. Based on these findings, autophagy may serve an important role in IP, and the present study data provide a new insight into the IP pathogenesis and treatment.

Status of intracellular and extracellular magnesium concentration in patients with cardiac syndrome X.

OBJECTIVES: This study sought to clarify the differences of intracellular and extracellular magnesium levels in patients with cardiac syndrome X. METHODS: We evaluated the intracellular and extracellular magnesium status of 22 patients with cardiac syndrome X (group A) and 22 age--and gender--matched disorder-free control subjects (group B). Levels of magnesium were determined in serum, urine, erythrocytes, and the 24-h magnesium retention rate was calculated by a magnesium loading test. RESULTS: Group A showed a higher 24-h magnesium retention rate (49.8 +/- 1.3% vs. 32.6 +/- 7.5%, p < 0.05) and a lower intracellular concentration of magnesium in erythrocytes than group B (3.7 +/- 1.4 vs. 5.6 +/- 1.3 fg/cell, p < 0.05), demonstrating the presence of magnesium deficiency in group A. There were no significant differences in the serum concentration of magnesium between groups A and B (0.87 +/- 0.23 vs. 0.83 +/- 0.15 mmol/l). CONCLUSIONS: This study demonstrated that the intracellular magnesium level decreased in patients with cardiac syndrome X.