Investigation of the disinfection efficiency of commercial hydrogen peroxide, chlorine dioxide, and chlorine disinfectant on different surfaces.

OBJECTIVE: The disinfection efficiency of disinfectants differs in specific conditions. This study aimed to investigate the disinfection efficiency of commercial hydrogen peroxide, chlorine dioxide, and chlorine disinfectant on real field surfaces and provide data for precise disinfection. METHODS: Simulated field disinfection and field disinfection methods were conducted to quantitatively evaluate the disinfection efficiency of hydrogen peroxide, chlorine dioxide, and sodium dichloroisocyanurate. The log10 reduction of biological indicators, Escherichia coli (ATCC 8099) and Staphylococcus aureus (ATCC 6538), was calculated. Next, the reduction in natural bacteria on the surfaces of a food production and processing workshop and a biosafety laboratory was determined. RESULTS: The 3 commercial disinfectants evaluated were effective against E coli and S aureus, with a reduction of more than 3.00 log10 colony-forming units/mL tested for an exposure time of 15 minutes with 3.5% hydrogen peroxide, 100 mg/L chlorine dioxide, and 250 mg/L sodium dichloroisocyanurate. The natural load in the food production and processing workshop decreased by more than 90% using 10.5% hydrogen peroxide with an exposure time of 30 minutes. The same disinfection level in the biosafety level 2 laboratory was achieved by 500 mg/L chlorine dioxide at an exposure time of 60 minutes and 450 mg/L sodium dichloroisocyanurate at 60 minutes. CLINICAL RELEVANCE: This study provides a reference for precise disinfection of surfaces in the food industry and biosafety laboratories.

Acid-Triggered Degradation of Three-In-One Ag2S Quantum Dots for In Situ Ratiometric NIR-II Fluorescence Imaging-Guided Ion/Gas Combination Therapy.

Smart theranostic nanoprobes with the integration of multiple therapeutic modalities are preferred for precise diagnosis and efficient therapy of tumors. However, it remains a big challenge to arrange the imaging and two or more kinds of therapeutic agents without weakening the intended performances. In addition, most existing fluorescence (FL) imaging agents suffer from low spatiotemporal resolution due to the short emission wavelength (<900 nm). Here, novel three-in-one Ag2S quantum dot (QD)-based smart theranostic nanoprobes were proposed for in situ ratiometric NIR-II FL imaging-guided ion/gas combination therapy of tumors. Under the acidic tumor microenvironment, three-in-one Ag2S QDs underwent destructive degradation, generating toxic Ag+ and H2S. Meanwhile, their FL emission at 1270 nm was weakened. Upon introduction of a downconversion nanoparticle (DCNP) as the delivery carrier and NIR-II FL reference signal unit, the formed Ag2S QD-based theranostic nanoprobes could achieve precise diagnosis of tumors through ratiometric NIR-II FL signals. Also, the generated Ag+ and H2S enabled specific ion/gas combination therapy toward tumors. By combining the imaging and therapeutic functions, three-in-one Ag2S QDs may open a simple yet reliable avenue to design theranostic nanoprobes.

Effect of Resveratrol on MMP-2 Expression in Scleral Fibroblasts: An In Vitro Study.

PURPOSE: To investigate the effects of resveratrol (Res) on human fetal scleral fibroblasts (HFSFs) and its potential mechanism. METHODS: HFSFs were randomly divided into the Res-treated group and the control group. Following, HFSFs were treated with or without a concentration of 10 µM Res for 48 h. To detect the expression of related genes, reverse transcription quantitative PCR (RT-qPCR) and western blotting were used. The apoptosis rate of different groups was determined using flow cytometry. RESULTS: The mRNA expression of matrix metalloproteinase 2 (MMP-2), Collagen, Type I, Alpha 1 (COL1A1), Janus Kinase 2 (JAK2), and Signal Transducer and Activator of Transcription 3 (STAT3)" was downregulated in the Res-treatment group compared to the control group, according to RT-qPCR. Western blotting revealed that Res therapy reduced the expression of MMP-2, JAK2, P-JAK2, STAT3, P-STAT3, and Bcl-2 associated protein X (Bax) while increasing the expression of COL1A1 and B-cell lymphoma-2 (Bcl-2). Flow cytometry showed that the cell apoptosis rate was significantly lower in HFSFs treated with Res. CONCLUSIONS: In conclusion, these findings suggest that Res increases COL1A1 expression while inhibiting MMP-2 and cell apoptosis in HFSFs, possibly through modulation of the JAK2/STAT3 signaling pathway.

Exploring the performance of protected areas in alleviating future human pressure.

Protected areas (PAs) are effective in mitigating human pressures, yet their future pressure alleviating effects remain unclear. In this study, we employed the ConvLSTM model to forecast the future human footprint and analyzed human pressure trends using Theil-Sen median and Mann-Kendall tests. We further evaluated the mitigating effects of PAs within their buffer zones (1-10 km) and the contributions of different IUCN categories of PAs to mitigating human pressure using linear regression models. The results indicate that by 2035, the average human pressure value is expected to increase by 11%, with trends exhibiting a polarized pattern. Furthermore, PAs also effectively mitigate human pressure within their 1 km buffer zones. Different categories of PAs vary in their effectiveness in mitigating human pressure, and stricter conservation areas are not always the most effective. This study can offer insights for evaluating the effectiveness of PAs in reducing human pressure and advocate for their targeted management in urban areas.

Deep learning-based label-free imaging of lymphatics and aqueous veins in the eye using optical coherence tomography.

We demonstrate an adaptation of deep learning for label-free imaging of the micro-scale lymphatic vessels and aqueous veins in the eye using optical coherence tomography (OCT). The proposed deep learning-based OCT lymphangiography (DL-OCTL) method was trained, validated and tested, using OCT scans (23 volumetric scans comprising 19,736 B-scans) from 11 fresh ex vivo porcine eyes with the corresponding vessel labels generated by a conventional OCT lymphangiography (OCTL) method based on thresholding with attenuation compensation. Compared to conventional OCTL, the DL-OCTL method demonstrates comparable results for imaging lymphatics and aqueous veins in the eye, with an Intersection over Union value of 0.79 ± 0.071 (mean ± standard deviation). In addition, DL-OCTL mitigates the imaging artifacts in conventional OCTL where the OCT signal modelling was corrupted by the tissue heterogeneity, provides ~ 10 times faster processing based on a rough comparison and does not require OCT-related knowledge for correct implementation as in conventional OCTL. With these favorable features, DL-OCTL promises to improve the practicality of OCTL for label-free imaging of lymphatics and aqueous veins for preclinical and clinical imaging applications.

The study of loading mode with in-vitro fatigue testing for mitral annuloplasty ring.

To maintain the physiological dynamics of the mitral annulus, mitral annuloplasty rings (MAR) must be flexible. Enhanced flexibility implies decreased resistance to fatigue and potential for fatigue fracture. This study established new methods to test the flexible fatigue life of MAR in-vitro using numerical analysis; the purpose is that the fatigue test could reflect the real stress distribution in-vivo. Based on the conventional test methods (C1, D1), this paper presents a novel test method (C2, D2). Four testing methods for open-end annuloplasty rings (C1, C2) and closed-end annuloplasty rings (D1, D2) were modelled and their stress distribution calculated by finite element analysis. The mean absolute error (Χ) and the Pearson correlation coefficient (Φ) were used to quantify the difference in stress distribution between the loading modes in-vivo and in-vitro. For closed-end annuloplasty rings, the novel test method (D2) is not obvious better than conventional test methods(D1) in duplicating the stress distribution (ΦD1 = 0.88 vs ΦD2 = 0.92). However, the maximum values of stress in the novel test method are closer to the maximum value of stress under in-vivo loading (ΧD1 = 5.2Mpa vs ΧD2 = 4.4Mpa). For open-end annuloplasty rings, the novel test method(C2) is obviously superior to the conventional test method(C1) in duplicating both the stress distribution and the stress peak values of the in-vivo loading (ΦC1 = 0.22 vs ΦC2 = 0.98; ΧC1 = 59.1Mpa vs ΧC2 = 11.0Mpa). The in-vitro loading methods described in this article more closely approximated in-vivo conditions compared to traditional methods. They are simpler to operate, more efficient and can help manufacturers expedite new product development, assist regulatory agencies with product quality oversight.