Evaluation of Temperature Increase From Joule Heat in Numerical Tooth Model by Applying 500 kHz Current for Apical Periodontitis Treatment-Effect of Applied Voltage and Tooth Conductivity.

For apical periodontitis treatments, a new method with the insertion of an electrode into the root canal of a tooth and application of a current at 500 kHz to sterilize the area by Joule heat has attracted attention. However, few studies have quantified the temperature increase in the root canal. This study aimed to investigate the basic characteristics of the temperature increase in a simple and standard tooth model when energizing a current at 500 kHz to the numerical tooth model with typical electrical and physical properties. We developed a numerical model of a standard tooth (dentin) and periodontal tissues consisting of an alveolar bone, cortical bone, and gingiva, and physiological saline in a root canal and calculated the temperature increase inside the numerical model by a coupled analysis of current and heat when a voltage was applied across the electrodes. The calculated results for the different applied voltages showed a temperature increase at the apical portion of the root canal, which increased with the applied voltage even for the same total supplied energy. The temperature increase occurred at the apical portion of the root canal as the tooth conductivity decreased. When the tooth conductivity was high, a current passed through the dentin, which led to a decrease in the temperature at the apical portion of the root canal. However, a chemical solution with a higher conductivity in the root canal tended to increase the temperature at the apical portion of the root canal, regardless of the tooth conductivity. More efficient approaches for increasing the spatial and temporal temperature for the tooth model target are needed. © 2021 Bioelectromagnetics Society.

Estimation of short-circuit current induced by ELF uniform electric fields in grounded humans with different body shapes based on a semi-ellipsoidal model.

It has been reported that when a grounded human is exposed to an electric field at power frequency, a short-circuit current flowing from the feet to the ground is proportional to the square of his or her height. The current, however, should also vary with the body surface area, that is, body shape, even in people with the same height. In the present study, we confirmed this hypothesis using an analytical solution derived from a semi-ellipsoidal model. The short-circuit currents were calculated for various numerical human body models in which the horizontal length of a voxel was varied from 1.8 to 3.0 mm, and the results for different body shapes were compared. Finally, we derived an approximate expression for estimating the short-circuit current from the left-right width (2b), frontal thickness (2c), and height (a) of a human from the analytical solution. The short-circuit currents obtained from the approximate expression are consistent with those obtained from numerical calculations for 48 differently shaped human body models with a correlation coefficient of 0.9942. Hence, we concluded that the short-circuit current can be determined depending on the similarity ratio (a/b) and the ellipticity ratio (c/b) of the human body as well as the height. This finding is consistent with the numerical human body models that have been used previously, in which the similarity and ellipticity ratios were very close. Therefore, we can make the limited conclusion that the short-circuit current is proportional only to the square of the height. Additionally, numerical calculations showed that the short-circuit current is the same whether one foot or both feet are grounded.

Simple estimation of induced electric fields in nervous system tissues for human exposure to non-uniform electric fields at power frequency.

Most results regarding induced current in the human body related to electric field dosimetry have been calculated under uniform field conditions. We have found in previous work that a contact current is a more suitable way to evaluate induced electric fields, even in the case of exposure to non-uniform fields. If the relationship between induced currents and external non-uniform fields can be understood, induced electric fields in nervous system tissues may be able to be estimated from measurements of ambient non-uniform fields. In the present paper, we numerically calculated the induced electric fields and currents in a human model by considering non-uniform fields based on distortion by a cubic conductor under an unperturbed electric field of 1 kV m(-1) at 60 Hz. We investigated the relationship between a non-uniform external electric field with no human present and the induced current through the neck, and the relationship between the current through the neck and the induced electric fields in nervous system tissues such as the brain, heart, and spinal cord. The results showed that the current through the neck can be formulated by means of an external electric field at the central position of the human head, and the distance between the conductor and the human model. As expected, there is a strong correlation between the current through the neck and the induced electric fields in the nervous system tissues. The combination of these relationships indicates that induced electric fields in these tissues can be estimated solely by measurements of the external field at a point and the distance from the conductor.

Possible Influences of Spark Discharges on Cardiac Pacemakers.

Exposure to spark discharges may occur beneath high voltage transmission lines when contact is initiated with a conductive object (such as a motor vehicle) with the spark discharge mediated by the ambient electric field from the line. The objective of this study was to assess whether such exposures could interfere with the normal functioning of implanted cardiac pacemakers (PMs). The experiment consisted of PMs implanted in a human-sized phantom and then exposed to spark discharge through an upper extremity. A circuit was designed that produced spark discharges between two spherical electrodes fed to the phantom's left hand. The circuit was set to deliver a single discharge per half cycle (every 10 ms) about 10 µs in duration with a peak current of 1.2-1.3 A, thus simulating conditions under a 400-kV power line operating at 50 Hz. Of 29 PMs acquired, all were tested in unipolar configuration and 20 in bipolar configuration with exposure consisting of 2 min of continuous exposure (one unit was exposed for 1 min). No interference was observed in bipolar configuration. One unit in unipolar configuration incorrectly identified ventricular extra systoles (more than 400 beats min(-1)) for 2 s. The use of unipolar configuration in new implants is extremely rare, thus further minimizing the risk of interference with the passage of time. Replication of this study and, if safety for human subjects can be assured, future testing of human subjects is also advisable.

Cardiac pacemakers in magnetic fields of a shunt reactor at a 400†kV substation.

The use of cardiac pacemakers (PMs) increases in Western countries. The aim of the study is to investigate cardiac pacemakers (PMs) using a human-shaped phantom in magnetic fields of a shunt reactor at a 400 kV substation. We performed seven PM experiments using a phantom. Two locations close to the shunt reactors were chosen. The magnetic field exposure was over 1000 µT in one location and over 600 µT in the other one. The magnetic field exposure did not disturb the tested five different PMs (in unipolar or bipolar configurations). It can be stated that in our experiment, the magnetic field exposure (over 600 µT and over 1000 µT) did not disturb the PMs (in unipolar or bipolar configurations). Since we only studied some PMs, it is possible that the magnetic field exposure at 400 kV substations can cause disturbances to other PMs. However, the risk of disturbances does not seem to be high.

Comparison of electric field exposure measurement methods under power lines.

The object of the study was to investigate extremely low frequency (ELF) electric field exposure measurement methods under power lines. The authors compared two different methods under power lines: in Method A, the sensor was placed on a tripod; and Method B required the measurer to hold the meter horizontally so that the distance from him/her was at least 1.5 m. The study includes 20 measurements in three places under 400 kV power lines. The authors used two commercial three-axis meters, EFA-3 and EFA-300. In statistical analyses, they did not find significant differences between Methods A and B. However, in the future, it is important to take into account that measurement methods can, in some cases, influence ELF electric field measurement results, and it is important to report the methods used so that it is possible to repeat the measurements.

Influence of relative humidity on analyzing electric field exposure using ELF electric field measurements.

The objective of the study was to investigate the influence of humidity on analyzing electric field exposure using extremely low frequency (ELF) electric field measurements. The study included 322 measurements in a climate room. We used two commercial three-axis meters, EFA-3 and EFA-300, and employed two measurement techniques in the climate room where we varied the temperature from 15 to 25 °C, the relative humidity from 55% to 95%, and the electric field from 1 to 25 kV/m. We calculated Pearson correlations between humidity and percentage errors for all data and for data at different levels of humidity. When the relative humidity was below 70%, the results obtained by the different measurement methods in terms of percentage errors were of the same order of magnitude for the considered temperatures and field strength, but the results were less reliable when the relative humidity was higher than 80%. In the future, it is important to take humidity into account when electric field measurement results will be compared to the values given in different exposure guidelines.

Numerical evaluation of currents induced in a worker by ELF non-uniform electric fields in high voltage substations and comparison with experimental results.

An ungrounded human, such as a substation worker, receives contact currents when touching a grounded object in electric fields. In this article, contact currents and internal electric fields induced in the human when exposed to non-uniform electric fields at 50 Hz are numerically calculated. This is done using a realistic human model standing at a distance of 0.1-0.5 m from the grounded conductive object. We found that the relationship between the external electric field strength and the contact current obtained by calculation is in good agreement with previous measurements. Calculated results show that the contact currents largely depend on the distance, and that the induced electric fields in the tissues are proportional to the contact current regardless of the non-uniformity of the external electric field. Therefore, it is concluded that the contact current, rather than the spatial average of the external electric field, is more suitable for evaluating electric field dosimetry of tissues. The maximum induced electric field appears in the spinal cord in the central nervous system tissues, with the induced electric field in the spinal cord approaching the basic restriction (100 mV/m) of the new 2010 International Commission on Non-Ionizing Radiation Protection guidelines for occupational exposure, if the contact current is 0.5 mA.

Occupational exposure to electric fields and currents associated with 110 kV substation tasks.

The main aim of this study was to investigate occupational exposure to electric fields, and current densities and contact currents associated with tasks at air-insulated 110 kV substations and analyze if the action value of EU Directive 2004/40/EC was exceeded. Four workers volunteered to simulate the following tasks: Task (A) maintenance of an operating device of a disconnector at ground or floor level, Task (B) maintenance of an operating device of a circuit breaker at ground or floor level, Task (C) breaker head maintenance from a man hoist, and Task (D) maintenance of an operating device of a circuit breaker from a service platform. The highest maximum average current density in the neck was 1.8 mA/m(2) (calculated internal electric field 9.0-18.0 mV/m) and the highest contact current was 79.4 µA. All measured values at substations were lower than the limit value (10 mA/m(2)) of the EU Directive 2004/40/EC and the 2010 basic restrictions (0.1 and 0.8 V/m for central nervous system tissues of the head, and all tissues of the head and body, respectively) of the International Commission on Non-Ionizing Radiation Protection (ICNIRP).

Intercomparison of induced fields in Japanese male model for ELF magnetic field exposures: effect of different computational methods and codes.

The present study provides an intercomparison of the induced quantities in a human model for uniform magnetic field exposures at extremely low frequency. A total of six research groups have cooperated in this joint intercomparison study. The computational conditions and numeric human phantom including the conductivity of tissue were set identically to focus on the uncertainty in computed fields. Differences in the maximal and 99th percentile value of the in situ electric field were less than 30 and 10 % except for the results of one group. Differences in the current density averaged over 1 cm(2) of the central nerve tissue are 10 % or less except for the results of one group. This comparison suggests that the computational uncertainty of the in situ electric field/current density due to different methods and coding is smaller than that caused by different human phantoms and the conductivitys of tissue, which was reported in a previous study.