Location of a Hydrophobic Load in Poly(oligo(ethylene glycol) methyl ether methacrylate)s (PEGMAs) Dissolved in Water and Probed by Fluorescence.

Two series of pyrene-labeled poly(oligo(ethylene glycol) methyl ether methacrylate)s referred to as PyEG5-PEGnMA and PyC4-PEGnMA were prepared to probe the region surrounding the polymethacrylate backbone by using the fluorescence of the dye pyrene. PyEG5-PEGnMA and PyC4-PEGnMA were prepared by copolymerizing the EGnMA methacrylate monomers with penta(ethylene glycol) 1-pyrenemethyl ether methacrylate or 1-pyrenebutyl methacrylate, respectively. In organic solvents, the much longer 18 non-hydrogen atom linker connecting the pyrene moieties to the polymethacrylate backbone in the PyEG5-PEGnMA samples enabled the deployment of the pyrenyl labels into the solution. In water, however, an excited pyrene for PyEG5-PEGnMA was found to probe a same volume as for the PyC4-PEGnMA samples where a much shorter 6 non-hydrogen atom spacer connected pyrene to the backbone. Another surprising observation, considering that the hydrophobicity of pyrene induces strong pyrene aggregation for many pyrene-labeled water-soluble polymers (Py-WSPs) in water, was the little pyrene aggregation found for the PyEG5-PEGnMA and PyC4-PEGnMA samples in water. These effects could be related to the organic-like domain (OLD) generated by the oligo(ethylene glycol) side chains densely arranged around the polymethacrylate backbone of the polymeric bottlebrush (PBB). Additional fluorescence experiments conducted with the penta(ethylene glycol) 1-pyrenemethyl ether derivative indicated that the cylindrical OLD surrounding the polymethacrylate backbone had a chemical composition similar to that of ethylene glycol. Binding of hydrophobic pyrene molecules to unlabeled PEGnMA bottlebrushes in water further supported the existence of the OLD. The demonstration, that PEGnMA samples form an OLD in water, which can host and protect hydrophobic cargoes like pyrene, should lead to the development of improved PEGnMA-based drug delivery systems.

Nanocellulose aerogels as 3D amyloid templates.

Proteins in solution tend to coat solid surfaces upon exposure. Depending on the nature of the surface, the environmental conditions, and the nature of the protein these adsorbed proteins may self-assemble into ordered, fibre-like structures called amyloids. Nanoparticulate surfaces, with their high surface to volume ratio, are particularly favourable to amyloid formation. Most prior research has focussed on either inorganic or organic nanoparticles in solution. In this research, we instead focus on aerogels created from TEMPO-oxidized cellulose nanofibers (TO-CNF) to serve as bio-based, three-dimensional amyloid templates with a tuneable surface chemistry. Previous research on the use of cellulose as a protein adsorption template has shown no evidence of a change in the secondary protein structure. Herein, however, with the aid of the reducing agent TCEP, we were able to induce the formation of amyloid-like 'worms' on the surface of TO-CNF aerogels. Furthermore, we demonstrate that the addition of the TO-CNF aerogel can also induce bulk aggregation under conditions where it previously did not exist. Finally, we show that the addition of the aerogel increases the rate of 'worm' formation in conditions where previous research has found a long lag-phase. Therefore, TO-CNF aerogels are shown to be excellent templates for inducing ordered protein aggregation.

Persistence Length of PEGMA Bottle Brushes Determined by Pyrene Excimer Fluorescence.

Seven pyrene-labeled poly(oligo(ethylene glycol) methyl ether methacrylate)s (PyEG5-PEGnMAs) were prepared with n = 0, 3, 4, 5, 7, 9, and 19 ethylene glycol units by copolymerizing a small amount of penta(ethylene glycol) 1-pyrenemethyl ether methacrylate with an EGnMA monomer. The conformation of the PyEG5-PEGnMA polymers evolved from a random coil for PyEG5-PEG0MA or poly(methyl methacrylate) to a polymeric bottle brush (PBB) architecture with increasing side chain length. The fluorescence decays of the PyEG5-PEGnMA samples were fitted according to the fluorescence blob model (FBM) whose parameters were used, in combination with the Kratky-Porod equation, to calculate the persistence length of these polymers. The persistence lengths obtained from the PEF experiments were found to increase with the square of the number (NS) of non-hydrogen atoms in the side chain as expected theoretically. The persistence lengths found with the PyEG5-PEGnMA samples in DMF also matched those found earlier for another series of PEGnMA samples labeled with 1-pyrenebutanol. The good agreement found between the persistence lengths obtained with the PEGnMA samples labeled with two different pyrene derivatives illustrates the robustness of the method and its applicability for measuring the unknown persistence length of polydisperse polymer samples.

Direct Measure of the Local Concentration of Pyrenyl Groups in Pyrene-Labeled Dendrons Derived from the Rate of Fluorescence Collisional Quenching.

The model-free analysis (MFA) was applied to measure the average rate constant () for pyrene excimer formation (PEF) in a series of pyrene-labeled dendrons referred to as Pyx-G(N), where x (= 2N) is the number of pyrenyl labels born by a dendron of generation N ranging from 1 to 6. was measured in four different solvents, namely tetrahydrofuran (THF), toluene, N,N-dimethylformamide (DMF), and dimethylsulfoxide (DMSO). was found to increase linearly with increasing local pyrene concentration ([Py]loc), where [Py]loc had been determined mathematically for the Pyx-G(N) dendrons. The slope of each straight line changed with the nature of the solvent and represented kdiff, the bimolecular rate constant for PEF. kdiff depended on the solvent viscosity (η) and the probability (p) for PEF upon encounter between an excited and a ground-state pyrene. In a same solvent, kdiff for the Pyx-G(N) dendrons was about 360 ± 30 times smaller than kdiff obtained for ethyl 4-(1-pyrene)butyrate (PyBE), a pyrene model compound similar to the pyrene derivative used to label the dendrons. The massive decrease in kdiff observed for the Pyx-G(N) samples reflected the massive loss in mobility experienced by the pyrenyl labels after being covalently attached onto a macromolecule compared to freely diffusing PyBE. Interestingly, the kdiff values obtained for the Pyx-G(N) dendrons and the PyBE model compound followed similar trends as a function of solvent, indicating that the difference in behavior between the kdiff values obtained in different solvents were merely due to the changes in the η and p values between the solvents. Normalizing the values obtained with the Pyx-G(N) dendrons by the kdiff values obtained for PyBE in the same solvents accounted for changes in η and p, resulting in a master curve upon plotting /(fdiff × kdiff) as a function of [Py]loc, where fdiff was introduced to account for some pyrene aggregation in the higher generation dendron (Py64-G(6)). This result demonstrates that represents a direct measure of [Py]loc in pyrene-labeled macromolecules.

Long Range Polymer Chain Dynamics of Highly Flexible Polysiloxane in Solution Probed by Pyrene Excimer Fluorescence.

A poly(dimethylsiloxane-co-(3-aminopropyl)methylsiloxane) polymer (PDMS with 20.3 mol % of (3-aminopropyl)methyl siloxane monomer) has been labeled randomly with 1-pyreneacetyl groups to generate a series of polysiloxanes (Py-PDMS) with pyrenyl contents ranging from 0.7 mol % to 5.2 mol % of the total number of structural units. The remainder of the amino groups were acetylated to avoid intra-chain quenching of the excited singlet states of pyrene via exciplex formation with free amino groups while allowing the formation of excimers to proceed. The fluorescence spectra and temporal decays of the Py-PDMS samples were acquired in tetrahydrofuran (THF), N,N-dimethylformamide (DMF), and dioxane. blob, the average rate constant for intra-chain pyrene excimer formation, was determined from the analysis of the fluorescence decays. blob was found to equal 1.16 (±0.13) × 108, 1.14 (±0.12) × 108, and 0.99 (±0.10) × 108 s-1 in THF, DMF, and dioxane, respectively, at room temperature. They are the largest values found to date for any polymeric backbone in these solvents. The qualitative relationship found here between blob and the chemical structures of the polymers indicates that the luminescence characteristics of randomly labeled polymers is a very useful method to probe the long range dynamics of chains of almost any polymer that is amenable to substitution by a lumophore.