Properties of Magnetic Garnet Films for Flexible Magneto-Optical Indicators Fabricated by Spin-Coating Method.

Non-destructive testing using a magneto-optical effect is a high-resolution non-destructive inspection technique for a metallic structure. It is able to provide high-spatial resolution images of defects. Previously, it has been difficult to fabricate flexible magneto-optical sensors because thermal treatment is necessary to crystallize the magnetic garnet. Therefore, it was not possible to apply magneto-optical imaging to complicated shapes in a test subject, such as a curved surface. In this study, we developed a new process for deposition of the magnetic garnet on the flexible substrate by applying the magnetic garnet powders that have already undergone crystallization. In this new process, as it does not require thermal treatment after deposition, flexible substrates with low heat resistance can be used. In this paper, we report our observations of the optical properties, magnetic hysteresis loop, crystallizability and density of the particles on the flexible substrate deposited by the spin-coating method.

Three port logic gate using forward volume spin wave interference in a thin yttrium iron garnet film.

We demonstrate a logic gate based on interference of forward volume spin waves (FVSWs) propagating in a 54 nm thick, 100 µm wide yttrium iron garnet waveguide grown epitaxially on a garnet substrate. Two FVSWs injected by coplanar waveguides were made to interfere constructively and destructively by varying their phase difference, showing an XNOR logic function. The reflected and resonant waves generated at the edges of the waveguide were suppressed using spin wave absorbers. The observed isolation ratio was 19 dB for a magnetic field of ~2.80 kOe ( = 223 kA m-1) applied perpendicular to the film. The wavelength and device length were ~8.9 µm and ~53 µm, respectively. Further, the interference state of the SWs was analyzed using three-dimensional radio frequency simulations.

Recording and reconstruction of volumetric magnetic hologram using multilayer medium with heat dissipation layers.

Hologram memory is a strong candidate for optical storage due to its high recording density and high data transfer rate. We have studied and engineered a magnetic hologram memory medium using a stable magnetic garnet as recording material. To record a deep and clear magnetic hologram, it is important to control the heat diffusion generated during recording. Numerical simulation suggested that a multilayer structure with transparent heat-dissipation layers would be effective to address this. We fabricated a multilayer magnetic medium for a collinear magnetic hologram. This medium exhibited a diffraction efficiency as high as that of the single layered one, and errorless recording and reconstruction was achieved with the magnetic assist technique.

Randomly polarised beam produced by magnetooptically Q-switched laser.

Diode-pumped solid-state micro lasers are compact (centimetre-scale), highly stable, and efficient. Previously, we reported Q-switched lasers incorporating rare-earth substituted iron garnet (RIG) film. Here, the first demonstration of the magnetooptical (MO) Q-switch in an Nd:YAG laser cavity is performed. We fabricate a quasi-continuous-wave (QCW) diode-pumped Nd:YAG laser cavity, which is shortened to 10 mm in length and which contains an RIG film and a pair of small coils. This cavity yields a 1,064.58-nm-wavelength pulse with 25-ns duration and 1.1-kW peak power at a 1-kHz repetition ratio. Further, the polarisation state is random, due to the isotropic crystal structure of Nd:YAG and the fact that the MO Q-switch incorporating the RIG film does not require the presence of polarisers in the cavity. This is also the first report of an MO Q-switch producing random polarisation.

Reconstruction of non-error magnetic hologram data by magnetic assist recording.

Hologram memory is expected to be the next-generation of optical data storage technology. Bismuth-substituted yttrium iron garnet is typically used for rewritable magnetic hologram media. The diffraction efficiency of magnetic holography depends on the Faraday rotation angle, but the experimental diffraction efficiency is not as high as that expected from calculations. This difference could be caused by incomplete magnetization reversal at the recorded region. In this study, we investigated the effects of magnetic assist (MA) recording through numerical simulation and experiment to improve the diffraction efficiency and the resulting reconstructed images. The improvement of diffraction efficiency was more effective in garnet films thinner than the width of a fringe, and a suitable value of the assist magnetic field was identified for the improvement. In addition, MA recording improved the intensity of reconstructed images and broadened the non-error recording conditions to the low energy region. This technique shows promise in improving the reconstructed quality of magnetic hologram data.

Thermally stable amorphous tantalum yttrium oxide with low IR absorption for magnetophotonic devices.

Thin film oxide materials often require thermal treatment at high temperature during their preparation, which can limit them from being integrated in a range of microelectronic or optical devices and applications. For instance, it has been a challenge to retain the optical properties of Bragg mirrors in optical systems at temperatures above 700 °C because of changes in the crystalline structure of the high-refractive-index component. In this study, a ~100 nm-thick amorphous film of tantalum oxide and yttrium oxide with an yttrium-to-tantalum atomic fraction of 14% was prepared by magnetron sputtering. The film demonstrated high resistance to annealing above 850 °C without degradation of its optical properties. The electronic and crystalline structures, stoichiometry, optical properties, and integration with magnetooptical materials are discussed. The film was incorporated into Bragg mirrors used with iron garnet microcavities, and it contributed to an order-of-magnitude enhancement of the magnetooptical figure of merit at near-infrared wavelengths.

The role of Snell's law for a magnonic majority gate.

In the fifty years since the postulation of Moore's Law, the increasing energy consumption in silicon electronics has motivated research into emerging devices. An attractive research direction is processing information via the phase of spin waves within magnonic-logic circuits, which function without charge transport and the accompanying heat generation. The functional completeness of magnonic logic circuits based on the majority function was recently proved. However, the performance of such logic circuits was rather poor due to the difficulty of controlling spin waves in the input junction of the waveguides. Here, we show how Snell's law describes the propagation of spin waves in the junction of a Ψ-shaped magnonic majority gate composed of yttrium iron garnet with a partially metallized surface. Based on the analysis, we propose a magnonic counterpart of a core-cladding waveguide to control the wave propagation in the junction. This study has therefore experimentally demonstrated a fundamental building block of a magnonic logic circuit.

Error-free reconstruction of magnetic hologram via improvement of recording conditions in collinear optical system.

Magnetic holographic memory is expected as a rewritable high-capacity data storage technology. To improve the reconstructed image, we investigate recording conditions by numerical simulation and experiments. We found experimentally that four diffracted beams from a digital micromirror device interfere with each other at a suitable defocus recording point, and such overlapping is favorable to obtain clear reconstruction images without diffuser. Subsequently, we modify the shape of the reference beam to ensure more effective interference. As a result, we achieve error-free image reconstruction from the magnetic hologram. Our results indicate that magnetic holograms can potentially be utilized as holographic memory.

Magnetic domains driving a Q-switched laser.

A 10-mm cavity length magnetooptically Q-switched Nd:GdVO4 laser was demonstrated using a single-crystalline ferrimagnetic rare-earth iron garnet film. To design the Q-switching system, the magnetic, optical, and magnetooptical properties of the garnet film were measured. The diode pumped solid-state laser cavity was constructed using a 190-µm-thick garnet film with 58% transmittance. The garnet film had maze-shaped magnetic domains, and the domain walls disappeared when a field of over 200 Oe was applied. Therefore, the polarization state of the transmitted light was modified by modulating the magnetization, and a Q-switched pulse output with a pulse width of 5 ns and peak power of 255 W was achieved in the 10-mm-long cavity. The physical limitation of the pulse width was discussed with the calculated results.