Facile synthesis of efficient Co3O4 nanostructures using the milky sap of Calotropis procera for oxygen evolution reactions and supercapacitor applications.

The preparation of Co3O4 nanostructures by a green method has been rapidly increasing owing to its promising aspects, such as facileness, atom economy, low cost, scale-up synthesis, environmental friendliness, and minimal use of hazardous chemicals. In this study, we report on the synthesis of Co3O4 nanostructures using the milky sap of Calotropis procera (CP) by a low-temperature aqueous chemical growth method. The milky sap of CP-mediated Co3O4 nanostructures were investigated for oxygen evolution reactions (OERs) and supercapacitor applications. The structure and shape characterizations were done by X-ray diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive spectroscopy (EDS), and X-ray photoelectron spectroscopy (XPS) techniques. The prepared Co3O4 nanostructures showed a heterogeneous morphology consisting of nanoparticles and large micro clusters. A typical cubic phase and a spinel structure of Co3O4 nanostructures were also observed. The OER result was obtained at a low overpotential of 250 mV at 10 mA cm-2 and a low Tafel slope of 53 mV dec-1. In addition, the durability of 45 hours was also found at 20 mA cm-2. The newly prepared Co3O4 nanostructures using the milky sap of CP were also used to demonstrate a high specific capacitance of 700 F g-1 at a current density of 0.8 A g-1 and a power density of 30 W h kg-1. The enhanced electrochemical performance of Co3O4 nanostructures prepared using the milky sap of CP could be attributed to the surface oxygen vacancies, a relatively high amount of Co2+, the reduction in the optical band gap and the fast charge transfer rate. These surface, structural, and optical properties were induced by reducing, capping, and stabilizing agents from the milky sap of CP. The obtained results of OERs and supercapacitor applications strongly recommend the use of the milky sap of CP for the synthesis of diverse efficient nanostructured materials in a specific application, particularly in energy conversion and storage devices.

ZnO Nanostructures Doped with Various Chloride Ion Concentrations for Efficient Photocatalytic Degradation of Methylene Blue in Alkaline and Acidic Media.

In this study, chloride (Cl−) ions were successfully doped into ZnO nanostructures by the solvothermal method. The effect of various Cl− concentrations on the photocatalytic activity of ZnO towards the photodegradation of methylene blue (MB) under the illumination of ultraviolet light was studied. The as-prepared Cl−-doped ZnO nanostructures were analyzed in terms of morphology, structure, composition and optical properties. XRD data revealed an average crystallite size of 23 nm, and the XRD patterns were assigned to the wurtzite structure of ZnO even after doping with Cl−. Importantly, the optical band gap of various Cl ion-doped ZnO nanostructures was successively reduced from 3.42 to 3.16 eV. The photodegradation efficiency of various Cl− ion-doped ZnO nanostructures was studied for MB in aqueous solution, and the relative performance of each Cl ion-doped ZnO sample was as follows: 20% Cl−-doped ZnO > 15% Cl−-doped ZnO > 10% Cl−-doped ZnO > 5% Cl−-doped ZnO > pristine ZnO. Furthermore, the correlation of the pH of the MB solution and each Cl ion dopant concentration was also investigated. The combined results of varying dopant levels and the effect of the pH of the MB solution on the photodegradation process verified the crucial role of Cl− ions in activating the degradation kinetics of MB. Therefore, these newly developed photocatalysts could be considered as alternative materials for practical applications such as wastewater treatment.