Rubrene single crystal solar cells and the effect of crystallinity on interfacial recombination.

Single crystal studies provide a better understanding of the basic properties of organic photovoltaic devices. Therefore, in this work, rubrene single crystals with a thickness of 250 nm to 1000 nm were used to produce an inverted bilayer organic solar cell. Subsequently, polycrystalline rubrene (orthorhombic, triclinic) and amorphous bilayer solar cells of the same thickness as single crystals were studied to make comparisons across platforms. To investigate how single crystal, polycrystalline (triclinic-orthorhombic) and amorphous forms alter the charge carrier recombination mechanism at the rubrene/PCBM interface, light intensity measurements were carried out. The light intensity dependency of the JSC, VOC and FF parameters in organic solar cells with different forms of rubrene was determined. Monomolecular (Shockley Read Hall) recombination is observed in devices employing amorphous and polycrystalline rubrene in addition to bimolecular recombination, whereas the single crystal device is weakly affected by trap assisted SRH recombination due to reduced trap states at the donor acceptor interface. To date, the proposed work is the only systematic study examining transport and interface recombination mechanisms in organic solar cells produced by different structure forms of rubrene.

Chemical Composition, Antioxidant, Anticholinesterase and Anti-Tyrosinase Activities of Essential Oils of Two Sideritis Species from Turkey.

Sideritis species have been known as medicinal plants since ancient times, and used as tea in Mediterranean countries such as Turkey, Greece, and Spain. They are also used for the treatment of several ailments such as a cough, common cold, and gastrointestinal disorders. The aim of the present study was to perform the chemical composition, antioxidant, anticholinesterase, and anti-tyrosinase activities of the essential oils of Sideritis albiflora and S. leptoclada. ß-caryophyllene (21.2%) and Germacrene D (17.9%) were identified as the major compounds in S. albiflora and S. leptoclada essential oils, respectively. The essential oil of S. albiflora showed the highest lipid peroxidation inhibitory (IC50: 73.8 ± 0.8 µg/mL), DPPH free radical scavenging (28.3±0.1%), ABTS cation radical scavenging (IC50: 50.6 ± 1.0 µg/mL), reducing power (A0.05: 181.7 ± 0.6 µg/mL), acetylcholinesterase (22.1 ± 0.4%), butyrylcholinesterase (IC50: 157.2 ± 0.9 µg/mL) and tyrosinase (15.2 ± 0.4%) inhibitory activities. Moreover, S. albiflora essential oil had rich total phenolic and flavonoid contents indicating 41.5 ± 0.8 µg PEs/mg and 21.4 ± 1.0 µg QEs/mg respectively. This study suggests that consumption of Sideritis species as tea may protect one against melanogenesis, amnesia, and oxidative stress without any observable side effect.

Enhanced Device Efficiency and Long-Term Stability via Boronic Acid-Based Self-Assembled Monolayer Modification of Indium Tin Oxide in a Planar Perovskite Solar Cell.

Interfacial engineering is essential for the development of highly efficient and stable solar cells through minimizing energetic losses at interfaces. Self-assembled monolayers (SAMs) have been shown as a handle to tune the work function (WF) of indium tin oxide (ITO), improving photovoltaic cell performance and device stability. In this study, we utilize a new class of boronic acid-based fluorine-terminated SAMs to modify ITO surfaces in planar perovskite solar cells. The SAM treatment demonstrates an increase of the WF of ITO, an enhancement of the short-circuit current, and a passivation of trap states at the ITO/[poly(3,4ethylenedioxylenethiophene):poly(styrenesulfonic acid)] interface. Device stability improves upon SAM modification, with efficiency decreasing only 20% after one month. Our work highlights a simple treatment route to achieve hysteresis-free, reproducible, stable, and highly efficient (16%) planar perovskite solar cells.

Correlating Crystal Thickness, Surface Morphology, and Charge Transport in Pristine and Doped Rubrene Single Crystals.

The relationship between charge transport and surface morphology is investigated by utilizing rubrene single crystals of varying thicknesses. In the case of pristine crystals, the surface conductivities decrease exponentially as the crystal thickness increases until ∼4 µm, beyond which the surface conductivity saturates. Investigation of the surface morphology using optical and atomic force microscopy reveals that thicker crystals have a higher number of molecular steps, increasing the overall surface roughness compared with thin crystals. The density of molecular steps as a surface trap is further quantified with the subthreshold slope of rubrene air-gap transistors. This thickness-dependent surface conductivity is rationalized by a shift from in-plane to out-of-plane transport governed by surface roughness. The surface transport is disrupted by roughening of the crystal surface and becomes limited by the slower vertical crystallographic axis on molecular step edges. Separately, we investigate surface-doping of rubrene crystals by using fluoroalkyltrichrolosilane and observe a different mechanism for charge transport which is independent of surface roughness. This work demonstrates that the correlation between crystal thickness, surface morphology, and charge transport must be taken into account when measuring organic single crystals. Considering the fact that these molecular steps are universally observed on organic/inorganic and single/polycrystals, we believe that our findings can be widely applied to improve charge transport understanding.

Direct Printing of Graphene Electrodes for High-Performance Organic Inverters.

Scalable fabrication of high-resolution electrodes and interconnects is necessary to enable advanced, high-performance, printed, and flexible electronics. Here, we demonstrate the direct printing of graphene patterns with feature widths from 300 µm to ∼310 nm by liquid-bridge-mediated nanotransfer molding. This solution-based technique enables residue-free printing of graphene patterns on a variety of substrates with surface energies between ∼43 and 73 mN m-1. Using printed graphene source and drain electrodes, high-performance organic field-effect transistors (OFETs) are fabricated with single-crystal rubrene (p-type) and fluorocarbon-substituted dicyanoperylene-3,4:9,10-bis(dicarboximide) (PDIF-CN2) (n-type) semiconductors. Measured mobilities range from 2.1 to 0.2 cm2 V-1 s-1 for rubrene and from 0.6 to 0.1 cm2 V-1 s-1 for PDIF-CN2. Complementary inverter circuits are fabricated from these single-crystal OFETs with gains as high as ∼50. Finally, these high-resolution graphene patterns are compatible with scalable processing, offering compelling opportunities for inexpensive printed electronics with increased performance and integration density.

Poly[2,5-bis(3-dodecylthiophen-2-yl)thieno[3,2-b]thiophene] Oligomer Single-Crystal Nanowires from Supercritical Solution and Their Anisotropic Exciton Dynamics.

Supercritical fluids, exhibiting a combination of liquid-like solvation power and gas-like diffusivity, are a relatively unexplored medium for processing and crystallization of oligomer and polymeric semiconductors whose optoelectronic properties critically depend on the microstructure. Here we report oligomer crystallization from the polymer organic semiconductor, poly[2,5-bis(3-dodecylthiophen-2-yl)thieno[3,2-b]thiophene] (PBTTT) in supercritical hexane, yielding needle-like single crystals up to several microns in length. We characterize the crystals' photophysical properties by time- and polarization-resolved photoluminescence (TPRPL) spectroscopy. These techniques reveal two-dimensional interchromophore coupling facilitated by the high degree of π-stacking order within the crystal. Furthermore, the crystals obtained from supercritical fluid were found to be similar photophysically as the crystallites found in solution-cast thin films and distinct from solution-grown crystals that exhibited spectroscopic signatures indicative of different packing geometries.

Anisotropic Lithium Ion Conductivity in Single-Ion Diblock Copolymer Electrolyte Thin Films.

Well-defined single-ion diblock copolymers consisting of a Li-ion conductive poly(styrenesulfonyllithium(trifluoromethylsulfonyl)imide) (PSLiTFSI) block associated with a glassy polystyrene (PS) block have been synthesized via reversible addition fragmentation chain transfer polymerization. Conductivity anisotropy ratio up to 1000 has been achieved from PS-b-PSLiTFSI thin films by comparing Li-ion conductivities of out-of-plane (aligned) and in-plane (antialigned) cylinder morphologies at 40 °C. Blending of PS-b-PSLiTFSI thin films with poly(ethylene oxide) homopolymer (hPEO) enables a substantial improvement of Li-ion transport within aligned cylindrical domains, since hPEO, preferentially located in PSLiTFSI domains, is an excellent lithium-solvating material. Results are also compared with unblended and blended PSLiTFSI homopolymer (hPSLiTFSI) homologues, which reveals that ionic conductivity is improved when thin films are nanostructured.

Metal Residues in Semiconducting Polymers: Impact on the Performance of Organic Electronic Devices.

The effect of impurities on the optoelectronic and charge transport properties of semiconducting polymers was investigated through the performance of organic photovoltaics (OPVs) and organic field effect transistors (OFETs), respectively. A model representative semiconducting polymer, i.e., poly(3-hexylthiophene) (P3HT), was synthesized and purified using different methods such as precipitation, metals' complexation, and Soxhlet extraction. After the purification processes, each fraction was analyzed to determine its composition in metals (impurities) by various techniques. OFETs and OPVs fabricated from these purified polymer fractions were found to show different charge carrier properties and photovoltaic behaviors. The purest fraction which was obtained after Soxhlet extraction complemented by metals' complexation with the help of ethylenediamine and 15-crown-5 ether showed the best performance in both OPVs and OFETs.