RESUMO
In this paper, we present how complementary characterization techniques, such as electrical measurements with a vector network analyzer (VNA), optical measurements with a laser Doppler vibrometer (LDV), and numerical simulations with the finite element method, coupled with spectral domain analysis (FEMSDA), allow us to independently access different properties of a SAW device and fully characterize its operation using the coupling-of-modes theory (COM). A set of chemical SAW sensors coated with parylene C layers of different thicknesses (1, 1.5, and 2 µm) and an uncoated sensor were used as test samples. The sensors represent dual-channel electroacoustic delay lines operating in the vicinity of 77 MHz. The IDTs consist of split aluminum electrodes deposited on a AT-cut quartz substrate. The thickness-dependent influence of the parylene C layer was observed on the operating frequency (SAW velocity), static capacitance, attenuation, crosstalk, and reflection coefficient. COM parameters were reported for the four cases considered; measured and simulated data show good agreement. The presented approach is suitable for the design, characterization, and validation of polymer film-coated SAW sensors.
RESUMO
This work investigates properties of the thin film elongation acoustic resonator (TFEAR) operating at megahertz frequencies in air. This resonator is composed of a piezoelectric layer of AlN sandwiched between 2 Al electrodes. TFEAR works in the extensional mode excited via AlN d31 piezoelectric coefficient. A 3D finite element method (3D-FEM) analysis using ANSYS software has been performed to model static modal and harmonic behavior of the TFEAR. To consider insertion losses into the substrate, equivalent electrical models based on a modified Butterworth-Van Dyke (MBVD) circuit have been improved by adding extra dissipative elements. Thus, a whole model for the on-wafer characterization setup is given, allowing for automatic de-embedding of the present TFEAR equivalent circuit. Quality factors Q as high as 2500 in air have been recorded with motional resistance lower than 400 ohms. A first oscillator based on a TFEAR resonator was also designed and tested.