RESUMO
Fabry-Perot cavities are central to many optical measurement systems. In high-precision experiments, such as aLIGO and AdVirgo, coupled cavities are often required, leading to complex optical behavior. We show, for the first time to our knowledge, that discrete linear canonical transforms (LCTs) can be used to compute circulating optical fields for cavities in which the optics have arbitrary apertures, reflectance and transmittance profiles, and shape. We compare the predictions of LCT models with those of alternative methods. To further highlight the utility of the LCT, we present a case study of point absorbers on the aLIGO mirrors and compare it with recently published results.
RESUMO
Precise mode matching is needed to maximize performance in coupled cavity interferometers such as Advanced Laser Interferometer Gravitational-Wave Observatory (LIGO). In this paper, we present a new mode matching sensing scheme, to the best of our knowledge, that uses a single radio-frequency higher-order-mode sideband and single-element photodiodes. It is first-order insensitive to misalignment and can serve as an error signal in a closed loop control system for a set of mode matching actuators. We also discuss how it may be implemented in Advanced LIGO. The proposed mode matching error signal has been successfully demonstrated on a tabletop experiment, where the error signal increased the mode matching of a beam to a cavity to 99.9%.
RESUMO
We describe an efficient Er:YAG laser that is resonantly pumped using continuous-wave (CW) laser diodes at 1470 nm. For CW lasing, it emits 6.1 W at 1645 nm with a slope efficiency of 36%, the highest efficiency reported for an Er:YAG laser that is pumped in this manner. In Q-switched operation, the laser produces diffraction-limited pulses with an average power of 2.5 W at 2 kHz PRF. To our knowledge this is the first Q-switched Er:YAG laser resonantly pumped by CW laser diodes.
Assuntos
Lasers Semicondutores , Lasers de Estado Sólido , Óptica e Fotônica/instrumentação , Óptica e Fotônica/métodos , Raios Infravermelhos , Modelos TeóricosRESUMO
This paper reports automatic compensation of strong thermal lensing in a suspended 80 m optical cavity with sapphire test mass mirrors. Variation of the transmitted beam spot size is used to obtain an error signal to control the heating power applied to the cylindrical surface of an intracavity compensation plate. The negative thermal lens created in the compensation plate compensates the positive thermal lens in the sapphire test mass, which was caused by the absorption of the high intracavity optical power. The results show that feedback control is feasible to compensate the strong thermal lensing expected to occur in advanced laser interferometric gravitational wave detectors. Compensation allows the cavity resonance to be maintained at the fundamental mode, but the long thermal time constant for thermal lensing control in fused silica could cause difficulties with the control of parametric instabilities.
RESUMO
In an experiment to simulate the conditions in high optical power advanced gravitational wave detectors, we show for the first time that the time evolution of strong thermal lenses follows the predicted infinite sum of exponentials (approximated by a double exponential), and that such lenses can be compensated using an intracavity compensation plate heated on its cylindrical surface. We show that high finesse approximately 1400 can be achieved in cavities with internal compensation plates, and that mode matching can be maintained. The experiment achieves a wave front distortion similar to that expected for the input test mass substrate in the Advanced Laser Interferometer Gravitational Wave Observatory, and shows that thermal compensation schemes are viable. It is also shown that the measurements allow a direct measurement of substrate optical absorption in the test mass and the compensation plate.