The Accuracy of Three-Dimensional Soft Tissue Simulation in Orthognathic Surgery-A Systematic Review.

Three-dimensional soft tissue simulation has become a popular tool in the process of virtual orthognathic surgery planning and patient-surgeon communication. To apply 3D soft tissue simulation software in routine clinical practice, both qualitative and quantitative validation of its accuracy are required. The objective of this study was to systematically review the literature on the accuracy of 3D soft tissue simulation in orthognathic surgery. The Web of Science, PubMed, Cochrane, and Embase databases were consulted for the literature search. The systematic review (SR) was conducted according to the PRISMA statement, and 40 articles fulfilled the inclusion and exclusion criteria. The Quadas-2 tool was used for the risk of bias assessment for selected studies. A mean error varying from 0.27 mm to 2.9 mm for 3D soft tissue simulations for the whole face was reported. In the studies evaluating 3D soft tissue simulation accuracy after a Le Fort I osteotomy only, the upper lip and paranasal regions were reported to have the largest error, while after an isolated bilateral sagittal split osteotomy, the largest error was reported for the lower lip and chin regions. In the studies evaluating simulation after bimaxillary osteotomy with or without genioplasty, the highest inaccuracy was reported at the level of the lips, predominantly the lower lip, chin, and, sometimes, the paranasal regions. Due to the variability in the study designs and analysis methods, a direct comparison was not possible. Therefore, based on the results of this SR, guidelines to systematize the workflow for evaluating the accuracy of 3D soft tissue simulations in orthognathic surgery in future studies are proposed.

The usefulness of cutting guides for resection or biopsy of mandibular lesions: A technical note and case report.

The application of three dimensional (3D) printed patient specific cutting guide for biopsy of a mandibular lesion closely positioned to the mandibular canal is presented. To prevent inferior alveolar nerve damage, the cutting site of the bone window was virtually planned and then the cutting guide was 3D printed. This guide enabled intra-operative control and resulted in absence of postoperative hypo- or dysesthesia. This case demonstrates that 3D printed patient specific guides can help reduce the risk of hypoesthesia in mandibular surgery.

A systematic review of treatment and outcomes in patients with mandibular coronoid process hyperplasia.

Treatment of mandibular coronoid process hyperplasia (MCPH) has been described and explored in the literature. This systematic review aims to provide a comprehensive overview of the surgical and non-surgical treatment options for MCPH in pediatric and adult populations. Three databases were searched for treatment of MCPH patients (MEDLINE, Embase, and Web of Science). Two reviewers selected case reports and case series based on titles and abstracts. Finally, 55 studies reporting a total of 127 cases were included for qualitative synthesis and data extraction. The mean age at symptom onset was 15.6 years, while the mean age at diagnosis was 23.5 years. Of the included cases, 83.7% were male, and the condition was bilateral in more than 81% of the cases. Coronoidectomy was performed in 82.7% of the included cases, while coronoidotomy was performed in 3.9% of the cases. In 85.0% of the surgically treated cases, the approach was intraoral. The mean maximal intraoperative mouth opening was 38.1 mm compared with 16.5 mm at diagnosis. The mean maximal postoperative mouth opening was 35.3 mm, and the mean follow-up period was 16.3 months. Maximum mouth opening was achieved intraoperatively, and non-surgical treatment after surgery aims to reduce the risk of relapse. Additional research with a higher level of evidence is necessary to confirm these findings.