Manufacturing process transfer to a 30 kg/h continuous direct compression line with real-time composition monitoring.

Transferring an existing marketed pharmaceutical product from batch to continuous manufacturing (CM) without changes in regulatory registration is a challenging task in the pharmaceutical industry. Continuous manufacturing can provide an increased production rate and better equipment utilisation while retaining key quality attributes of the final product. Continuous manufacturing necessitates the monitoring of critical quality attributes in real time by appropriate process analytical tools such as near infra-red (NIR) probes. The present work reports a successful transfer of an existing drug product from batch to continuous manufacturing process without changing the formulation. A key step was continuous powder blending, whose design and operating parameters including weir type, agitation rate, dynamic hold-up and residence time were systematically investigated with respect to process repeatability. A NIR-based multivariate data model for in-line composition monitoring has been developed and validated against an existing quality control method for measuring tablet content uniformity. A continuous manufacturing long-run with a throughput of 30 kg/h (approx. 128,000 tablets per hour), uninterrupted for 320 min, has been performed to test and validate the multivariate data model as well as the batch to continuous process transfer. The final disintegration and dissolution properties of tablets manufactured by the continuous process were found to be equivalent to those manufactured by the original batch process.

Continuous direct compression of a commercially batch-manufactured tablet formulation with two different processing lines.

The transfer from batch-based to continuous tablet manufacturing increases the quality and efficiency of processes. Nonetheless, as in the development of a batch process, the continuous process design requires optimization studies to ensure a robust process. In this study, processing of a commercially batch-manufactured tablet product was tested with two continuous direct compression lines while keeping the original formulation composition and tablet quality requirements. Tableting runs were conducted with different values of process parameters. Changes in parameter settings were found to cause differences in tablet properties. Most of these quality properties could be controlled and maintained within the set limits effortlessly already at this stage of studies. However, the API content and content uniformity seemed to require more investigation. The observed content uniformity challenges were traced to individual tablets with a high amount of API. This was suspected to be caused by API micro-agglomerates since tablet weight variability did not explain the issue. This could be solved by adding a mill between two blenders in the process line. Overall, this case study produced promising results with both tested manufacturing lines since many tablet properties complied with the test result limits without optimization of process parameter settings.

Virtual Prototyping and Parametric Design of 3D-Printed Tablets Based on the Solution of Inverse Problem.

The problem of designing tablet geometry and its internal structure that results into a specified release profile of the drug during dissolution was considered. A solution method based on parametric programming, inspired by CAD (computer-aided design) approaches currently used in other fields of engineering, was proposed and demonstrated. The solution of the forward problem using a parametric series of structural motifs was first carried out in order to generate a library of drug release profiles associated with each structural motif. The inverse problem was then solved in three steps: first, the combination of basic structural motifs whose superposition provides the closest approximation of the required drug release profile was found by a linear combination of pre-calculated release profiles. In the next step, the final tablet design was constructed and its dissolution curve found computationally. Finally, the proposed design was 3D printed and its dissolution profile was confirmed experimentally. The computational method was based on the numerical solution of drug diffusion in a boundary layer surrounding the tablet, coupled with erosion of the tablet structure encoded by the phase volume function. The tablets were 3D printed by fused deposition modelling (FDM) from filaments produced by hot-melt extrusion. It was found that the drug release profile could be effectively controlled by modifying the tablet porosity. Custom release profiles were obtained by combining multiple porosity regions in the same tablet. The computational method yielded accurate predictions of the drug release rate for both single- and multi-porosity tablets.