RESUMO
A model mixture of six aromatic acids has been separated using a laboratory-made wide-bore electrophoretic device with aminopropyl-modified nanoparticles used as pseudostationary phase. Optimization of preparation of nanoparticles by an electrospray (ES) method is described. With the optimized electrophoretic method, 30 mmol/L acetate running buffer, pH 4.5, containing 1.0 mg/mL of nanoparticles as an additive was used, and 3.0 kV applied potential, improved resolution was achieved. The average theoretical plate number obtained was above 5.0 x 10(4) theoretical plates per meter with the highest value achieved in certain runs exceeding 1.0 x 10(5) theoretical plates per meter, which was better than previously reported results (approximately 6.7 x 10(4) theoretical plates per meter). Furthermore, repeatabilities of 2, 6.5, and 6% were obtained for the migration time, peak areas, and peak height, respectively. Additionally, sample capacity and sensitivity were improved by hundredfold using the novel wide-bore electrophoresis system compared to traditional CE.
Assuntos
Eletroforese Capilar/métodos , Nanopartículas/química , Compostos Orgânicos/análise , Soluções TampãoRESUMO
AIM: To study the protein binding of glimepiride. METHODS: An HPLC-FA method is performed by using Pinkerton GFF II-S5-80 internal-surface reversed-phase silica support (150 mm x 4.6 mm ID, 5 microm) at pH 7.4 in a 67 mmol x L(-1) isotonic sodium phosphate buffer at 37 degree C. Other conditions included flow rate of 0.2 mL x min(-1), UV detection at wavelength 230 nm and injection volume 900 microL. RESULTS: Nonlinear regression parameter estimation was used for the association constant measurement of glimepiride to both primary and secondary sites, which were 5.1 (micromol x L(-1)-1 and 1 for K1 and n1, and 0.017 (micromol x L(-1))-1 and 7 for K2 and n2, respectively. CONCLUSION: The method is shown to be suitable for investigation of protein binding of glimepiride.