RESUMO
The target mono-BF2 complex is weakly emissive in fluid solution because radiationless decay of the excited-singlet state is promoted through an intramolecular Nâ â â H-N hydrogen bond. The lack of mirror symmetry for this compound is attributed to vibronic effects, as reported previously for the bis-BF2 complex (BOPHY). Red-shifted fluorescence is observed from single crystals, the emission quantum yield approaching 30 % with a fluorescence lifetime of 2â ns. The large Stokes shift of 5,700â cm-1 helps minimize self-absorption. Crystallography indicates that the internal fold and twist angles are increased substantially in the crystal, but the hydrogen bond is weakened relative to solution. The crystal structure is compiled from pairs of head-to-tail molecules having a shift of ca. 4.1â Å and closest approach of ca. 3.5â Å. These molecular pairs are arranged in columns, which, in turn, assemble into sheets. The proximity favors excitonic coupling between individual molecules, with the coupling strength obtained by analysis of the absorption spectrum reaching ca. 1,000â cm-1 . Both the ideal dipole approximation and the extended dipole methodology seriously overestimate the coupling strength, but the atomic transition charge density procedure leads to good agreement with experiment. Emission is attributed to the closely coupled molecular pair functioning in an excimer-like manner with the exciton trapped in a local minimum. Increasing temperature causes a slight blue shift and loss of fluorescence.
RESUMO
We report a push-pull BODIPY-based dye functionalised with an electronegative SF5 group at the meso position for applications in photocathodes in tandem dye-sensitized solar cells (DSSCs). The push-pull character enhances charge-transfer from the mesoporous NiO cathode surface towards the redox mediator. A Knoevenagel condensation reaction was used to introduce the carboxylic acid to anchor the dye to the oxide surface, via a styryl linker which increases the conjugation in the molecule and shifts the absorption to the red. The room-temperature synthesis and high yields, make the dye promising for manufacture on a large scale. The dye was applied in p-DSSCs giving a power conversion efficiency (0.066%), a short circuit photocurrent (J SC) of 3.84 mA cm-2, open circuit voltage (V OC) of 58 mV and fill factor of 30%.
RESUMO
The BOPHY structural scaffold provides opportunities for the synthesis of innumerable derivatives with linear geometries and well-controlled π-conjugation pathways. The simpler BOPHY chromophores are highly fluorescent but exhibit poor mirror symmetry between absorption and fluorescence spectra at ambient temperature. In particular, the absorption (and excitation) spectra are broad and appear as two overlapping bands of comparable intensity. In constrained media, such as low-temperature rigid glasses or stretched poly(ethylene) films, mirror symmetry is restored. Analysis of the temperature dependence recorded for simple BOPHY derivatives indicates that the vibronic envelope accompanying the electronic transitions can be well described in terms of low- and medium-frequency modes. Whereas the fluorescence spectral profile is only weakly dependent on temperature, the excitation spectrum is far more affected. The magnitude of the low-frequency mode, and the associated electron-phonon coupling, increase substantially with increasing temperature and is responsible for temperature broadening and distortion of the excitation spectrum in solution. This critical low-frequency vibronic mode is associated with out-of-plane torsional bending of the BOPHY unit. Variable temperature NMR studies failed to provide unequivocal evidence for conformational changes of one of the derivatives over the temperature range 193-353â¯K.
RESUMO
Two Chromophore-Quencher Conjugates (CQCs) have been synthesized by covalent attachment of the anti-oxidant dibutylated-hydroxytoluene (BHT) to a pyrrole-BF2 chromophore (BOPHY) in an effort to protect the latter against photofading. In fluid solution, light-induced intramolecular charge transfer is favoured in polar solvents and helps to inhibit photo-bleaching of the chromophore. The rate of photo-fading, which scales with the number of BHT residues, is zero-order in polar solvents but shows a linear dependence on the number of absorbed photons. The zero-order rate constant shows an inverse correlation with the fluorescence quantum yield measured in the same solvent. Photo-bleaching in benzonitrile involves autocatalysis while reaction in cyclohexane shows an unexpected stoichiometry. NMR spectroscopy indicates initial damage takes place at the BHT unit and allows identification of a reactive hydroperoxide as being the primary product. In the presence of an adventitious substrate, this hydroperoxide is a photocatalyst for amide formation under mild conditions.
RESUMO
Most quantitative fluorescence measurements report emission quantum yields by referring the integrated fluorescence profile to that of a well-known standard compound measured under carefully controlled conditions. This simple protocol works well provided an appropriate standard fluorophore is available and that the experimental conditions used for reference and unknown are closely comparable. Commercial fluorescence spectrophotometers tend to perform very well at wavelengths between 250 and 650 nm but are less responsive at longer wavelengths. There are no recognized emission standards for the far-red region. We now report fluorescence quantum yields for a series of commercially available cyanine dyes in methanol solution at room temperature. The compounds are selected to span the wavelength region from 600 to 850 nm, with absolute emission quantum yields being determined by thermal blooming spectrometry. Calibration of the instrument is made by reference to aluminium(iii) phthalocyanine tetrasulfonate and aza-BODIPY in methanol.
RESUMO
Erythrosine, a popular food dye, undergoes fast O2-sensitive bleaching in water when subjected to visible light illumination. In dilute solution, erythrosine undergoes photobleaching via first-order kinetics, where the rate of bleaching depends critically on the rate of photon absorption and on the concentration of dissolved oxygen. Kinetic studies indicate that this inherent bleaching is augmented by self-catalysis at higher concentrations of erythrosine and on long exposure times. Under the conditions used, bleaching occurs by way of geminate attack of singlet molecular oxygen on the chromophore. Despite the complexity of the overall photobleaching process, the rate constants associated with both inherent and self-catalytic bleaching reactions follow Arrhenius-type behavior, allowing the activation parameters to be resolved. Bleaching remains reasonably efficient in the solid state, especially if the sample is damp, and provides a convenient means by which to construct a simple chemical actinometer.