kHz-order linewidth controllable 1550 nm single-frequency fiber laser for coherent optical communication.

A kHz-order linewidth controllable 1550 nm single-frequency fiber laser (SFFL) is demonstrated for the first time to our best knowledge. The control of the linewidth is realized by using a low-pass filtered white Gaussian noise (WGN) signal applied on a fiber stretcher in an optical feedback loop. Utilizing WGN signals with different signal amplitudes An and different cutoff frequencies fc, the linewidths are availably controlled in a wide range from 0.8 to 353 kHz. The obtained optical signal-to-noise ratio (OSNR) is more than 72.0 dB, and the relative intensity noise (RIN) at frequency greater than 40 MHz reaches -148.5 dB/Hz which approaches the shot noise limit (-152.9 dB/Hz). This kHz-order linewidth controllable SFFL is meaningful and valuable, for optimizing the receiver sensitivity and bit error rate (BER) performance of the coherent optical communication system based on high-order quadrature amplitude modulation (QAM).

Ultra-narrow linewidth full C-band tunable single-frequency linear-polarization fiber laser.

An ultra-narrow linewidth full C-band tunable single-frequency linear-polarization fiber laser based on self-injection locking has been demonstrated. By the use of a tunable narrow-band fiber Fabry-Perot interferometer, the laser wavelength could be flexibly tuned from 1527 to 1563 nm with linewidths of < 700 Hz. The laser frequency noise is less than 40 dB re Hz/Hz1/2 at low frequencies (< 100 Hz) and reaches -5 dB re Hz/Hz1/2 at around 25 kHz. The measured relative intensity noise (RIN) is less than -130 dB/Hz with regard to frequencies of over 3 MHz, while the obtained linear polarization extinction ratio (LPER) is higher than 28 dB. This ultra-narrow linewidth low-noise tunable single-frequency linear-polarization fiber laser provides a promising candidate for high-order quadrature amplitude modulation (QAM) optical communication system.

Advanced modulation formats for 400-Gbps short-reach optical inter-connection.

Besides the long-haul optical networks covering over thousands of kilometers for backbone transmission, short reach optical networks (SR-ONs) are widely deployed in metro-area for aggregation and accessing. The SR-ONs include the metro optical transport networks (Metro-OTN), optical access networks or other optical inter-connection systems with even shorter distance. As predicted, the growing bandwidth demanding from SR-ONs will be much more than that from the long-haul optical networks in the near future. Besides, there are tremendous amounts of optical terminals and end-users in SR-ONs compared with the long-haul transmission systems and thus will induce large cost and huge energy consumption. So, the power and cost efficiency should be the key consideration for SR-ONs besides the transmission performance. To improve the power and cost efficiency in SR-ONs, advanced modulations and detection techniques based on low power, low cost and integrated optical modulators should be utilized. In this paper, different advanced modulation formats have been discussed. 56Gbps PAM4, 112Gbps poly-binary and 100Gbps DMT that can be used to realize 400-Gbps SR-ONs for different applications have also been demonstrated respectively. In addition, low-cost and low-power opto-electronic components suitable for SR-ONs, the impairments induced by all kinds of defects and bandwidth limitation of opto-electronic components and the corresponding compensation techniques based on DSP algorithms have also been discussed in the experiments.

Short and efficient mode-size converter designed by segmented-stepwise method.

We present an efficient segmented-stepwise method to design a short and low-loss mode-size converter. A silicon-on-insulator platform-based converter with 20 µm length and 95.2% conversion efficiency is acquired by taking only 10 optimization generations using 2D-FDTD method. A 3D-FDTD simulation is performed to verify the calculated results, returning an efficiency of 92.1%. The proposed device can be used to connect a 12-µm-wide waveguide and a 0.5-µm-wide single-mode waveguide, with comparable performance of a regular scheme using 150-µm-long linear taper. For demonstration, the converter was fabricated by electron-beam-lithography and inductively-coupled-plasma etching. A conversion loss of -0.62±0.02 dB at 1550 nm was experimentally measured.

Non-data-aided and universal cycle slip detection and correction for coherent communication systems.

We propose a simple non-data-aided (or unsupervised) and universal cycle slip detection and correction (CS-DC) technique based on locating the minimum of the sliding average of twice estimated phase noise. The CS-DC can be appended to any carrier phase estimation(CPE) technique and is modulation format independent. We analytically derive the probability density function of the CS detection metric and study how the sliding window length and detection threshold affects CS detection performance. Simulation results reveal significant cycle slips reduction for various modulation formats with a residual CS probability of 2 × 10-7 for single carrier system even in unrealistic highly nonlinear system setups. In addition, we show that a second stage of CS-DC with a different sliding window length can further reduce the cycle slip probability by at least an order of magnitude. We also show that CS-DC is tolerant to inter-channel nonlinearities and residue frequency offset effects. Overall, the proposed CS-DC technique can be used in conjunction to other CS reduction techniques to maximize the ability of CS mitigation in next generation optical transceivers.

Generation of square or hexagonal 16-QAM signals using a dual-drive IQ modulator driven by binary signals.

We propose a simple square or hexagonal 16-QAM signal generation technique using a commercially available dual-drive IQ modulator driven by four binary electrical signals with properly designed amplitudes. We analytically derive the required driving signal amplitudes for square and hexagonal 16-QAM and characterize its implementation penalty. Polarization-multiplexed (PM)-16-QAM signals at 28 Gbuad are experimentally demonstrated and stable performance is achieved with simple bias control.