Application of dye analysis in forensic fibre and textile examination: Case examples.

Seven cases and a quality assurance test are presented. In these cases, fibres or textiles submitted for investigation were analysed by HPLC-DAD-MS to identify the dyes present. The cases presented illustrate that it is possible to identify textile dyes in fibre traces recovered for forensic analysis. The results show that a mixture of dyes is present in all textiles investigated, except one sample that was taken from a manufacturer dye shade card. It is concluded that dye analyses improves the evidential value of forensic fibre examinations, as it becomes possible to distinguish textiles that are different in dye chemistry, but have a similar colour. In addition dye analysis makes the examination more robust, as it becomes possible to attribute colour differences between samples to identical dyes (mixed in different ratios) or to chemically different dyes.

Development and validation of highly selective screening and confirmatory methods for the qualitative forensic analysis of organic explosive compounds with high performance liquid chromatography coupled with (photodiode array and) LTQ ion trap/Orbitrap mass spectrometric detections (HPLC-(PDA)-LTQOrbitrap).

An LTQ-Orbitrap FTMS is a new (hybrid) mass spectrometric (MS) analyzer. It allows for the acquisition of full scan MS(n) (n-stage fragmentations, n=1-n) spectra with the linear ion trap detector (LTQ) at high speed and/or with the Fourier Transform-detector (Orbitrap) with ultra high mass resolution (>60,000 at m/z<400amu) and high mass accuracy (≤1ppm with internal calibration). In addition it may be coupled with liquid chromatography (LC) with photo diode array (PDA) detection. Two methods for the forensic screening and confirmation of all common trace explosives in post-blast residues have been developed on this instrument using atmospheric pressure chemical ionization (APCI). In one run, the nitrogen-containing explosives are analyzed with the combination of "LC-(PDA)-APCI(-)-LTQ MS(2)/Orbitrap FTMS" (Method 1). In another run, peroxide explosives are analyzed with "LC-APCI(+)-LTQ MS(2)/Orbitrap FTMS" (Method 2). The performance of both methods has been validated according to procedures defined in the EU COMMISSION DECISION implementing Council Directive 96/23/EC concerning the performance of analytical methods and the interpretation of results (DC 2002/657/EC) and other standards (NEN 17025 and NEN 7777). The methods are highly selective due to the simultaneous utilization of the Orbitrap FTMS and LTQ MS(2), both of which are highly selective detectors Tested explosive compounds can be detected in the molecular ion form by the Orbitrap analyzer with minimal mass interference in different matrices when using an extremely narrow mass tolerance detection window (≤2ppm). The identification of a detected compound follows an identification point system. Experimental results show that almost all explosive compounds meet the confirmation criteria (minimum 4 points) required for the positive identification by the DC 2002/657/EC.

LCMS analysis of fingerprints, the amino acid profile of 20 donors.

The analysis of amino acids present in fingerprints has been studied several times. In this paper, we report a method for the analysis of amino acids using an fluorenylmethyloxycarbonyl chloride-derivatization for LC separation and MS detection. We have obtained good results with regard to the calibration curves and the limit of detection and LOQ for the target compounds. The extraction of the amino acids from the substrates used proved to be very efficient. Analysis of the derivatized amino acids enabled us to obtain full amino acid profiles for 20 donors. The intervariability is as expected rather large, with serine as the most abundant constituent, and when examining the total profile of the amino acids per donor, a characteristic pattern can be observed. Some amino acids were not detected in some donors, or fell out of the range of the calibration curve, where others showed a surprisingly high amount of material in the deposition analyses. Further investigations will have to address the intravariability of the amino acid profiles of the fingerprints from donors. By the development of the analytical method and the application to the analysis of fingerprints, we were able to gain insight in the variability of the constituents of fingerprints between the donors.

Identification of dyes on single textile fibers by HPLC-DAD-MS.

An HPLC-DAD-MS method is described to analyze textile dyes in different dye classes (reactive, basic, acid, direct, disperse). The described method is sensitive enough to analyze single fibers with a length of a few millimeters or less, which makes it suitable for forensic analyses. The current paper describes the information content of the acquired data as well as the results of a validation study, in which the repeatability, specificity, and limit of detection of the method were assessed by repeated measurements of nine different dyes in the mentioned dye classes. The mass accuracy (deviation generally <2 ppm) and absorbance spectra were found to be highly stable in several measurements over a period of 8 weeks. Deviation in retention times were observed and attributed to small experimental effects and a precolumn blockage. The results show that dye analysis is possible for most fibers with a minimum length of one or a few millimeters.

Highly sensitive screening method for nitroaromatic, nitramine and nitrate ester explosives by high performance liquid chromatography-atmospheric pressure ionization-mass spectrometry (HPLC-API-MS) in forensic applications.

A highly sensitive screening method based on high performance liquid chromatography atmospheric pressure ionization mass spectrometry (HPLC-API-MS) has been developed for the analysis of 21 nitroaromatic, nitramine and nitrate ester explosives, which include the explosives most commonly encountered in forensic science. Two atmospheric pressure ionization (API) methods, atmospheric pressure chemical ionization (APCI) and electrospray ionization (ESI), and various experimental conditions have been applied to allow for the detection of all 21 explosive compounds. The limit of detection (LOD) in the full-scan mode has been found to be 0.012-1.2 ng on column for the screening of most explosives investigated. For nitrobenzene, an LOD of 10 ng was found with the APCI method in the negative mode. Although the detection of nitrobenzene, 2-, 3-, and 4-nitrotoluene is hindered by the difficult ionization of these compounds, we have found that by forming an adduct with glycine, LOD values in the range of 3-16 ng on column can be achieved. Compared with previous screening methods with thermospray ionization, the API method has distinct advantages, including simplicity and stability of the method applied, an extended screening range and a low detection limit for the explosives studied.

Trace analysis of peroxide explosives by high performance liquid chromatography-atmospheric pressure chemical ionization-tandem mass spectrometry (HPLC-APCI-MS/MS) for forensic applications.

An HPLC-APCI-MS(/MS) method for the (trace) analysis of the most commonly encountered peroxide explosives, hexamethylenetriperoxidediamine (HMTD) and triacetonetriperoxide (TATP), has been developed. With this method, HMTD and TATP have been analyzed in the same run. (Pseudo-)molecular ions of these peroxides have been obtained as base peak under the same condition. A series of product ions was produced from these pseudo-molecular ions ([HMTD - 1]+ and [TATP + NH4]+) in the MS/MS analysis. We also pioneered in showing that a TATP molecular ion [TATP + H]+ can be observed with HPLC-MS/MS. The limit of detection for HMTD and TATP was 0.26 and 3.3 ng, respectively, on column by HPLC-MS in the Full Scan mode and 0.08 and 0.8, respectively, by HPLC-APCI-MS/MS in Selected Reaction Monitoring (single mass unit) mode. The method presented has been applied successfully for the identification of peroxides in the bulk solid state (powder sample), as well as in post-blast extracts originating from a forensic case. For the post-blast extracts, the use of tandem MS has been shown clearly to be of crucial importance for the identification and detection of the peroxide explosives.