RESUMO
To understand the heavy metal pollution status of Dongjiang Lake, the contents and species of heavy metals in the surface sediments were investigated during September 2021, and the heavy metal pollution level and potential ecological risk were evaluated. The results showed that Cd, Pb, As, Cu, Zn, Ni, and Cr contents were in the range of 0.40-34.1, 14.8-1688, 6.99-1155, 6.89-280, 26.2-1739, 6.29-55.4, and 23.3-44.8 mg·kg-1, respectively, with extremely uneven spatial distributions. The highest contents of Cd, Pb, As, Zn, Cu, and Ni were found in the site adjacent to Yaogangxian tungsten ore. The proportion of metal species with bioavailability was high, in which Cd in acid-soluble species was 46.7%-71.5% and Pb in reducible species was 46.8%-67.0%. The bioavailable species of Cu, Zn, Ni, and Cr were 35%-68%, 42%-72%, 26%-51%, and 6%-30%, respectively, although they primarily existed in residual species. According to the geo-accumulation index (Igeo), there was a moderate or extreme pollution status of Cd in all sites, moderate or extreme pollution status of Pb in 90% of sites, and moderate pollution status of As, Cu, and Zn in 30% of sites. The ecological risk factor (Eri) of Cd showed high potential ecological risk in all sites with significantly high potential ecological risk in 80% of sites. Moreover, As and Pb had significantly high potential ecological risk, and Cu had moderate potential ecological risk in S7, which was adjacent to Yaogangxian tungsten ore. There was a high total potential ecological risk in all sites and significantly high potential ecological risk in 50% of sites. Therefore, the surface sediments of Dongjiang Lake were under the combined pollution of Cd, Pb, As, Zn, and Cu with high bioavailability and high total potential ecological risk.
RESUMO
Selenium (Se) is an essential and crucial micronutrient for humans and animals, but excessive Se brings negativity and toxicity. The adsorption and oxidation of Se(IV) on Mn-oxide surfaces are important processes for understanding the geochemical fate of Se and developing engineered remediation strategies. In this study, the characterization of simultaneous adsorption, oxidation, and desorption of Se(IV) on δ-MnO2 mineral was carried out using stirred-flow reactors. About 9.5% to 25.3% of Se(IV) was oxidized to Se(VI) in the stirred-flow system in a continuous and slow process, with the kinetic rate constant k of 0.032 h-1, which was significantly higher than the apparent rate constant of 0.0014 h-1 obtained by the quasi-level kinetic fit of the batch method. The oxidation reaction was driven by proton concentration, and its rate also depended on the Se(IV) influent concentration, flow rate, and δ-MnO2 dosage. During the reaction of Se(IV) and δ-MnO2, Mn(II) was produced and adsorbed strongly on Mn oxide surfaces, which was evidenced by the total reflectance Fourier transform infrared (ATR-FTIR) results. The X-ray photoelectron spectroscopy (XPS) data indicated that the reaction of Se(VI) on δ-MnO2 produced Mn(III) as the main product. These results contribute to a deeper understanding of the interface chemical process of Se(IV) with δ-MnO2 in the environment.