RESUMO
We theoretically study the electromagnetic forces (optical gradient force, optical torque and vacuum friction) acting on a spherical anisotropic nanoparticle, which can be characterized by multilayer hyperbolic metamaterials (mHMMs). We find three important results about these forces: (i) Firstly, we theoretically demonstrate that the optical gradient force produced on a mHMMs nanoparticle can be flexibly tuned, from pushing the particle to pulling it, just via changing incident angle of illuminating plane light wave. (ii) Secondly, we find the optical torque acting on the mHMMs nanoparticle (its filling factor is around 0.3) can be tuned between positive and negative via changing the incident angle of circularly polarized plane light. Therefore, the rotating mHMMs nanoparticle with designed filling factor can be accelerated or decelerated by the optical torque. (iii) Finally, due to the large fluctuations of dipole polarizability of mHMMs nanoparticle with appropriate filling factor, we propose a new method to obtain the large enhancement of vacuum friction torque by designing the filling factor of the rotating mHMMs nanoparticle.
RESUMO
Light trapping, caused by the introduction of metallic nanoparticles, has been demonstrated to enhance photo-absorption in GaAs solar cells. In this study, we successfully synthesized gold nanostar thin film with hot spots and obtained a notable improvement of power conversion efficiency (PCE) in single-junction and three-junction high-performance GaAs solar cells by incorporating the poly (3,4-ethylenedioxythiophene): poly(styrenesulfonate) (PEDOT:PSS) layer, which enables a much stronger light trapping capability and scattering enhancement than conventional metal nanostructures. Increases of 5.2% and 3.94% in short circuit current density (Isc) were achieved for single-junction cells and three-junction cells while the enhancement in cell PCE was 3.85 and 2.50%, respectively. The relationship between the optical characteristics, the distribution density of the gold NSs and the performance of GaAs solar cells was systemically investigated.
RESUMO
The difluoromethyl group (CF2H) is of great interest in the area of medicinal chemistry. However, the investigation of molecular scaffolds containing this group has been hampered by the limitation of synthetic methods for the introduction of CF2H into heteroarenes. Herein we disclose a new strategy for the direct introduction of a difluoromethyl group into heteroarenes via the copper-mediated C-H oxidative difluoromethylation of heteroarenes with TMSCF2H. This mild and regioselective method enables the convenient synthesis of a range of difluoromethylated heteroarenes in high yields. The usage of 9,10-phenanthrenequinone (PQ) as an oxidant is critical to the success of this new difluoromethylation reaction.
RESUMO
A silver-mediated oxidative difluoromethylation of phenanthridines and 1,10-phenanthrolines with TMSCF2H is disclosed. This C-H difluoromethylation of N-containing polycyclic aromatics constitutes an efficient method for the regioselective synthesis of difluoromethylated N-heterocycles.
RESUMO
The nanocomposite polyvinyl pyrrolidone (PVP) films containing Ag nanoparticles and Rhodamine 6G are prepared on the two-dimensional distinctive continuous ultrathin gold nanofilms. We investigate the optical properties and the fluorescence properties of silver nanoparticles-PVP polymer composite films influenced by Ag nanoparticles and Au nanoparticles. Absorption spectral analysis suggests that the prominently light absorption in Ag nanowire/PVP and Ag nanowire/PVP/Au film arises from the localized surface plasmon resonance of Ag nanowire and Au nanofilm. The enhanced fluorescence is observed in the presence of Ag nanowire and Au nanofilm, which is attributed to the excitation of surface plasmon polariton resonance of Ag nanowire and Au nanofilm. The gold nanofilm is proven to be very effective fluorescence resonance energy transfer donors. The fabricated novel structure, gold ultrathin continuous nanofilm, possesses high surface plasmon resonance properties and prominent fluorescence enhancement effect. Therefore, the ultrathin continuous gold nanofilm is an active substrate on nanoparticle-enhanced fluorescence.
RESUMO
Surface-enhanced Raman scattering is an effective analytical method that has been intensively applied in the field of identification of organic molecules from Raman spectra at very low concentrations. The Raman signal enhancement that makes this method attractive is usually ascribed to the noble metal nanoparticle (NMNP) arrays which can extremely amplify the electromagnetic field near NMNP surface when localized surface plasmon resonance (LSPR) mode is excited. In this work, we report a simple, facile, and room-temperature method to fabricate large-scale, uniform gold nanoparticle (GNP) arrays on ITO/glass as SERS substrates using a promoted self-assembly deposition technique. The results show that the deposition density of GNPs on ITO/glass surface increases with prolonging deposition time, and nanochain-like aggregates appear for a relatively longer deposition time. It is also shown that these films with relatively higher deposition density have tremendous potential for wideband absorption in the visible range and exhibit two LSPR peaks in the extinction spectra because the electrons simultaneously oscillate along the nanochain at the transverse and the longitudinal directions. The SERS enhancement activity of these GNP arrays was determined using 10-6 M Rhodamine 6G as the Raman probe molecules. A SERS enhancement factor as large as approximately 6.76 × 106 can be obtained at 1,363 cm-1 Raman shift for the highest deposition density film due to the strong plasmon coupling effect between neighboring particles.
RESUMO
BACKGROUND: Noble metallic nanoparticles have prominent optical local-field enhancement and light trapping properties in the visible light region resulting from surface plasmon resonances. RESULTS: We investigate the optical spectral properties and the surface-enhanced Raman spectroscopy of two-dimensional distinctive continuous ultrathin gold nanofilms. Experimental results show that the one- or two-layer nanofilm obviously increases absorbance in PEDOT:PSS and P3HT:PCBM layers and the gold nanofilm acquires high Raman-enhancing capability. CONCLUSIONS: The fabricated novel structure of the continuous ultrathin gold nanofilms possesses high surface plasmon resonance properties and boasts a high surface-enhanced Raman scattering (SERS) enhancement factor, which can be a robust and cost-efficient SERS substrate. Interestingly, owing to the distinctive morphology and high light transmittance, the peculiar nanofilm can be used in multilayer photovoltaic devices to trap light without affecting the physical thickness of solar photovoltaic absorber layers and yielding new options for solar cell design.
RESUMO
We report an electrophoretic deposition method for the fabrication of gold nanoparticle (GNP) thin films as sensitive surface-enhanced Raman scattering (SERS) substrates. In this method, GNP sol, synthesized by a seed-mediated growth approach, and indium tin oxide (ITO) glass substrates were utilized as an electrophoretic solution and electrodes, respectively. From the scanning electron microscopy analysis, we found that the density of GNPs deposited on ITO glass substrates increases with prolonged electrophoresis time. The films possess high mechanical adhesion strength and exhibit strong localized surface plasmon resonance (LSPR) effect by showing high SERS sensitivity to detect 1 × 10-7 M rhodamine 6 G in methanol solution. Finally, the relationship between Raman signal amplification capability and GNP deposition density has been further investigated. The results of our experiment indicate that the high-density GNP film shows relatively higher signal amplification capability due to the strong LSPR effect in narrow gap regions between the neighboring particles on the film.
RESUMO
Wide wavelength ranges of light localization and scattering characteristics can be attributed to shape-dependent longitude surface plasmon resonance in complicated nanostructures. We have studied this phenomenon by spectroscopic measurement and a three-dimensional numerical simulation, for the first time, on the high-density branched silver nanowires and nanomeshworks at room temperature. These nanostructures were fabricated with simple light-induced colloidal method. In the range from the visible to the near-infrared wavelengths, light has been found effectively trapped in those trapping sites which were randomly distributed at the corners, the branches, and the junctions of the nanostructures in those nanostructures in three dimensions. The broadened bandwidth electromagnetic field enhancement property makes these branched nanostructures useful in optical processing and photovoltaic applications.
RESUMO
We propose a polymer growth model, in which propagating radicals can grow through propagation processes or annihilate through termination (disproportionation or combination) processes. Considering a simple case in which the propagation and termination rates of each polymer chain are both independent of its length, we then investigate analytically the kinetics of the model by means of the rate-equation approach. The propagating radicals will be exhausted eventually and only the inert polymers (the termination products of propagating radicals) can survive in the end. Moreover, the size distribution of propagating radicals can always take the form of the Poisson distribution at a given time, while that of inert polymers is dependent strongly on the details of the reaction-rate kernels. For the case in which the propagation rate constant J1 is less than the termination rate constant J2 , the size distribution of inert polymers can always take a power-law form ck(t) approximately k-2-J/1/(J2-J1), in the region of t>>1 and k>>1 . For the J1>J2 case, the kinetic evolution of inert polymers is very complex and ck(t) can take one of the three forms: monotone decreasing, single peak (Poisson-like distribution), and double peak. For the special J1=J2 case, ck(t) exhibits an exponential decay in size.