Comparison of mono-rhamnolipids and di-rhamnolipids on microbial enhanced oil recovery (MEOR) applications.

Rhamnolipids (RMLs) have more effectiveness for specific uses according to their homologue proportions. Thus, the novelty of this work was to compare mono-RMLs and di-RMLs physicochemical properties on microbial enhanced oil recovery (MEOR) applications. For this, RML produced by three strains of Pseudomonas aeruginosa containing different homologues proportion were used: a mainly mono-RMLs producer (mono-RMLs); a mainly di-RMLs producer (di-RMLs), and the other one that produces relatively balanced amounts of mono-RML and di-RML homologues (mono/di-RML). For mono-RML, the most abundant molecules were Rha-C10 C10 (m/z 503.3), for di-RML were RhaRha-C10 C10 (m/z 649.4) and for Mono/di-RML were Rha-C10 C10 (m/z 503.3) and RhaRha-C10 C10 (m/z 649.4). All RMLs types presented robustness under high temperature and variation of salinity and pH, and high ability for oil displacement, foam stability, wettability reversal and were classified as safe for environment according to the European Union Directive No. 67/548/EEC. For all these properties, it was observed a highlight for mono-RML. Mono-RML presented the lowest surface tension (26.40 mN/m), interfacial tension (1.14 mN/m), and critical micellar concentration (CMC 27.04 mg/L), the highest emulsification index (EI24 100%) and the best wettability reversal (100% with 25 ppm). In addition, mono-RML showed the best acute toxicity value (454 mg/L), making its application potential even more attractive. Based on the results, it was concluded that all RMLs homologues studied have potential for MEOR applications. However, results showed that mono-RML stood out and have the best mechanism of oil incorporation in micelles due their most effective surface-active physicochemical features.

Response of marine bacteria to oil contamination and to high pressure and low temperature deep sea conditions.

The effect of pressure and temperature on microbial communities of marine environments contaminated with petroleum hydrocarbons is understudied. This study aims to reveal the responses of marine bacterial communities to low temperature, high pressure, and contamination with petroleum hydrocarbons using seawater samples collected near an offshore Brazilian platform. Microcosms containing only seawater and those containing seawater contaminated with 1% crude oil were subjected to three different treatments of temperature and pressure as follows: (1) 22°C/0.1 MPa; (2) 4°C/0.1 MPa; and (3) 4°C/22 MPa. The effect of depressurization followed by repressurization on bacterial communities was also evaluated (4°C/22 MPaD). The structure and composition of the bacterial communities in the different microcosms were analyzed by PCR-DGGE and DNA sequencing, respectively. Contamination with oil influenced the structure of the bacterial communities in microcosms incubated either at 4°C or 22°C and at low pressure. Incubation at low temperature and high pressure greatly influenced the structure of bacterial communities even in the absence of oil contamination. The 4°C/22 MPa and 4°C/22 MPaD treatments resulted in similar DGGE profiles. DNA sequencing (after 40 days of incubation) revealed that the diversity and relative abundance of bacterial genera were related to the presence or absence of oil contamination in the nonpressurized treatments. In contrast, the variation in the relative abundances of bacterial genera in the 4°C/22 MPa-microcosms either contaminated or not with crude oil was less evident. The highest relative abundance of the phylum Bacteroidetes was observed in the 4°C/22 MPa treatment.