A conservative full-mouth ceramic rehabilitation for a severely worn dentition.

There is a constantly growing prevalence of tooth wear in dentistry. The present case report describes a rehabilitation through ceramic restorations of a severely worn dentition based on a conservative intervention, adequate restorative material selection, and adhesive bonding strategies. A 36-year-old patient with a mainly esthetic complaint presented with signs of tooth wear caused by erosion and attrition. Preparations were performed guided by the diagnostic planning. The full-mouth rehabilitation, combined with the correction of the vertical dimension of occlusion, was split into quadrants, and lithium disilicate partial restorations were fabricated. The proposed rehabilitation was based on the maximal preservation of the remaining tooth structure and the adequate selection of restorative materials and adhesive bonding strategies.

Fractal analysis is a useful tool for evaluating prostate tissue remodeling caused by ethanol consumption and androgen therapy.

Alcohol has been widely consumed for centuries and is linked to the aggravation of diseases. Several studies have shown that excessive consumption of ethanol results in morphophysiological changes in the male reproductive system. One of the effects of ethanol is the decrease in testosterone concentration and hormonal therapies are an alternative to minimize the changes resulting from chronic alcoholism. Qualitative studies were commonly carried out to evaluate the male histopathological alterations resulting from ethanol consumption, being necessary quantitative and non-subjective techniques. This study analyzes the importance of fractal analysis as a useful tool to identify and quantify tissue remodeling in rats submitted to ethanol consumption and hormone therapy with testosterone. Prostate of animals submitted to chronic ethanol consumption showed tissue disorganization, which was confirmed by an increasing of fractal dimension. Regarding the prostatic stroma, collagen fractal dimension and quantification revealed lower values in animals that were only submitted to androgen therapy. Thus, we can conclude that the fractal analysis was a useful tool to quantify tissue changes caused by ethanol consumption and androgen therapy.

The Influence of Post System Design and Material on the Biomechanical Behavior of Teeth with Little Remaining Coronal Structure.

PURPOSE: To evaluate the influence of different post systems on the biomechanical behavior of teeth with a severe loss of remaining coronal structure. MATERIALS AND METHODS: Fifty standardized bovine teeth (n = 10 per group) were restored with: cast post-and-core (CPC), prefabricated metallic post (PFM), parallel glass-fiber post (P-FP), conical glass-fiber post (C-FP), or composite core (no post, CC). The survival rate during thermomechanical challenging (TC), the fracture strength (FS), and failure patterns (FP) were evaluated. Finite element models evaluated the stress distribution after the application of 100 N. RESULTS: All specimens survived TC. Similar FS was observed among post-containing groups. Groups P-FP and CC presented 100% repairable fractures. The von Mises analysis showed the maximum stresses into the root canal in groups restored with metallic posts. Glass-fiber posts and CC presented the maximum stresses at the load contact point. Glass-fiber groups showed lower stresses in the analysis of maximal contact pressure; CPC led to the highest values of contact pressure. The modified von Mises (mvM) stress in dentin did not show differences among groups. Moreover, mvM values did not reach the dentin fracture limit for any group. CONCLUSIONS: The type of intracanal post had a relevant influence on the biomechanical behavior of teeth with little remaining coronal structure.

Resin cements formulated with thio-urethanes can strengthen porcelain and increase bond strength to ceramics.

OBJECTIVES: The use of thio-urethane oligomers has been shown to significantly improve the mechanical properties of resin cements (RCs). The aim of this study was to use thio-urethane-modified RC to potentially reinforce the porcelain-RC structure and to improve the bond strength to zirconia and lithium disilicate. METHODS: Six oligomers were synthesized by combining thiols - pentaerythritol tetra-3-mercaptopropionate (PETMP, P) or trimethylol-tris-3-mercaptopropionate (TMP, T) - with di-functional isocyanates - 1,6-Hexanediol-diissocyante (HDDI) (aliphatic, AL) or 1,3-bis(1-isocyanato-1-methylethyl)benzene (BDI) (aromatic, AR) or Dicyclohexylmethane 4,4'-Diisocyanate (HMDI) (cyclic, CC). Thio-urethanes (20 wt%) were added to a BisGMA/UDMA/TEGDMA organic matrix. Filler was introduced at 60 wt%. The microshear bond strength (µSBS), Weibull modulus (m), and failure pattern of RCs bonded to zirconia (ZR) and lithium disilicate (LD) ceramics was evaluated. Biaxial flexural test and fractographic analysis of porcelain discs bonded to RCs were also performed. The biaxial flexural strength (σbf) and m were calculated in the tensile surfaces of porcelain and RC structures (Z = 0 and Z = -t2, respectively). RESULTS: The µSBS was improved with RCs formulated with oligomers P_AL or T_AL bonded to LD and P_AL, P_AR or T_CC bonded to zirconia in comparison to controls. Mixed failures predominated in all groups. σbf had superior values at Z = 0 with RCs formulated with oligomers P_AL, P_AR, T_AL, or T_CC in comparison to control; σbf increased with all RCs composed by thio-urethanes at Z = -t2. Fractographic analysis revealed all fracture origins at Z = 0. CONCLUSION: The use of specific thio-urethane oligomers as components of RCs increased both the biaxial flexural strength of the porcelain-RC structure and the µSBS to LD and ZR. CLINICAL SIGNIFICANCE: The current investigation suggests that it is possible to reinforce the porcelain-RC pair and obtain higher bond strength to LD and ZR with RCs formulated with selected types of thio-urethane oligomers.