RESUMO
Fast emitting polymeric scintillators are requested in advanced applications where high speed detectors with a large signal-to-noise ratio are needed. However, their low density implies a weak stopping power of high energy radiation and thus a limited light output and sensitivity. To enhance their performance, polymeric scintillators can be loaded with dense nanoparticles (NPs). We investigate the properties of a series of polymeric scintillators by means of photoluminescence and scintillation spectroscopy, comparing standard scintillators with a composite system loaded with dense hafnium dioxide (HfO2) NPs. The nanocomposite shows a scintillation yield enhancement of +100% with an unchanged time response. We provide for the first time an interpretation of this effect, pointing out the local effect of NPs in the generation of emissive states upon interaction with ionizing radiation. The obtained results indicate that coupling fast conjugated emitters with optically inert dense NPs could lead to surpassing the actual limits of pure polymeric scintillators.
RESUMO
The presented work is dedicated to the study and comparison of scintillating properties of zinc oxide samples prepared in different morphologies: whiskers, nanowalls, multipods, and ceramics. It was shown that total transmittance, photo- and radioluminescence spectra, and radioluminescence kinetics can vary significantly depending on sample structure and preparation conditions. The highest total transmittance was registered for ZnO ceramics (>50% at 0.5 mm thickness). Differences in the transmittance of whiskers, nanowalls, and multipods can be attributed to their shape and thickness which affects the amount of light refraction and scattering. The study of radioluminescence demonstrated that all samples, except undoped ceramics and air annealed whiskers, have predominantly fast luminescence with a decay time <1 ns. High transmittance of ceramics opens the way for their use in the registration of high energy X-ray and gamma radiation, where a large volume of scintillators is required. In cases, where large scintillator thickness is not a necessity, one may prefer to use other ZnO structures, such as ensembles of whiskers and nanowalls. Studies of near-band-edge luminescence components at low temperatures showed that the structure is quite similar in all samples except Ga doped ceramics.