Regional variations in C1-C2 bone density on quantitated computed tomography and clinical implications.

Background: Our elderly population is growing and the number of spine fractures in the elderly is also growing. The elderly population in general may be considered as poor surgical candidates experience a high rate of fractures at C1 and C2 compared with the general population. Nonoperative management of upper cervical fractures is not benign as there is a high nonunion rate for both C1 and C2 fractures in the elderly, and orthosis compliance is often suboptimal, or complicated by skin breakdown. The optimal technique for upper cervical stabilization in the elderly may be different than in younger populations as the bone quality is inferior in the elderly. The objective of this basic science study is to determine whether the bone mineral density (BMD) of C1 and C2 vary by region, and if this is a gender difference in this elderly age group. Methods: Twenty cadaveric spines from 45 to 83 years of age were used to obtain BMD using quantitated computed tomography (QCT). BMD was measured using a QCT. For C1, 8 regions were determined: anterior tubercle, bilateral anterior and medial lateral masses, bilateral posterior arches, and posterior tubercle. For C2, 7 regional BMDs were determined: top of odontoid, base of odontoid-body interface, mid body, bilateral lateral masses, anterior inferior body near the discs space, and the C2 spinous process. Results: The BMD was greatest at the C1 anterior tubercle (564.4±175.8 mg/cm3) and C1 posterior ring (420.8±110.2 mg/cm3), and least at the anterior and medial lateral masses (262.8±59.5 mg/cm3, 316.9±72.6 mg/cm3). At C2 QCT BMD was greatest at the top of the dens (400.6±107.9 mg/cm3) decreasing down through the odontoid-C2 body junction (267.8±103.5 mg/cm3) and least in the mid C2 body 249.1±68.8 mg/cm3). The posterior arch of C1 and the spinous process of C2 had higher BMD's 420.8±110.2 mg/cm3 and 284.1±93.0 mg/cm3, respectively. A high correlation was observed between the BMD at the interface of the dens-vertebral body with the vertebral body with a Pearson correlation coefficient of 0.86. The BMD of the top of dens was significantly higher (p<.05) than all the regions in C2. Conclusions: Regional and segmental BMD variations at C1 and C2 have clinical implications for surgical constructs in the elderly population. Given the higher BMDs of the C1 and C2 spinous process and posterior arches, consideration should be given to incorporate these areas using various C1-C2 wiring techniques. In the elderly, lateral masses particularly at C1 with lower BMD may result in potential screw loosening and nonunion in this age group. Old-school wiring techniques have a track record of efficacy and safety with less blood loss, reduced operative time, reduced X-ray exposure, and should be considered in the elderly as a primary stabilization technique or a belt-over suspenders approach based on regional variations in BMD in the elderly.

Segmental Variations in the Peel Characteristics of the Porcine Thoracic Aorta.

Aortic dissection occurs predominantly in the thoracic aorta and the mechanisms for the initiation and propagation of the tear in aortic dissection are not well understood. We study the tearing characteristics of the porcine thoracic aorta using a peeling test and we estimate the peeling energy per unit area in the ascending and the descending segments. The stretch and the peel force per unit width undergone by the peeled halves of a rectangular specimen are measured. We find that there can be significant variation in the stretch within the specimen and the stretch between the markers in the specimen varies with the dynamics of peeling. We found that in our experiment the stretch achieved in the peeled halves was such that it was in the range of the stretch at which the stress-stretch curve for the uniaxial experiment starts deviating from linearity. Higher peeling energy per unit area is required in the ascending aorta compared to the descending aorta. Longitudinal specimens required higher peeling energy per unit area when compared to the circumferential specimens.

Asymmetric Dynamics of the Native Aortic Annulus Evaluated by Force Transducer and Sonomicrometry in a Porcine Model.

PURPOSE: With new repair techniques of the aortic root and valve emerging, a detailed understanding of the dynamics of the aortic annulus and valve is required for optimal results. The objective of this study was to characterize geometrical changes and force distribution of the native porcine aortic annulus throughout the cardiac cycle. METHODS: Measurements were performed in an acute 80 kg porcine model (n = 7) using sonomicrometry crystals in the aortic annulus for evaluation of geometry and dynamics, annular force transducer evaluating force distribution, and pressure measurements and echocardiography evaluating valve performance. RESULTS: Overall, segmental force distribution and geometrical changes differed between different segments of the aortic annulus. The highest force development was found at the left/right interleaflet triangle (2.87 ± 2.1 N) and the largest segmental expansion was observed at the right-coronary and left-coronary sinus. The aortic annulus changed configuration throughout the cardiac cycle and became more oval in systole. CONCLUSIONS: This study is the first to describe detailed segmental dynamics and force distribution of the native aortic annulus in a porcine model in vivo. The heterogenous behavior of the aortic annulus suggests that different segments demand different support for repair of the aortic root and valve.