Ultra-trace Cu isotope ratio measurements via multi-collector ICP-mass spectrometry using Ga as internal standard: an approach applicable to micro-samples.

The capabilities of Cu isotope ratio measurements are often restricted by the small volumes of sample available and/or their low Cu concentration. In this work, an analytical approach was developed for performing Cu isotopic analysis via multi-collector ICP-mass spectrometry (MC-ICP-MS) at ultra-trace level using Ga as an internal standard for mass bias correction. The minimum concentration of Cu required for accurate and precise isotope ratio measurements was established to be 20 µg L-1 with wet plasma conditions and 5 µg L-1 with dry plasma conditions. The use of Ga as an internal standard for mass bias correction provided several advantages compared to Ni, i.e. improved internal precision on δ65Cu values and lower blank levels. Ga can also be used at a 4-fold lower concentration level than Ni. However, in wet plasma conditions, the signals of 36Ar16O21H+ and 40Ar15N16O+ interfered with the signals of 69Ga+ and 71Ga+, respectively, while in dry plasma conditions, realized by the use of a desolvation unit, 69Ga+ suffered from spectral interference from 40Ar14N21H+. These interferences were resolved by using medium mass resolution. For validation purposes, the approach was applied to commercially available blood and serum samples. The δ65Cu values for the samples measured at a concentration level of 5 µg L-1 Cu and 5 µg L-1 Ga using dry plasma conditions were in good agreement with those obtained for isotope ratio measurements at the "standard" concentration level of 200 µg L-1 Cu and 200 µg L-1 Ni using wet plasma conditions. In addition, the δ65Cu values obtained for micro-samples of serum/blood (volume of 100 µL) were in good agreement with the corresponding ones obtained using the "standard" volume for isotopic analysis (500 µL).