Your browser doesn't support javascript.
loading
Wetting Dynamics of a Lipid Monolayer.
Guo, Shuo; Wang, Yong Jian; Chen, Hsuan-Yi; Tong, Penger.
Afiliação
  • Guo S; School of Physical Science and Technology, ShanghaiTech University, Shanghai 201210, China.
  • Wang YJ; Department of Physics, Hong Kong University of Science and Technology, Clear Water Bay, Kowloon, Hong Kong, China.
  • Chen HY; Department of Physics and Center for Complex Systems, National Central University, Chungli District, Taoyuan City 32001, Taiwan.
  • Tong P; Institute of Physics, Academia Sinica, Taipei 11529, Taiwan.
Langmuir ; 37(16): 4879-4890, 2021 04 27.
Article em En | MEDLINE | ID: mdl-33848422
ABSTRACT
Direct measurement and control of the dynamic wetting properties of a lipid-coated water-air interface over a wide range of surface tension variations have many important applications. However, the wetting dynamics of the interface near its partial-to-complete wetting transition has not been fully understood. Here, we report a systematic study of the wetting dynamics of a lipid-coated water-air interface around a thin glass fiber of diameter 1-5 µm and length 100-300 µm. The glass fiber is glued onto the front end of a rectangular cantilever to form a "long-needle" atomic-force-microscope probe. Three surface modifications are applied to the glass fiber to change its wetting properties from hydrophilic to hydrophobic. A monolayer of phospholipid dipalmitoylphosphatidylcholine (DPPC) is deposited on the water-air interface in a homemade Langmuir-Blodgett trough, and the surface tension γL of the DPPC-coated water-air interface is varied in the range of 2.5 ≲ γL ≲ 72 mN/m. From the measured hysteresis loop of the capillary force for the three coated fiber surfaces with varying γL, we observe a sharp transition from partial to complete wetting when γL is reduced to a critical value (γL)c. The obtained values of (γL)c are 27 ± 1 mN/m for a DPPC-coated fiber surface and 23 ± 1 mN/m for an trichloro(1H,1H,2H,2H-perfluorooctyl) silane (FTS)-coated surface. Below (γL)c, the contact angle θ0 of the liquid interface is found to be zero for both hydrophobic fiber surfaces and the corresponding spreading parameter S becomes positive. For the FTS-coated fiber surface, the height of capillary rise exhibits a jump when γL is reduced to (γL)c, which indicates that a rapidly advancing liquid film is formed on the fiber surface when the partial-to-complete wetting transition takes place. Our experiment thus establishes a quantitative method by which many other liquid interfaces coated with polymers, surfactants, and biomolecules (such as proteins and lipids) may be characterized dynamically.

Texto completo: 1 Base de dados: MEDLINE Idioma: En Ano de publicação: 2021 Tipo de documento: Article

Texto completo: 1 Base de dados: MEDLINE Idioma: En Ano de publicação: 2021 Tipo de documento: Article