ABSTRACT
Ever since the inception of synthetic polymeric materials in the late 19th century, the number of studies on polymers as well as the complexity of their structures have only increased. The development and commercialization of new polymers with properties fine-tuned for specific technological, environmental, consumer, or biomedical applications requires powerful analytical techniques that permit the in-depth characterization of these materials. One such method with the ability to provide chemical composition and structure information with high sensitivity, selectivity, specificity, and speed is mass spectrometry (MS). This tutorial review presents and exemplifies the various MS techniques available for the elucidation of specific structural features in a synthetic polymer, including compositional complexity, primary structure, architecture, topology, and surface properties. Key to every MS analysis is sample conversion to gas-phase ions. This review describes the fundamentals of the most suitable ionization methods for synthetic materials and provides relevant sample preparation protocols. Most importantly, structural characterizations via one-step as well as hyphenated or multidimensional approaches are introduced and demonstrated with specific applications, including surface sensitive and imaging techniques. The aim of this tutorial review is to illustrate the capabilities of MS for the characterization of large, complex polymers and emphasize its potential as a powerful compositional and structural elucidation tool in polymer chemistry.
ABSTRACT
Per- and polyfluoroalkyl substances are an emerging class of contaminants that are environmentally persistent, bioaccumulative, and noxious to human health. Among these, perfluorooctanoic acid (PFOA) molecules are widely found in ground and surface water sources. A novel high surface area, meso- and macroporous syndiotactic polystyrene (sPS) wet gel is used in this work as the adsorbent of PFOA molecules from water at environmentally relevant PFOA concentrations (≤1 µg/L) and cleanse water to below the U.S. EPA's 2023 health advisory limit of 4 parts per trillion (ppt). The sigmoidal shape of the PFOA adsorption isotherm indicates a two-step adsorption mechanism attributed to the strong affinity of PFOA molecules for the sPS surface and molecular aggregation at solid-liquid interfaces or within the pores of the sPS wet gel. The adsorption kinetics and the effects of sPS wet gel porosity, pore size, and pore volume on the removal efficiency are reported. The adsorption kinetics is seen to be strongly dependent on pore size and pore volume.
ABSTRACT
Nucleophilic and non-nucleophilic bases have been employed in anionic oligomerization of unsaturated δ-valerolactone (3-ethylidene-6-vinyltetrahydro-2H-pyran-2-one) (1). Compared to the seminal findings with 1,5,7-triazabicyclo[4.4.0]dec-5-ene (TBD), the unsaturated lactone reacts with guanidines, disilazanes, and phosphazenes both in bulk and in solution with higher productivities and activities, reaching full conversion with turnover frequencies up to 382 h-1. Additionally, reactions using phosphazenes and NaHMDS were active at 1 mol % catalyst loadings both in solvent and in bulk monomer at room temperature. Characterization of the reaction products by 1H, 13C, FTIR, MALDI-MS, tandem mass spectrometry (MS/MS), and ion mobility mass spectrometry (IM-MS) revealed microstructural differences dependent on the nucleophilicity of the organocatalytic base and reaction conditions. The products from phosphazene-catalyzed reactions are consistent with selective vinylogous 1,4-conjugate addition, whereas both conjugate addition and ring-opening mechanisms are observed in TBD. DSC reveals that these microstructures can be tuned to have a Tg range between -18 and 80 °C, while SEC and MALDI-MS reveal that only low molar mass oligomers are formed (748-5949 g/mol). From these results, an approach for selectively favoring the vinylogous 1,4-conjugate addition pathway is obtained over ring-opening reactivity.