ABSTRACT
PURPOSE: To describe a strategy for coronal alignment using a computed tomography (CT) based custom total knee arthroplasty (TKA) system, and to evaluate the agreement between the planned and postoperative Hip-Knee-Ankle (HKA) angle, Femoral Mechanical Angle (FMA) and Tibial Mechanical Angle (TMA). METHODS: From a consecutive series of 918 primary TKAs, 266 (29%) knees received CT-based posterior-stabilized cemented custom TKA. In addition to a preoperative CT-scan, pre- and post-operative radiographs of weight-bearing long leg, anterior-posterior and lateral views of the knee were obtained, on which the FMA, TMA and HKA angles were measured. CT-based three-dimensional (3D) models enabled to correct for cases with bony wear by referring to the non-worn areas and to estimate the native pre-arthritic angles. The alignment technique aimed to preserve or restore constitutional alignment (CA) within predetermined limits, by defining a 'target zone' based on three criteria: 1) a ± 3° (range 87°-93°) primary tolerance for the femoral and tibial resections; 2) a ± 2° secondary tolerance for component obliquity, extending the bounds for FMA and TMA (range 85°-95°); 3) a planned HKA angle range of 175°-183°. Agreement between preoperative, planned and postoperative measurements of FMA, TMA and HKA angle were calculated using intra-class correlation coefficients (ICC). RESULTS: Preoperative radiograph and CT-scan measurements revealed that, respectively, 73 (28%) and 103 (40%) knees were in the 'target zone', whereas postoperative radiographs revealed that 217 (84%) TKAs were in the 'target zone'. Deviation from the planned angles were - 0.5° ± 1.8° for FMA, - 0.5° ± 1.8° for TMA, and - 1.1° ± 2.1° for HKA angle. Finally, the agreement between the planned and achieved targets, indicated by ICC, were good for FMA (0.701), fair for TMA (0.462) and fair for HKA angle (0.472). CONCLUSION: Using this strategy for coronal alignment, 84% of custom TKAs were within the 'target zone' for FMA, TMA and HKA angles. These findings support the concepts of emerging personalized medicine technologies, and emphasise the importance of accurate strategies for preoperative planning, which are key to achieving satisfactory 'personalised alignment' that can further be improved by customisation of implant components. LEVEL OF EVIDENCE: IV.
Subject(s)
Arthroplasty, Replacement, Knee , Osteoarthritis, Knee , Arthroplasty, Replacement, Knee/methods , Femur/surgery , Humans , Knee Joint/diagnostic imaging , Knee Joint/surgery , Osteoarthritis, Knee/diagnostic imaging , Osteoarthritis, Knee/surgery , Tibia/diagnostic imaging , Tibia/surgeryABSTRACT
The role of the patella is paramount in the transmission of the quadriceps muscle forces, the increase of the lever arm, the distribution of the forces on the trochlea and the centring of the extensor apparatus. Despite the low incidence of patellar factures in comparison with other lower limb fractures, the painful and functional complications, such as knee stiffness, loss of extension and patellofemoral osteoarthritis, can be very disabling and will often compromise the return to a professional or recreational activity and induce falls in the elderly population. Treatment can be conservative or surgical, provided that it is adapted to the type of fracture. Undisplaced fractures with an intact extensor mechanism can be treated nonoperatively. Surgical treatment is recommended for fractures that either disrupt the extensor mechanism or have more than 2 to 3 mm of step-off and more than 1 to 4 mm of displacement. Tension band fixation is the most commonly employed surgical technique. In most cases, hardware has to be removed after fracture healing because of implant-related pain. Operative treatment of comminuted patellar fractures presents a significant challenge to surgeons. Failure to restore the articular surface contour results in posttraumatic arthritis. Anatomical reconstruction of the articular surface is the only way to prevent the development of posttraumatic osteoarthritis. Typically, fracture classification and thus treatment choice are based on anteroposterior and lateral radiographs of the knee, but when computed tomography of the knee was performed pre-operatively, both the classification and treatment were modified thanks to a better understanding of the fracture complexity. The purpose of this article is to review current treatment strategies and optimise the management of adult patients with patellar fractures.