ABSTRACT
Today microalgae represent a viable alternative source for high-value products. The specie Chlorella protothecoides (Cp), heterotrophically grown, has been widely studied and provides a high amount of lutein and fatty acids (FA) and has a good profile for biodiesel production. This work studies carotenoid and FA production by autotrophic grown Cp. Cp was grown until the medium's nitrogen was depleted, then diluted in NaCl solution, resulting in nutritional, luminosity, and salinity stresses. Different NaCl concentrations were tested (10, 20, 30 g/L) at two different dilutions. After dilution, a color shifting from green to orange-red was noticed, showing carotenoid production. The best production of both carotenoids and FA was attained with a 20 g/L NaCl solution. The total carotenoid content was 0.8 % w/w (canthaxanthin (23.3 %), echinenone (14.7 %), free astaxanthin (7.1 %), and lutein/zeaxanthin (4.1 %)). Furthermore, the total lipid content reached 43.4 % w/w, with a FA composition of C18:1 (33.64 %), C16:0 (23.30 %), C18:2 (11.53 %), and less than 12 % of C18:3, which is needed to fulfill the biodiesel quality specifications (EN 14214).
Subject(s)
Carotenoids/metabolism , Chlorella/metabolism , Light , Lipid Metabolism , Salinity , Stress, Physiological , Biofuels , Chlorella/drug effects , Chlorella/physiology , Chlorella/radiation effects , Color , Fermentation , Sodium Chloride/metabolismABSTRACT
Biofuel production from microalgal biomass could be an alternative solution to conventional biofuels typically dependent on food and high land/water demanding crops. However, the economic and energetic viability of microalgal biofuels is limited by their harvesting processes. The finding of innovative, low cost and efficient harvesting method(s) is imperative. In this study, the Electro-Coagulation (EC) was studied as a process to harvest the marine Nannochloropsis sp. microalga. Several EC operational conditions were studied and the best EC recovery efficiency (>97%) was achieved using a current density of 8.3 mA cm(-2) for 10 min. The quality of the recovered microalgal biomass was evaluated in terms of total lipids, fatty acid and pigment profile where no significant differences were observed after EC treatment. The energy requirements of the harvesting process were estimated and the combination of EC and centrifugation processes proved to decrease significantly the energy demand when compared with the individual process.
Subject(s)
Biofuels/microbiology , Biomass , Electrochemical Techniques/methods , Microalgae/growth & development , Pigments, Biological/biosynthesis , Absorption , Aluminum/analysis , Centrifugation , Electricity , Electrochemical Techniques/instrumentation , Electrodes , Microalgae/metabolism , Oils/analysis , Spectrum Analysis , Thermodynamics , Time FactorsABSTRACT
The microalga Nannochloropsis sp. was used in this study, in a biorefinery context, as biomass feedstock for the production of fatty acids for biodiesel, biohydrogen and high added-value compounds. The microalgal biomass, which has a high lipid and pigment content (mainly carotenoids), was submitted to supercritical CO2 extraction. The temperature, pressure and solvent flow-rate were evaluated to check their effect on the extraction yield. The best operational conditions to extract 33 g lipids/100 g dry biomass were found to be at 40 °C, 300 bar and a CO2 flow-rate of 0.62 g/min. The effect of adding a co-solvent (ethanol) was also studied. When supercritical CO2 doped with 20% (w/w) ethanol was used, it was possible to extract 45 g lipids/100 g dry biomass of lipids and recover 70% of the pigments. Furthermore, the remaining biomass after extraction was effectively used as feedstock to produce biohydrogen through dark fermentation by Enterobacter aerogenes resulting in a hydrogen production yield of 60.6 mL/g dry biomass.