The low energy X-ray response of the LiF:Mg:Cu:P thermoluminescent dosemeter: a comparison with LiF:Mg:Ti.

LiF:Mg:Cu:P thermoluminescent dosemeters (TLD) can be used for the same X-ray dosimetry applications as LiF:Mg:Ti, with each type having the disadvantage of a response dependent on energy, particularly at low energies. Measurements were made of the response per unit air kerma of LiF:Mg:Cu:P and LiF:Mg:Ti to nine quasi-monoenergetic X-ray beams with mean energies from 12 keV to 208 keV. Each measurement was normalized to the value produced by 6 MV X-rays. LiF:Mg:Cu:P was found to under-respond to a majority of these radiations whereas LiF:Mg:Ti over-responded to a majority. Their smallest relative measured response was produced by the lowest energy beam, and the maximum measured relative response of 1.15+/-0.07 and 1.21+/-0.07 for LiF:Mg:Cu:P and LiF:Mg:Ti, respectively, occurred at 33 keV. Energy response coefficients were derived from these measurements to estimate the error introduced by using either type of TLD to measure the dose from an X-ray spectrum different to that used for its absolute response calibration. It was calculated that if the response of either type of TLD was calibrated at 100 kVp, then an error of no more than +/-2% would be introduced into measurements of tube output at potentials of 50-130 kVp. LiF:Mg:Cu:P was found to introduce a larger error (up to 30%) into the measurement of body exit dose than LiF:Mg:Ti at tube potentials of 40-150 kVp, if its absolute response was calibrated using the corresponding body entrance beam. The method should allow this type of error to be estimated in other dosimetry applications for either type of TLD.

The response of a MOSFET, p-type semiconductor and LiF TLD to quasi-monoenergetic x-rays.

A metal oxide semiconductor field effect transistor (MOSFET), p-type semiconductor and a TLD can all be used for x-ray dosimetry, with each system having the common disadvantage of a response which is dependent upon the incident photon energy, particularly for energies < 1 MeV. A Pantak HF-320 quasi-monoenergetic x-ray unit was used to determine the response of two Thomson and Nielson TN-502RD MOSFETs, a Scanditronix EDP-10 semiconductor (build-up cap 10 mm: tissue equivalence), an EDD-5 semiconductor (build-up cap 4.5 mm: tissue equivalence) and an Lif:Mg:Ti TLD over the energy range 12-208 keV. The sensitivity of each detector was normalized to the value produced by exposure to 6 MV x-rays. The maximum relative sensitivities of the two MOSFET detectors were 4.19 +/- 0.25 and 4.44 +/- 0.26 respectively, occurring at an incident x-ray energy of 33 keV. The maximum relative sensitivity of the Scanditronix EDP-10 of 2.24 +/- 0.13 occurred at 65 keV, and for the EDD-5, it was 7.72 +/- 0.45 at 48 keV. The TLD produced a maximum relative sensitivity of 1.31 +/- 0.09 at 33 keV. Compared with available data based on heteroenergetic x-ray sources, these measurements have identified a more representative response for each detector to low-energy x-rays.

An enhanced sensitivity K-shell x-ray fluorescence technique for tibial lead determination.

A novel irradiation-detection geometry capable of enhancing sensitivity for the measurement of tibial lead content by K-shell x-ray fluorescence (XRF) is described. The high-count-rate system comprised a small-area high-specific-activity (0.147 GBq mm-2) 109Cd source and a large-area (nominally 20 cm2) uncollimated detector, forming an axially symmetric back-scattering arrangement. Precisions in the range +/- 4.9 to +/- 14.2 micrograms Pb (g bone mineral)-1 have been obtained in a study of a cohort of 63 controls and 73 workers industrially exposed to lead. These precisions are comparable with those obtained in results using earlier systems, but at reduced source activities (less than 50% of the activity of other systems) and with significant reduction in measurement time (some 30% less than the measurement times of other systems). Subsequent investigation of detector collimation resulted in a marginal improvement in energy resolution, but the restriction in detected photon fluence meant that there was an insignificant change in detection sensitivity. For the resistive feedback preamplifier used in this study a maximum energy rate of the order of 7000 MeV s-1 was found to limit measurement precisions significantly. Higher-count-rate detector systems offer a basis for obtaining mean precisions down to +/- 3 micrograms Pb (g bone mineral)-1 at one standard deviation.

Performance assessment of patient dosimetry services and X-ray quality assurance instruments used in diagnostic radiology.

Experiences of the Regional Radiation Physics and Protection Service (RRPPS) in performance assessment of diagnostic X-ray QA instrumentation and on-patient dosemeters are recounted. Issues relating to the provision of realistic and reproducible reference conditions for calibrated X-irradiations are considered and summary statistics from test measurements of dose and kVp meters are provided. For both dose and kVp meters it is indicated that as many as 25% of instruments used in routine use in the U.K. may require some adjustment before they can truly be said to be performing as the manufacturer intended. Results from intercomparison exercises for patient dosimetry services are also discussed. It is apparent that, for those centres participating in the exercise, dose assessments are generally being obtained to within a bias and a relative standard deviation of less then 10%.

In vivo X-ray fluorescence of lead in bone using K X-ray excitation with 109Cd sources: radiation dosimetry studies.

Independent experiments have been performed at two centers, to evaluate the dosimetric properties of their respective 109Cd K X-ray fluorescence (XRF) bone lead measurement systems. Measurements were made of the dose to several points on the skin on the lower leg, at the surface of the tibia, in the red marrow tibia cavity, at the midcalf, and in the abdominal region occupied by the conceptus. Overall agreement between the two data sets was found. Similarities and differences are discussed. The effective dose values for an in vivo measurement of tibia lead concentration in 1-, 5-, and 10-year-old and adult subjects were calculated from one data set to be 1100, 420, 190, and 34/38 (male/female) nSv, respectively, for an in vivo median precision (one standard deviation) of 4.9 micrograms Pb (g bone mineral)-1 for a 30-min adult measurement.