ABSTRACT
In this paper we address the possibility to perform imaging of two samples within the same acquisition time using coupled ceramic resonators and one transmit/receive channel. We theoretically and experimentally compare the operation of our ceramic dual-resonator probe with a wire-wound solenoid probe, which is the standard probe used in ultrahigh-field magnetic resonance microscopy. We show that due to the low-loss ceramics used to fabricate the resonators, and a favorable distribution of the electric field within the conducting sample, a dual probe, which contains two samples, achieves an SNR enhancement by a factor close to the square root of 2 compared with a solenoid optimized for one sample.
Subject(s)
Ceramics/chemistry , Magnetic Resonance Imaging/instrumentation , Microscopy/instrumentation , Electromagnetic Fields , Numerical Analysis, Computer-Assisted , Plant Leaves/anatomy & histology , Signal-To-Noise RatioABSTRACT
Power dissipation in electromagnetic absorbers is a quadratic function of the incident fields. To characterize an absorber, one needs to deal with the coupling that may occur between different excitations. Energy absorption interferometry (EAI) is a technique that highlights the independent degrees of freedom through which a structure can absorb energy: the natural absorption modes of the structure. The coupling between these modes vanishes. In this paper, we use the EAI formalism to analyze different kinds of plasmonic periodic absorbers while rigorously accounting for the coupling: resonant golden patches on a grounded dielectric slab, parallel free-standing silver wires, and a silver slab of finite thickness. The EAI formalism is used to identify the physical processes that mediate absorption in the near and far field. First, we demonstrate that the angular absorption, which is classically used to characterize periodic absorbers in the far field and which neglects the coupling between different plane waves, is only valid under stringent conditions (subwavelength periodicity, far-field excitation, and negligible coupling between the two possible polarizations). Using EAI, we show how the dominant absorption channels can be identified through the signature of the absorption modes of the structure, while rigorously accounting for the coupling. We then exploit these channels to improve absorption. We show that long-range processes can be exploited to enhance the spatial selectivity, while short-range processes can be exploited to improve absorptivity over wide angles of incidence. Finally, we show that by simply adding scatterers with the proper periodicity on top of the absorber, the absorption can be increased by more than 1 order of magnitude.
ABSTRACT
In many applications of absorbing structures it is important to understand their spatial response to incident fields, for example in thermal solar panels, bolometric imaging, and controlling radiative heat transfer. In practice, the illuminating field often originates from thermal sources and is only partially spatially coherent when it reaches the absorbing device. In this paper, we present a method to fully characterize the way a structure can absorb such partially coherent fields. The method is presented for any three-dimensional material and accounts for the partial coherence and partial polarization of the incident light. This characterization can be achieved numerically using simulation results or experimentally using the energy absorption interferometry that has been described previously in the literature. The absorbing structure is characterized through a set of absorbing functions onto which any partially coherent field can be projected. This set is compact for any structure of finite extent, and the absorbing function is discrete for periodic structures.