Key Factors for Binders to Enhance the Electrochemical Performance of Silicon Anodes through Molecular Design.

Silicon is considered the most promising candidate for anode material in lithium-ion batteries due to the high theoretical capacity. Unfortunately, the vast volume change and low electric conductivity have limited the application of silicon anodes. In the silicon anode system, the binders are essential for mechanical and conductive integrity. However, there are few reviews to comprehensively introduce binders from the perspective of factors affecting performance and modification methods, which are crucial to the development of binders. In this review, several key factors that have great impact on binders' performance are summarized, including molecular weight, interfacial bonding, and molecular structure. Moreover, some commonly used modification methods for binders are also provided to control these influencing factors and obtain the binders with better performance. Finally, to overcome the existing problems and challenges about binders, several possible development directions of binders are suggested.

Effects of initial particle sizes of Triarrhena lutarioriparia on processing performance, material properties, and heavy metal speciation in sewage sludge composting.

The purpose of this study was to investigate the effect of initial particle size (IPS) on the environmental parameters and heavy metal speciation during sludge composting. Three piles were conducted: fine material (FM, screen underflow), coarse material (CM, oversize product), and mixed material (MM, mix FM and CM in 1:1). Results showed that the temperature trends of the three piles in different layers were highly repeatable during the thermophilic period. With the decrease of IPS, the heating rate and the highest temperature of the pile increased, the thermophilic period was prolonged, and the highest temperature area in the pile shifted to a lower layer. It also promoted the organic matter degradation, compost maturation, and nitrogen fixation effect. Composting had a good effect on the passivation of heavy metals, especially Cd, Cu, and Pb. The passivation effect on Cd and Cu was FM > CM > MM, and on Pb was CM > FM > MM. Fourier transform infrared spectroscopy, excitation-emission matrix, and thermogravimetric thermal analysis indicated that FM had the highest content of aromatic structure and humic-like substance on D40. The redundancy analysis revealed that MM was beneficial to improve the internal uniformity during composting.

Co-composting of sewage sludge and Phragmites australis using different insulating strategies.

Insulating strategies are indispensable for laboratory-scale composting reactors, however, current insulation methods interfere with the aerobic fermentation behaviors related to composting. To address this issue, a centre-oriented real-time temperature compensation strategy was designed in this study. Five 9 L reactors (R1-R5) with different insulation strategies were used for the co-composting of dewatered sludge and Phragmites australis and compared. The process performance was assessed by monitoring the temperature, O2 and CO2 emissions, the physical-chemical properties of the composting materials were evaluated by measuring the organic matter (OM), carbon nitrogen ratio (C/N), pH, electrical conductivity (EC), and fluorescence excitation-emission matrix (EEM) spectra. And a 16S rDNA analysis was used to quantify the evolution of bacterial community. The main findings are as follows. Compared with R1 as a control, the insulating strategies can increase the maximum temperature and prolong the thermophilic phase of composting. Comparing R1 and R3 showed that real-time temperature compensation can better restore the real fermentation of the compost. The results showed that R5 had the best composting effect, reaching 69.8 °C, which was 25.1%, 29.7%, 19.3%, and 17.3% higher than R1, R2, R3, and R4, respectively, and remaining in the thermophilic phase for 4.24 d, which is 1.4, 1.5, 1.3, and 0.2 times longer than R1, R2, R3, and R4, respectively. Furthermore, it can significantly reduce the temperature difference between the centre and edge of the reactor, which improved the composting material allocation efficiency and composting process control accuracy, further providing a basis for the actual full-scale composting operation.