Experimental study on the adsorption of Cr+6 and Ni+2 from aqueous solution using low-cost natural material.

The adsorption behavior of Chromium (Cr)(VI) and Nickel (Ni)(II) from aqueous solution onto date pits (DPs) was investigated as a function of initial concentration (5-100 mg/L), contact time (0-70 min), adsorbent dose (2-20 g/L), pH (1-9), and temperature (25-95[Formula: see text] Equilibrium took place after 45 and 55 min for Cr(VI) and Ni(II), respectively. The removal efficiency reached 100% and 95% for Cr(VI) and Ni(II), respectively, at optimal conditions. Fourier-transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), and Brunauer-Emmett-Teller (BET) analyses were performed to characterize the adsorbent. The Langmuir, Freundlich, Tempkin, and Dubinin-Radushkevich (D-R) models were applied to describe the equilibrium isotherms. The values of the free energy (ΔG), enthalpy (ΔH), and entropy (ΔS) were 34.599 kJ/mol, 17.5736 kJ/mol K, and -51.58 kJ/mol K, respectively, at pH 3 for Cr(VI) and -25.283 kJ/mol, -14.8525 kJ/mol K, and 31.31 kJ/mol K, respectively, at pH 6 for Ni(II). Kinetics of the adsorption was analyzed. The pseudo-first-order was suitable for Cr(VI) at R2 = 0.9977, and the pseudo-second-order model was suitable for the Ni(II) at R2 = 0.999. The maximum adsorption capacities were 110.02 mg Cr(VI)/g and 10.1 mg Ni(II)/g. A single-stage batch adsorber was designed for the adsorption of Cr(VI) and Ni(II) by DP based on the optimum isotherm.

Management of agricultural waste for removal of heavy metals from aqueous solution: adsorption behaviors, adsorption mechanisms, environmental protection, and techno-economic analysis.

In the last decades, Egypt has been suffering from the phenomenon of black cloud resulting from burning rice husk and increasing the demand for water leading to the water crisis. An alternative, low-value and surplus agricultural byproduct (rice husk, RH) has an enormous potential for the removal of Cu(II) ions from water. The present study focuses on the chance of the use of rice husk as a bio-adsorbent without any chemical treatment instead of burning it and soiling the environment. The elemental, structural, morphological, surface functional, thermal, and textural characteristics of RH are determined by XRF, XRD, SEM, FT-IR, TGA, and BET surface area, respectively, and contributed to the understanding of the adsorption mechanism of Cu(II) ions in aqueous solution. Also, the performance analysis, adsorption mechanism, influencing factors, favorable conditions, etc. are discussed in this article. The results obtained from optimization by batch mode are achieved under the following conditions: initial concentration, 150 ppm; amount of rice husk, 1 g; average particle size, 0.25 mm; temperature, 25 °C; pH, 4; agitation rate, 180 rpm; and contact time, 60 min. RH exhibits a high degree of selectivity for Cu(II) adsorption. The adsorption isotherm is fitted well with Langmuir and Freundlich models with R 2 0.998 and 0.997, respectively. The adsorption is well governed by the pseudo-second-order kinetics. It is observed that the rate of adsorption improves with decreasing temperature, and the process is exothermic and non-spontaneous. Particular attention has being paid to factors as production processes, fixed/operational cost, production cost, and profit. The techno-economical analysis is presented in this study that provides precise demands on capital for a fixed investment, provisions for operational capital, and finally provisions for revenue. The social, economical, and environmental benefits by industrial point of view using low-cost adsorbent are also discussed.