ABSTRACT
In order to know the potatoes nitrogen situation rapidly and accurately, promoting the efficient use of nitrogen fertilizer on the potatoes. Using the feature of portable hyperspectral spectrometer, digital cameras and SPAD-502 chlorophyll meter to abtain the potato digital indicators, leaf spectral and SPAD. Analysing the change status of digital indicators, leaf spectral index, SPAD and production of potatoes under different nitrogen levels in two key periods. Analysing the correlation between canopy image, leaf spectral and SPAD and production, with SPAD as auxiliary validation index, nitrogen fertilizer efficiency evaluation of yield to make sure potato canopy image under the most economic nitrogen application levels and leaf spectral's critical value to explore the methods of nitrogen nutrition diagnosis quickly and simply. The results show: (1)With nitrogen levels increased, potato tuber formation stage and tuber bulking stage leaf spectral reflectance is the emergence of the "red shift" phenomenon, and the red edge parameters REP, Lwidth, FD_Max increased, Lo decreased. (2)With the nitrogen levels increased, potatoes tuber formation stage and tuber bulking stage digital indicators G/B, (G-B)/(R+G+B) decreased gradually, B/(R+G+B) increased gradually. (3) with the increase of nitrogen application rate SPAD is increased.It is obvious low nitrogen levels increase production with nitrogen increased. It is not obvious the high level of nitrogen stimulation effect. Potato canopy image, leaf spectral and red edge parameters have good correlation with SPAD value and productions, establishing the index evaluation of nitrogen nutrition abundance or lack of quantitative standard of potatoes. Indicating digital image and spectrum technology to nitrogen nutrition diagnosis of potatoes is feasible, provide research ideas and technical support for the potato accurate monitoring of nitrogen nutrition.
ABSTRACT
High-pressure ultrasound-assisted extraction technology was applied to extract ferulic acid, senkyunolide I, senkyunolide H, senkyunolide A, ligustilide and levistolide A from Ligusticum chuanxiong rhizomes. Seven independent variables, including solvent type, pressure, particle size, liquid-to-solid ratio, extraction temperature, ultrasound power, and extraction time were examined. Response Surface Methodology (RSM) using a Central Composite Design (CCD) was employed to optimize the experimental conditions (extraction temperature, ultrasonic power, and extraction time) on the basis of the results of single factor tests for the extraction of these six major components in L. chuanxiong rhizomes. The experimental data were fitted to a second-order polynomial equation using multiple regression analysis and were also examined using appropriate statistical methods. The best extraction conditions were as follows: extraction solvent: 40% ethanol; pressure: 10 MPa; particle size: 80 mesh; liquid-to-solid ratio: 100:1; extraction temperature: 70 °C; ultrasonic power, 180 W; and extraction time, 74 min.
Subject(s)
Drugs, Chinese Herbal/chemistry , Plant Extracts/chemistry , Rhizome/chemistry , Benzofurans/chemistry , Benzofurans/isolation & purification , Chromatography, High Pressure Liquid , Drugs, Chinese Herbal/isolation & purification , Humans , Ligusticum , Regression Analysis , UltrasonicsABSTRACT
OBJECTIVE: To decide on the optimum artificial domestication cultivation light environment for Paris polyphylla var. chinensis through investigating the effect of light intensity on leaf's gas exchange parameters, photosynthetic parameters, light saturation point and compensation point of Paris polyphylla var. chinensis. METHODS: Different low-light stress gradients' effect on the growth of Paris polyphylla var. chinensis was compared with no low-light stress treatment through calculating leaf's gas exchange parameters, photosynthetic parameters, light saturation point and compensation point, and then all these parameters were statistically analyzed. RESULTS: Light intensity had significant influence on the photosynthetic characteristics of Paris polyphylla var. chinensis. With the strengthening of the low-light stress, chlorophyll content, gas exchange parameters, photosynthetic parameters P., AQY and light saturation point all gradually increased at first, and then decreased. However, both photosynthetic parameters Rd and light compensation point firstly decreased and then rose again. These results showed that too strong or too weak light intensity affected the optimization of photosynthetic parameters of Paris polyphylla var. chinensis. The optimal illuminance for each parameter was not completely same, but they could all reach a relative ideal state when the shading ranges between 40% and 60%. However, photosynthetic parameters deteriorated rapidly when the shading surpass 80%. CONCLUSION: For artificially cultivating Paris polyphylla var. chinensis in Baoxing,Sichuan or the similar ecological region, shading 40%-60% is the optimal light environment, which can enhance the photosynthesis of Paris polyphylla var. chinensis and promote the accumulation of photosynthetic products.
Subject(s)
Liliaceae , Photosynthesis , Stress, Physiological , Chlorophyll , Light , Plant LeavesABSTRACT
A simple and quick method is described for the determination of ferulic acid, senkyunolide I, senkyunolide H, senkyunolide A and ligustilide in rhizomes of Ligusticum chuanxiong. The 5 active ingredients in the sample was extracted using 40% ethanol and analyzed by reversed-phase high performance liquid chromatography (HPLC). Chromatography separation was performed using Agilent 1100 series HPLC system with a Symmetry C18 column and gradient elution with a mixture of three solvents : solvent A, acetonitrile, solvent B, methanol and solvent C, 1% aqueous acetic acid, 0 min to 5 min A: B: C 20: 40: 40, 5 min to 30 min A: B: C 60 to 100 : 0 : 40 to 0. The effluent was monitored using a VWD detector set at 321 nm (0-4.3 min) and 275 nm (4.31-30 min). The flow rate was set at 1 mL x min(-1) and the injection volume was 10 microL. The column temperature was maintained at 35 degrees C. The calibration curve was linear (r > or = 0.99) over the tested ranges. The average recovery was 94.44%-103.1% (n = 6). The method has been successfully applied to the analysis in different harvest periods of L. chuanxiong samples. In this paper, single-factor randomized block design to study the 5 components content of L. chuanxiong on ten collecting stages. For the L. chuanxiong collected from April 15th to May 30rd, the content of 5 ingredients increased primarily, and then decreased. Determine the appropriate harvest time has important significance to the promotion of the quality of L. chuanxiong.
Subject(s)
4-Butyrolactone/analogs & derivatives , Benzofurans/analysis , Chromatography, High Pressure Liquid/methods , Coumaric Acids/analysis , Ligusticum/chemistry , 4-Butyrolactone/analysis , Acetic Acid/chemistry , Acetonitriles/chemistry , Methanol/chemistry , Solvents/chemistry , Time FactorsABSTRACT
A field trial was carried out to study the influence of different kinds of spring topdressing on growth, yield and quality of Ligusticum chuanxiong. The results showed that the spring topdressing had effects of improving root length, tiller numbers and plant height to some extent. At the same time the chlorophyll content and dry weight accumulation especially the dry weight of root increased significantly. It also showed that the yield increased and quality was improved significantly. The effect of different treatment with urea58.7 kg x hm(-2)(N 27 kg x hm(-2)) was the best and the treatment with N,P,K the second.
Subject(s)
Alkaloids/metabolism , Coumaric Acids/metabolism , Fertilizers , Ligusticum/growth & development , Ligusticum/metabolism , SeasonsABSTRACT
The aim of this study was to explore the effects of different density treatments on potato spatial distribution and yield in spring and fall. Plant density influenced yield and composition, horizontal, and vertical distribution distances between potato tubers, and spatial distribution position of tuber weights. The results indicated that: (1) Spring potato yield had a convex quadratic curve relationship with density, and the highest value was observed at 15.75 × 10(4) tubers per hectare. However, the yield of fall potatoes showed a linear relationship with plant density, and the highest value was observed at 18 × 10(4) tubers per hectare; (2) Density had a greater influence on the tuber weight of spring potatoes and fruit number of single fall potatoes; (3) The number of potato tubers in the longitudinal concentration exhibited a negative linear relationship with density, whereas the average vertical distribution distance of tubers exhibited a positive incremental hyperbolic relationship. For spring and fall potato tubers, the maximum distances were 8.4152 and 6.3316 cm, and the minimum distances 8.7666 and 6.9366 cm, respectively; and (4) Based on the artificial neural network model of the spatial distribution of tuber weight, density mainly affected the number and spatial distribution of tubers over 80 g. Tubers over 80 g were mainly distributed longitudinally (6-10 cm) and transversely (12-20 cm) within the high density treatment, and the transverse distribution scope and number of tubers over 80 g were reduced significantly. Spring potato tubers over 80 g grown at the lowest density were mainly distributed between 12 and 20 cm, whereas those at the highest density were primarily distributed between 10 and 15 cm.
ABSTRACT
High-pressure ultrasound-assisted extraction was used to extract polysaccharides from the Ligusticum chuanxiong rhizomes. Three independent variables, namely, extraction temperature (X1), ultrasonic power (X2) and extraction time (X3) were investigated. Response surface methodology was performed based on the results of single-factor tests. Experimental data were fitted to a second-order polynomial equation using multiple regression analysis, and results were examined using appropriate statistical methods. The optimal conditions were as follows: extraction temperature of 85°C, ultrasonic power of 187 W and extraction time of 29 min. Under these conditions, the experimental yield of polysaccharides was 5.33%, which is close to the predicted yield of 5.41%. The extracted and purified polysaccharides showed excellent antioxidative effects on 2,2-diphenyl-1-picryl-hydrazy, hydroxyl and superoxide radicals in vitro.