Determination of ultratrace levels of tributyltin in waters by isotope dilution and gas chromatography coupled to tandem mass spectrometry.

The current EU legislation lays down the Environmental Quality Standards (EQS) of 45 priority substances in surface water bodies. In particular, the concentration of tributyltin (TBT) must not exceed 0.2ngL(-1) and analytical methodologies with a Limit of Quantification (LOQ) equal or below 0.06ngL(-1) are urged to be developed. This work presents a procedure for the determination of ultratrace levels of TBT in water samples by Isotope Dilution and GC-MS/MS operating in Selected Reaction Monitoring (SRM) mode which meets current EU requirements. The method requires the monitorization of five consecutive transitions (287>175 to 291>179) for the sensitive and selective detection of TBT. The measured isotopic distribution of TBT fragment ions was in agreement with the theoretical values computed by a polynomial expansion algorithm. The combined use of Tandem Mass Spectrometry, a sample volume of 250mL, the preconcentration of 1mL of organic phase to 30µL and an injection volume of 25µL by Programmed Temperature Vaporization provided a LOQ of 0.0426ngL(-1) for TBT (calculated as ten times the standard deviation of nine independent blanks). The recovery for TBT calculated in Milli-Q water at the EQS level was 106.3±4%. A similar procedure was also developed for the quantification of dibutyltin (DBT) and monobutyltin (MBT) in water samples showing satisfactory results. The method was finally implemented in a routine testing laboratory to demonstrate its applicability to real samples obtaining quantitative recoveries for TBT at the EQS level in mineral water, river water and seawater.

Acute health effects after accidental exposure to styrene from drinking water in Spain.

OBJECTIVES: We studied subjective health symptoms in a population accidentally exposed to high styrene concentrations in drinking tap water. The contamination occurred during the reparation of a water tank. METHODS: Residents of 27 apartments in two buildings using the contaminated water were contacted. A questionnaire on subjective symptoms was administered to 84 out of 93 persons living in the apartments at the time of the accident. Styrene concentration was measured in samples of water collected two days after the accident. The means of exposure associated with appearance of symptoms were examined through case-control analyses. RESULTS: Styrene in water reached concentrations up to 900 microg/L. Symptoms were reported by 46 persons (attack rate 55 %). The most frequent symptoms were irritation of the throat (26%), nose (19%), eyes (18%) and the skin (14%). General gastrointestinal symptoms were observed with 11% reporting abdominal pain and 7% diarrhea. The factors most strongly associated with symptoms were drinking tap water (OR = 7.8, 95% CI 1.3-48), exposure to vapors from the basement (OR = 10.4, 2.3-47) and eating foods prepared with tap water (OR = 8.6, 1.9-40). All residents in the ground floor reported symptoms. CONCLUSIONS: This accidental contamination led to very high styrene concentrations in water and was related to a high prevalence of subjective symptoms of the eyes, respiratory tract and skin. Similar exposures have been described in workers but not in subjects exposed at their residence. Various gastrointestinal symptoms were also observed in this population probably due to a local irritative effect.

Isotope dilution GC-MS routine method for the determination of butyltin compounds in water.

A standard GC-MS instrument with electron impact ionisation has been used to develop a fast, simple and reliable method for the simultaneous determination of monobutyltin (MBT), dibutyltin (DBT) and tributyltin (TBT) in water samples. Isotope dilution analysis (IDA) is used for the determination of species, taking advantage of a commercially available spike solution containing a mixture of MBT, DBT and TBT enriched in 119Sn. Method detection limits for 100-mL samples were between 0.18 and 0.25 ng L(-1) for the three butyltin compounds with typical RSD between 2 and 4% at levels between 100 and 10 ng L(-1), respectively. Recovery of tin species in spiked samples (natural water, wastewater and seawater) was quantitative. The stability of butyltin compounds in collected seawater samples was also studied. The addition of a 1% (v/v) glacial acetic acid preserved tin species in the samples for at least 5 days at room temperature. The IDA method was finally implemented in a routine testing laboratory and it was subsequently accredited by the Spanish National Accreditation Body according to the requirements of UNE-EN ISO/IEC 17025.