RESUMEN
The reduction of Cu(II) oxide species in siliceous matrixes of different porosity (MFI, FAU, MCM-48) and in alumosilicate MFI was studied by temperature-programmed reduction in hydrogen (TPR), by X-ray absorption fine structure (after stationary hydrogen treatments), and by transmission electron microscopy. It was found that the reduction may proceed in one or in two reduction steps. The two-step scheme known for zeolites was observed also for Cu(II) in siliceous microporous matrixes, with similar temperature of Cu(II) reduction onset as for the alumosilicate MFI. Therefore, the two-step scheme cannot be explained by the stabilization of Cu ions by intra-zeolite electrical fields. CuOx clusters in MCM-48 were reduced in a one-step scheme (similar to bulk CuO) at high Cu content (6 wt %) but in a two-step scheme at low Cu content (1 wt %). The two reduction steps observed with most samples cannot be identified with the transitions of all Cu(II) to Cu(I) and of Cu(I) to Cu(0). Instead, Cu(0) nuclei were observed already at low reduction temperatures and were found to coexist with Cu ions over temperature ranges of different extension. This coexistence range was narrow in materials that favor aggregation of the Cu nuclei into particles: Cu-MCM-48 of low Cu content and Cu-ZSM-5. In the latter, metal segregation from the pore system was found to be accompanied by an autocatalytic initiation of the second reduction step. In the siliceous microporous matrixes, the Cu(0) nuclei were observed to coexist with Cu ions over wide temperature ranges (100 K for MFI) at temperatures far above that of Cu reduction in the bulk oxide. These observations suggest that oligomeric Cu metal nuclei which may have been formed, e.g., at the intersections of the MFI channel system, may be unable to activate hydrogen, which would be required for rapid reduction of the coexisting Cu ions.
RESUMEN
The deposition of polycyclic aromatic hydrocarbons on substrate surfaces is a key step for using such disklike molecules in nanoelectronic devices. An alternative to the (frequently problematic) preparation by evaporation or deposition from solution is to use the substrate surface as a template for the planarization that accompanies the cyclodehydrogenation (see picture).
RESUMEN
Palladium islands with a thickness of a few monolayers were deposited on top of a self-assembled monolayer (SAM) fabricated from 4-mercaptopyridine. In the I(V) curves obtained using the scanning tunneling microscope (STM) clearly the signature of Coulomb blockade is observed, explicitly demonstrating that these islands are coupled to the underlying gold substrate only via a tunneling barrier; this spectroscopic feature also allows to distinguish the palladium islands from similar morphological features present on the gold substrate prior to palladium deposition.
Asunto(s)
Cristalización/métodos , Galvanoplastia/métodos , Microelectrodos , Nanoestructuras/química , Nanoestructuras/ultraestructura , Compuestos Orgánicos/química , Paladio/química , Adsorción , Impedancia Eléctrica , Diseño de Equipo , Análisis de Falla de Equipo , Tamaño de la Partícula , Electricidad Estática , Propiedades de Superficie , TemperaturaRESUMEN
Exposure of the mixed-terminated surface to atomic hydrogen at room temperature is found to lead to drastic changes of the electrical properties. The insulator surface is found to become metallic. By employing several experimental techniques (electron energy loss spectroscopy, He-atom scattering, and scanning tunneling microscopy) together with ab initio electronic structure calculations we demonstrate that a low-temperature (1 x 1) phase with two H atoms in the unit cell transforms upon heating to another (1 x 1) phase with only one H atom per unit cell. The odd number of electrons added to the surface per unit cell gives rise to partially filled surface states and thus a metallization of the surface.