RESUMEN
We report on stable, long-term operation of a diode-pumped solid-state laser (DPSSL) amplifying 15 ns pulses at 1029.5 nm wavelength to 10 J energy at 100 Hz pulse rate, corresponding to 1 kW average power, with 25.4% optical-to-optical efficiency. The laser was operated at this level for over 45 minutes (â¼3 · 105 shots) in two separate runs with a rms energy stability of 1%. The laser was also operated at 7 J, 100 Hz for 4 hours (1.44 · 106 shots) with a rms long-term energy stability of 1% and no need for user intervention. To the best of our knowledge, this is the first time that long-term reliable amplification of a kW-class high energy nanosecond pulsed DPSSL at 100 Hz has been demonstrated.
RESUMEN
We report on the successful amplification of 10 ns pulses to 10 J energy at 10 Hz in a DiPOLE laser amplifier using crystalline Yb:YAG/Cr:YAG composite slabs manufactured using adhesive-free bonding (AFB) technology. We demonstrate that bonded slabs are suitable for operation in high energy cryogenic laser amplifiers. We also report on frequency doubling of the beam amplified in the bonded slabs. When the pulse energy of the output infrared beam is set to 5 J, a pulse energy of 3.9 J is achieved in the green (corresponding to 78% conversion efficiency). Results demonstrate that AFB technology is suitable for producing large-sized gain material slabs and can overcome current limitations in the manufacture of large-aperture gain material pieces. We believe this work will facilitate energy scaling of high energy lasers where aperture scaling of optical elements is not achievable via conventional manufacturing techniques.
RESUMEN
In this paper, we present a model to predict thermal stress-induced birefringence in high energy, high repetition rate diode-pumped Yb:YAG lasers. The model calculates thermal depolarisation as a function of gain medium geometry, pump power, cooling parameters, and input polarisation state. We show that model predictions are in good agreement with experimental observations carried out on a DiPOLE 100 J, 10 Hz laser amplifier. We show that single-pass depolarisation strongly depends on input polarisation state and pumping parameters. In the absence of any depolarisation compensation scheme, depolarisation varies over a range between 5% and 40%. The strong dependence of thermal stress-induced depolarisation on input polarisation indicates that, in the case of multipass amplifiers, the use of waveplates after every pass can reduce depolarisation losses significantly. We expect that this study will assist in the design and optimisation of Yb:YAG lasers.
RESUMEN
We report on obtaining output energy of 146 J in 10 ns long pulses at 10 Hz repetition rate from Bivoj, a multi-Joule multi-slab cryogenic gas-cooled diode pumped solid state laser, by overcoming its damage threshold bottleneck. This is a 40% energy and power increase of the laser system in comparison to our previous publication and to the most powerful multi-Joule high power laser system.
RESUMEN
We report on the successful demonstration of second and third harmonic conversion of a high pulse energy, high average power 1030 nm diode pumped Yb-doped yttrium aluminum garnet (Yb:YAG) nanosecond pulsed laser in a large aperture lithium triborate (LBO) crystal. We demonstrated generation of 59.7 J at 10 Hz (597 W) at 515 nm (second harmonic) and of 65.0 J at 1 Hz (65 W) at 343 nm (third harmonic), with efficiencies of 66% and 68%, respectively. These results, to the best of our knowledge, represent the highest energy and power reported for frequency conversion to green and UV-A wavelengths.
RESUMEN
We report on frequency doubling of high-energy, high-repetition-rate ns pulses from a cryogenically gas cooled, multi-slab Yb:YAG laser system, using a type-I phase-matched lithium triborate (LBO) crystal. Pulse energy of 4.3 J was extracted at 515 nm for a fundamental input of 5.4 J at 10 Hz (54 W), corresponding to a conversion efficiency of 77%. However, during long-term operation, a significant reduction of efficiency (more than 25%) was observed owing to the phase mismatch arising due to the temperature-dependent refractive index change in the crystal. This forced frequent angle tuning of the crystal to recover the second-harmonic generation (SHG) energy. More than a five-fold improvement in energy stability of SHG was observed when the LBO crystal was mounted in an oven, and its temperature was controlled at 27°C. Stable frequency doubling with 0.8% rms energy variation was achieved at a higher input power of 74 W when the LBO temperature was controlled at 50°C.
RESUMEN
We report on type-I phase-matched second harmonic generation (SHG) in three nonlinear crystals: DKDP (98% deuteration), YCOB (XZ plane), and LBO (XY plane), of 8 J, 10 Hz cryogenic gas cooled Yb:YAG laser operating at 1029.5 nm. DKDP exhibited an efficiency of 45% at a peak fundamental intensity of 0.24 GW/cm2 for 10 Hz operation at 10 ns. At the same intensity and repetition rate, YCOB and LBO showed 50% and 65% conversion efficiencies, respectively. Significant improvement in conversion efficiency, to a maximum of 82%, was demonstrated in LBO at 0.7 GW/cm2 and 10 Hz, generating output energy of 5.6 J at 514.75 nm, without damage or degradation. However, no improvement in conversion efficiency was recorded for YCOB at this increased intensity. Additionally, we present theoretically calculated temperature maps for both 10 J and 100 J operation at 10 Hz, and discuss the suitability of these three crystals for frequency conversion of a 100 J, 10 Hz diode pumped solid state laser (DPSSL).
RESUMEN
We report on the successful demonstration of a 100 J-level, diode pumped solid state laser based on cryogenic gas cooled, multi-slab ceramic Yb:YAG amplifier technology. When operated at 175 K, the system delivered a pulse energy of 107 J at a 1 Hz repetition rate and 10 ns pulse duration, pumped by 506 J of diode energy at 940 nm, corresponding to an optical-to-optical efficiency of 21%. To the best of our knowledge, this represents the highest energy obtained from a nanosecond pulsed diode pumped solid state laser. This demonstration confirms the energy scalability of the diode pumped optical laser for experiments laser architecture.
RESUMEN
The Diode Pumped Optical Laser for Experiments (DiPOLE) project at the Central Laser Facility aims to develop a scalable, efficient high pulse energy diode pumped laser amplifier system based on cryogenic gas cooled, multi-slab ceramic Yb:YAG technology. We present recent results obtained from a scaled down prototype laser system designed for operation at 10 Hz pulse repetition rate. At 140 K, the system generated 10.8 J of energy in a 10 ns pulse at 1029.5 nm when pumped by 48 J of diode energy at 940 nm, corresponding to an optical to optical conversion efficiency of 22.5%. To our knowledge, this represents the highest pulse energy obtained from a cryo cooled Yb laser to date and the highest efficiency achieved by a multi-Joule diode pumped solid state laser system. Additionally, we demonstrated shot-to-shot energy stability of 0.85% rms for the system operated at 7 J, 10 Hz during several runs lasting up to 6 hours, with more than 50 hours in total. We also demonstrated pulse shaping capability and report on beam, wavefront and focal spot quality.