A simplified method for the quantitation of short-chain fatty acids in human stool.

A one-vial extraction method for the quantitation of short-chain fatty acids (SCFAs) in human stool was developed. Samples were extracted with an acidified aqueous internal standard solution, sodium sulfate, and diethyl ether, followed by analysis with GC-FID. Accuracy, in terms of relative recovery, was typically between 90 and 110% for most analytes; without internal standard, the accuracy was about 5-34%; the linear dynamic range (LDR) was 0.05-50 µmol per gram; the limit of detection (LOD) was less than or equal to 0.05 µmol per gram; and the (lower) limit of quantitation (LOQ) was 1 µmol per gram. The method is suitable for quantitating acetic acid, propanoic acid, isobutyric acid, butyric acid, isovaleric acid, valeric acid, isohexanoic acid, hexanoic acid, and heptanoic acid. It is not suitable for the quantitation of formic acid. Application to human biological research was tested by the measurement of SCFA in heathy humans. This confirmed that the method performed adequately, and even better than expected, with values up to 150 µmol per gram.

Identification of 8-nonenal as an important contributor to "plastic" off-odor in polyethylene packaging.

Food and beverage products stored in polyethylene (PE) containers may absorb some of PE's volatile minor components and become tainted by its characteristic "plastic" odor. High-density PE containers that had imparted "plastic" odor to an experimental corn chip product were analyzed by simultaneous distillation/extraction to remove the volatile components, by gas chromatography/olfactometry (GC/O) to locate the offending components and by 2-D GC/mass spectrometry (MS) to identify the major "plastic" odor contributor (8-nonenal). The identification was made using high-resolution electron ionization and chemical ionization MS data to narrow the possibilities to two isomers of nonenal, followed by retrieval of reference spectra and confirmatory synthesis. By monitoring 8-nonenal in HDPE containers and corn chips it was demonstrated that 8-nonenal tracks with "plastic" aroma observed in containers and with "plastic" flavor observed in corn chips stored in the containers.

Quantitation of acrylamide in food products by liquid chromatography/mass spectrometry.

A simple and inexpensive liquid chromatography/mass spectrometry (LC/MS) method was developed for the quantitation of acrylamide in various food products. The method involved spiking the isotope-substituted internal standard (1-C13 acrylamide) onto 6.00 g of the food product, adding 40 mL distilled/deionized water, and heating at 65 degrees C for 30 min. Afterwards, 10 mL ethylene dichloride was added and the mixture was homogenized for 30 s and centrifuged at 2700 x g for 30 min, and then 8 g supernatant was extracted with 10, 5, and 5 mL portions of ethyl acetate. The extracts were combined, dried with sodium sulfate, and concentrated to 100-200 microL. Acrylamide was determined by analysis of the final extract on a single quadrupole, bench-top mass spectrometer with electrospray ionization, using a 2 mm id C18 column and monitoring m/z = 72 (acrylamide) and m/z = 73 (internal standard). For difficult food matrixes, such as coffee and cocoa, a solid-phase extraction cleanup step was incorporated to improve both chromatography and column lifetime. The method had a limit of quantitation of 10 ppb, and coefficients of determination (r2) for calibration curves were typically better than 0.998. Acceptable spike recovery results were achieved in 11 different food matrixes. Precision in potato chip analyses was 5-8% (relative standard deviation). This method provides an LC/MS alternative to the current LC/MS/MS methods and derivatization gas chromatography/mass spectrometry methods, and is applicable to difficult food products such as coffee, cocoa, and high-salt foods.

Acrylamide formation mechanism in heated foods.

Recent findings of a potential human carcinogen, acrylamide, in foods have focused research on the possible mechanisms of formation. We present a mechanism for the formation of acrylamide from the reaction of the amino acid asparagine and a carbonyl-containing compound at typical cooking temperatures. The mechanism involves formation of a Schiff base followed by decarboxylation and elimination of either ammonia or a substituted imine under heat to yield acrylamide. Isotope substitution studies and mass spectrometric analysis of heated model systems confirm the presence of key reaction intermediates. Further confirmation of this mechanism is accomplished through selective removal of asparagine with asparaginase that results in a reduced level of acrylamide in a selected heated food.