Review on Indian Municipal Solid Waste Management practices for reduction of environmental impacts to achieve sustainable development goals.

Open dumping is a common practice for MSW disposal in most of the Indian cities, apart from the metro-cities. This practice poses significant environmental and health risks due to toxic and greenhouse gases (GHGs) emission through direct combustion and/or decay of wastes. Therefore, integrated solid waste management (ISWM) using different methods viz., incineration, composting, anaerobic digestions, refuse derived fuel, material recovery facility and sanitary landfilling, is much needed. Accordingly, three waste management case scenarios were studied for year 2001-2051 by keeping weightage of sustainable development goals 2030 of India. Case I depicts Indian present scenario of waste management where 164-735 tonnes/year of wastes would be generated for year 2001-2051. Further, 60% of waste can be treated in case II that help in reducing the land requirement up to 40% from estimated conditions of 2031 i.e., 83.8 × 107 m3. The case III is most ideal waste management condition for year 2031 to reduce 80% waste hence landfill requirement would minimize up to 16.76 × 107 m3 where population is at controlled conditions. This article concludes the formal handling and treatment of ISWM would minimize the landfilling, where LCA can be an antidote to achieve sustainable development goals.

Environmental quality monitoring and impact assessment of solid waste dumpsites in high altitude sub-tropical regions.

Solid Waste Management (SWM) in high altitude regions is critically phased because of the non-availability of suitable facilities for the treatment and handling of large quantities of Municipal Solid Waste (MSW). Open burning practices at hill slopes were noticed which affect the surrounding environment. Hence, it became essential to measure the environmental components around the dumpsites to examine the impacts and suggest new technological solutions. The pollution parameters were monitored in and around the dumpsites, and the data was analysed using statistical tools. The assessment of air quality indicated maximum fine suspended particulate matter (PM2.5) concentration of 206.66 µg/m3 followed by respairable particulate matter (PM10), oxides of nitrogen (NOx) and sulphur dioxide (SO2). Among the gaseous emissions, methane (CH4) concentration was very high (38.53 mg/L) followed by carbon monoxide (CO) concentration (0.96 mg/L). Volatile organic compounds (VOCs) were also detected at few dumpsites with highest observed benzene (C6H6) concentration of 157.53 µg/m3. The soil sample analysis indicated that iron (Fe) concentration dominates followed by manganese (Mn), zinc (Zn), chromium (Cr), copper (Cu), and nickel (Ni). For evaluation of different alternatives for the SWM system, Rapid Impact Assessment Matrix (RIAM) was applied.