RESUMEN
Microscale models of foam structure traditionally incorporate a balance between bubble pressures and surface tension forces associated with curvature of bubble films. In particular, models for flowing foam microrheology have assumed this balance is maintained under the action of some externally imposed motion. Recently, however, a dynamic model for foam structure has been proposed, the viscous froth model, which balances the net effect of bubble pressures and surface tension to viscous dissipation forces: this permits the description of fast-flowing foam. This contribution examines the behavior of the viscous froth model when applied to a paradigm problem with a particularly simple geometry: namely, a two-dimensional bubble "lens." The lens consists of a channel partly filled by a bubble (known as the "lens bubble") which contacts one channel wall. An additional film (known as the "spanning film") connects to this bubble spanning the distance from the opposite channel wall. This simple structure can be set in motion and deformed out of equilibrium by applying a pressure across the spanning film: a rich dynamical behavior results. Solutions for the lens structure steadily propagating along the channel can be computed by the viscous froth model. Perturbation solutions are obtained in the limit of a lens structure with weak applied pressures, while numerical solutions are available for higher pressures. These steadily propagating solutions suggest that small lenses move faster than large ones, while both small and large lens bubbles are quite resistant to deformation, at least for weak applied back pressures. As the applied back pressure grows, the structure with the small lens bubble remains relatively stiff, while that with the large lens bubble becomes much more compliant. However, with even further increases in the applied back pressure, a critical pressure appears to exist for which the steady-state structure loses stability and unsteady-state numerical simulations show it breaks up by route of a topological transformation.
RESUMEN
A single film (typical of a film in a foam) moving in a confined geometry (i.e. confined between closely spaced top and bottom plates) is analysed via the viscous froth model. In the first instance the film is considered to be straight (as viewed from above the top plate) but is not flat. Instead it is curved (with a circular arc cross-section) in the direction across the confining plates. This curvature leads to a maximal possible steady propagation velocity for the film, which is characterised by the curved film meeting the top and bottom plates tangentially. Next the film is considered to propagate in a channel (i.e. between top and bottom plates and sidewalls, with the sidewall separation exceeding that of the top and bottom plates). The film is now curved along as well as across the top and bottom plates. Curvature along the plates arises from viscous drag forces on the channel sidewall boundaries. The maximum steady propagation velocity is unchanged, but can now also be associated with films meeting channel sidewalls tangentially, a situation which should be readily observable if the film is viewed from above the top plate. Observed from above, however, the film need not appear as an arc of a circle. Instead the film may be relatively straight along much of its length, with curvature pushed into boundary layers at the sidewalls.