RESUMEN
The development of systems for weighing vehicles in motion aims to introduce systems allowing automatic enforcement of regulations. HSWIM (high speed weight-in-motion) systems enable measurement of a mass of vehicles passing through a measurement station without disturbing the traffic flow. This article focuses on the calibration of a weighing station for moving vehicles, where strain gauge sensors are used to measure pressures. A solution was proposed to replace the calibration coefficients with calibration functions. The analysis was performed for two methods of determining wheel loads: based on the maximum of the signal from strain gauge sensors and on a method using the field under the signal and the vehicle's speed. Calibration functions were determined jointly for all test vehicles and separately for each of them. The use of a calibration function for a specific vehicle type made it possible to determine wheel pressure and gross weight with a level of accuracy that allowed the weigh-in-motion station to be classified as a direct enforcement system. The achieved improvement in the accuracy of weighing in motion did not require any interference with the measurement station. The proposed change in the method of calibration and, ultimately, determination of wheel loads required only a change in the algorithm for determining wheel loads.
RESUMEN
Due to their lack of driving controllability, overweight vehicles are a big threat to road safety. The proposed method for a moving passenger car load estimation is capable of detecting an overweight vehicle, and thus it finds its application in road safety improvement. The weight of a car's load entering or leaving a considered zone, e.g., industrial facility, a state, etc., is also of concern in many applications, e.g., surveillance. Dedicated vehicle weight-in-motion measurement systems generally use expensive load sensors that also require deep intervention in the road while being installed and also are calibrated only for heavy trucks. In this paper, a vehicle magnetic profile (VMP) is used for defining a load parameter proportional to the passenger vehicle load. The usefulness of the proposed load parameter is experimentally demonstrated in field tests. The sensitivity of the VMP to the load change results from the fact that the higher load decreases the vehicle clearance value which in turn increases the VMP. It is also shown that a slim inductive-loop sensors allows the building of a load estimation system, with a maximum error around 30 kg, which allows approximate determination of the number of passengers in the car. The presented proof of concept extends the functionality of inductive loops, already installed in the road, for acquiring other traffic parameters, e.g., moving vehicle axle-to-axle distance measurement, to road safety and surveillance related applications.
RESUMEN
We conducted experiments on SnO2 thin layers to determine the dependencies between the stoichiometry, electrochemical properties, and structure. This study focused on features such as the film structure, working temperature, layer chemistry, and atmosphere composition, which play a crucial role in the oxygen sensor operation. We tested two kinds of resistive SnO2 layers, which had different grain dimensions, thicknesses, and morphologies. Gas-sensing layers fabricated by two methods, a rheotaxial growth and thermal oxidation (RGTO) process and DC reactive magnetron sputtering, were examined in this work. The crystalline structure of SnO2 films synthesized by both methods was characterized using XRD, and the crystallite size was determined from XRD and AFM measurements. Chemical characterization was carried out using X-ray photoelectron (XPS) and Auger electron (AES) spectroscopy for the surface and the near-surface film region (in-depth profiles). We investigated the layer resistance for different oxygen concentrations within a range of 1-4%, in a nitrogen atmosphere. Additionally, resistance measurements within a temperature range of 423-623 K were analyzed. We assumed a flat grain geometry in theoretical modeling for comparing the results of measurements with the calculated results.