RESUMEN
Membrane-less single-medium sediment microbial fuel cells (single-SMFC) can remove Cu2+ from sediment through electromigration. However, the high mass transfer resistance of the sediment and amount of oxygen at the cathode of the SMFC limit its Cu2+ removal ability. Therefore, this study used an oxygen-releasing bead (ORB) for slow oxygen release to increase oxygen at the SMFC cathode and improve the mass transfer property of the sediment. Resultantly, the copper removal efficiency of SMFC increased significantly. Response surface methodology was used to optimize the nano zero-valent iron (nZVI)-modified biochar as the catalyst to enhance the ability of the modified ORB (ORBm) to remove Cu2+ and slow release of O2. The maximum Cu2+ removal (95 %) and the slowest O2 release rate (0.41 mg O2/d·g ORBm) were obtained when the CaO2 content and ratio of nZVI-modified biochar to unmodified biochar were 0.99 g and 4.95, respectively. When the optimized ORBm was placed at the single-SMFC cathode, the voltage output and copper removal increased by 4.6 and 2.1 times, respectively, compared with the system without ORBm. This shows that the ORBm can improve the migration of Cu2+ in the sediment, providing a promising remediation method for Cu-contaminated sediments.
Asunto(s)
Fuentes de Energía Bioeléctrica , Carbón Orgánico , Cobre , Electrodos , Sedimentos Geológicos , Hierro , Oxígeno , Fuentes de Energía Bioeléctrica/microbiología , Carbón Orgánico/química , Cobre/química , Oxígeno/química , Hierro/química , Sedimentos Geológicos/química , Sedimentos Geológicos/microbiologíaRESUMEN
Escherichia coli has been used as an indicator of fecal pollution in environmental waters. However, its presence in environmental waters does not provide information on the source of water pollution. Identifying the source of water pollution is paramount to be able to effectively reduce contamination. The present study aimed to identify E. coli microbial source tracking (MST) markers that can be used to identify domestic wastewater contamination in environmental waters. We first analyzed wastewater E. coli genomes sequenced by us (n = 50) and RefSeq animal E. coli genomes of fecal origin (n = 82), and identified 144 candidate wastewater-associated marker genes. The sensitivity and specificity of the candidate marker genes were then assessed by screening the genes in 335 RefSeq wastewater E. coli genomes and 3318 RefSeq animal E. coli genomes. We finally identified two MST markers, namely W_nqrC and W_clsA_2, which could be used for detection of wastewater-associated E. coli isolates. These two markers showed higher performance than the previously developed human wastewater-associated E. coli markers H8 and H12. When used in combination, W_nqrC and W_clsA_2 showed specificity of 98.9 % and sensitivity of 25.7 %. PCR assays to detect W_nqrC and W_clsA_2 were also developed and validated. The developed PCR assays are potentially useful for detecting E. coli isolates of wastewater origin in environmental waters, though users should keep in mind that the sensitivity of these markers is not high. Further studies are needed to assess the applicability of the developed markers to a culture-independent approach.
Asunto(s)
Escherichia coli , Aguas Residuales , Animales , Humanos , Escherichia coli/genética , Microbiología del Agua , Contaminación del Agua/análisis , Reacción en Cadena de la Polimerasa , Heces , Monitoreo del AmbienteRESUMEN
The emergence of antibiotic-resistant bacteria (ARB) and their antibiotic resistance genes (ARGs) poses a serious challenge to human, animal, and environmental health worldwide. ARB can spread into the environment via various sources and routes. In this study, we investigated the occurrence of antibiotic-resistant E. coli in the southern watershed of Lake Biwa. Two-year monitoring of antibiotic-resistant E. coli was carried out in the southern part of Lake Biwa and inflow rivers and at three WWTPs around the southern part of the lake. Concentrations of E. coli in waters that are resistant to ampicillin (AMP), cefotaxime (CTX), ceftazidime (CAZ), levofloxacin (LVFX), tetracycline (TC), and amikacin (AMK) were measured using the culture method. Of these antibiotic-resistant E. coli, AMP-resistant E. coli were found at the highest prevalence, followed by LVFX, CTX, CAZ, TC, and AMK-resistant in both the influent and effluent of WWTPs. These resistance patterns in wastewater are the same as those in clinical samples in Japan. The numbers of antibiotic-resistant E. coli decreased by around a factor of 1000 during the wastewater treatment processes, but the rates clearly increased, suggesting that selection for antibiotic resistance might occur during the wastewater treatment process. AMP-resistant and TC-resistant E. coli were also detected in Lake Biwa and inflow rivers, which suggests that antibiotic resistance might come from not only WWTPs but also livestock farms and small-scale wastewater treatment facilities located in the river catchment.
Asunto(s)
Ampicilina , Antibacterianos , Farmacorresistencia Bacteriana , Escherichia coli , Lagos , Purificación del Agua , Ampicilina/farmacología , Antibacterianos/farmacología , Escherichia coli/efectos de los fármacos , Escherichia coli/aislamiento & purificación , Genes Bacterianos , Lagos/microbiología , Tetraciclina/farmacología , Aguas Residuales/análisis , Aguas Residuales/microbiología , Purificación del Agua/métodosRESUMEN
Microbial desalination cells (MDCs) are promising bioelectrochemical systems that are being investigated for simultaneous seawater desalination, electricity generation, and wastewater treatment. Anode materials play an important role in determining the performance of MDCs. In this study, a three-dimensional (3D) macroporous sponge was coated with compatible and conductive carbon nanotube-chitosan (CNT-CS) as a composite electrode for MDCs. Experimental results showed that the flexible CNT-CS sponge exhibited a high capacitance (159.4F/g at 20mVs-1), good cycling stability (96% specific capacitance retention after 1000 cyclic voltammetry cycles) and low resistance. Moreover, the MDC with a CNT-CS sponge anode generated a high power density of 1776.6mW/m2 (per electrode area) and desalination rate of 16.5mgh-1, which are significantly higher than those of commercial carbon felt electrodes under the same conditions. The improved MDC performance can be attributed to the continuous 3D macroporous structure of the sponge anode promoting the bacterial loading capacity on the electrode surface. Moreover, the presence of CNTs also further enhances extracellular electron transfer. Our results demonstrate that an MDC operating with a 3D CNT-CS sponge anode offers an effective means for manufacturing high-performance MDCs with wide applicability to bioelectrochemical systems.
Asunto(s)
Fuentes de Energía Bioeléctrica , Quitosano , Nanotubos de Carbono/química , Purificación del Agua/métodos , Conductividad Eléctrica , ElectricidadRESUMEN
In this study, a multiwalled carbon nanotubes-chitosan (CNTs-CS) composite electrode was fabricated to enable water purification by electrosorption. The CNTs-CS composite electrode was shown to possess excellent capacitive behaviors and good pore accessibility by electrochemical impedance spectroscopy, galvanostatic charge-discharge, and cyclic voltammetry measurements in 1 M H2SO4 electrolyte. Moreover, the CNTs-CS composite electrode showed promising performance for capacitive water desalination. At an electric potential of 1.2 V, the electrosorption capacity and electrosorption rate of NaCl ions on the CNTs-CS composite electrode were determined to be 10.7 mg g(-1) and 0.051 min(-1), respectively, which were considerably higher than those of conventional activated electrodes. The improved electrosorption performance could be ascribed to the existence of mesopores. Additionally, the feasibility of electrosorptive removal of aniline from an aqueous solution has been demonstrated. Upon polarization at 0.6 V, the CNTs-CS composite electrode had a larger electrosorption capacity of 26.4 mg g(-1) and a higher electrosorption rate of 0.006 min(-1) for aniline compared with the open circuit condition. The enhanced adsorption resulted from the improved affinity between aniline and the electrode under electrochemical assistance involving a nonfaradic process. Consequently, the CNT-CS composite electrode, exhibiting typical double-layer capacitor behavior and a sufficient potential range, can be a potential electrode material for application in the electrosorption process.