Simultaneous Dual Living Polymerizations: A Novel One-Step Approach to Block and Graft Copolymers.

Just one step is required for the synthesis of block copolymers by simultaneous "living"/controlled ring-opening and radical polymerization initiated by a difunctional (A-B) compound (shown schematically on the right).

Comb polymers prepared by ATRP from hydroxypropyl cellulose.

Hydroxypropyl cellulose (HPC) was used as a core molecule for controlled grafting of monomers by ATRP, the aim being to produce densely grafted comb polymers. HPC was either allowed to react with an ATRP initiator or the first generation initiator-functionalized 2,2-bis(methylol)propionic acid dendron to create macroinitiators having high degrees of functionality. The macroinitiators were then "grafted from" using ATRP of methyl methacrylate (MMA) or hexadecyl methacrylate. Block copolymers were obtained by chain extending PMMA-grafted HPCs via the ATRP of tert-butyl acrylate. Subsequent selective acidolysis of the tert-butyl ester moieties was performed to form a block of poly(acrylic acid) resulting in amphiphilic block copolymer grafts. The graft copolymers were characterized by 1H NMR and FT-IR spectroscopies, DSC, TGA, rheological measurements, DLS, and tapping mode AFM on samples spin coated upon mica. It was found that the comb (co)polymers were in the nanometer size range and that the dendronization had an interesting effect on the rheological properties.

ATRP grafting from cellulose fibers to create block-copolymer grafts.

Cellulose fibers, in the form of a conventional filter paper, have been modified by reacting the hydroxyl groups on the fiber surface with 2-bromoisobutyryl bromide, followed by grafting using ATRP conditions. The papers were first grafted with methyl acrylate (MA), rendering the paper very hydrophobic as reported in an earlier work. The papers were analyzed by gravimetry, FT-IR, ESCA, and AFM. To verify that the polymerization from the surface was "living", a second layer of another, hydrophilic, polymer, 2-hydroxyethyl methacrylate (HEMA), was grafted upon the PMA layer, creating a block-copolymer graft from the fibers. After the layer of PHEMA had been attached, contact angle measurements were no longer possible, because of the absorbing nature of PHEMA-grafted layer. This indicates that a copolymer had indeed been formed on the surface. FT-IR showed a large increase in carbonyl content after the PHEMA-grafting, which further proves that a layer of PHEMA was attached to the PMA layer. This goes to show that the hydrophilic/hydrophobic behavior of a cellulose surface can be tailored by the use of "living"/controlled radical polymerization methods such as ATRP.

The effect of macromolecular architecture in nanomaterials: a comparison of site isolation in porphyrin core dendrimers and their isomeric linear analogues.

The influence of macromolecular architecture on the physical properties of polymeric materials has been studied by comparing poly(benzyl ether) dendrons with their exact linear analogues. The results clearly confirm the anticipation that dendrimers are unique when compared to other architectures. Physical properties, from hydrodynamic volume to crystallinity, were shown to be different, and in a comparative study of core encapsulation in macromolecules of different architecture, energy transduction from the polymer backbone to a porphyrin core was shown to be different for dendrimers as compared to that of isomeric four- or eight-arm star polymers. Fluorescence excitation revealed strong, morphology dependent intramolecular energy transfer in the three macromolecular isomers investigated. Even at high generations, the dendrimers exhibited the most efficient energy transfer, thereby indicating that the dendritic architecture affords superior site isolation to the central porphyrin it surrounds.