Alternatives for Enhancing Mechanical Properties of Recycled Rubber Seismic Isolators.

Base isolators, traditionally made from natural rubber reinforced with steel sheets (SERIs), mitigate energy during seismic events, but their use in developing countries has been limited due to high cost and weight. To make them more accessible, lighter, cost-effective reinforcement fibers have been utilized. Additionally, the increasing use of natural rubber has caused waste storage and disposal issues, contributing to environmental pollution and disease spread. Exploring recycled rubber matrices as alternatives, this study improves seismic isolators' mechanical properties through modified reinforcements and layer adhesion. Eight reinforcement materials and eight adhesives, which may be activated with or without heat application, are systematically evaluated. Employing the chosen reinforcements and adhesives, prototypes are tested mechanically to examine their vertical and horizontal performance through cyclic compression and cyclic shear testing. Two innovative devices using recycled rubber matrices were developed, one using a layering technique and another through a monolithic approach shaped with heat and pressure. Both integrate a fiberglass mesh reinforced with epoxy resin; one employs a heat-activated hybrid adhesive, while the other uses a cold bonding adhesive. These prototypes exhibit potential in advancing seismic isolation technology for low-rise buildings in developing countries, highlighting the viability of recycled materials in critical structural applications.

Solar disinfection - An appropriate water treatment method to inactivate faecal bacteria in cold climates.

Solar disinfection (SODIS) is an inexpensive drinking water treatment method applied in tropical and sub-tropical low-income countries. However, it has been unclear whether it functions adequately also in colder climates. To investigate this issue, SODIS experiments were performed in the humid continental climate of Finland by exposing faecally contaminated drinking water to natural solar radiation at different water temperatures (8-23 °C) and UV intensities (12-19 W/m2) in polyethylene (PE) bags. To establish an adequate benchmark, SODIS experiments with the same experimental design were additionally conducted in the Mediterranean climate of Spain in typical conditions of SODIS application (~39 °C and 42 W/m2). Out of all experiments, the highest coliform and enterococci inactivation efficiencies in terms of lowest required doses for 4-log disinfection (25 Wh/m2 and 60 Wh/m2, respectively) were obtained in humid continental climate at the lowest studied mean water temperature (8-11 °C). Despite the low mean UV irradiance (~19 Wh/m2), 4-log disinfection of coliforms and enterococci were also reached fast in these conditions (1 h 27 min and 3 h 18 min, respectively). Overall, the doses required for disinfection increased as the water temperatures and UV intensities of the experiments rose. Disinfection of 4-logs (> 99.99%) of both bacteria was reached in all SODIS experiments within 6 h, suggesting SODIS could be a sufficient household water treatment method also in colder climates, unlike previously thought. The effects of different water temperatures on bacterial inactivation were also tested in the absence of sunlight. Together the obtained results indicate that while water temperatures below or close to the optima of coliforms and enterococci (~10 °C) alone do not cause inactivation, these temperatures may enhance SODIS performance. This phenomenon is attributed to slower bacterial metabolism and hence slower photorepair induced by the low water temperature.

Post-treatment of real municipal wastewater effluents by means of granular activated carbon (GAC) based catalytic processes: A focus on abatement of pharmaceutically active compounds.

Pharmaceutically active compounds (PhACs) widely present in urban wastewater effluents pose a threat to ecosystems in the receiving aquatic environment. In this work, efficiency of granular activated carbon (GAC) - based catalytic processes, namely catalytic wet peroxide oxidation (CWPO), peroxymonosulfate oxidation (PMS/GAC) and peroxydisulfate oxidation (PDS/GAC) at ambient temperature and pressure were studied for removal of 22 PhACs (ng L-1 level) that were present in secondary effluents of real urban wastewater. Concentrations of PhACs were measured using Ultra Performance Liquid Chromatography - Triple Quadrupole Mass Spectrometry (UPLC-QqQ-MS/MS). Catalytic experiments were conducted in discontinuous mode using up-flow fixed bed reactors with granular activated carbon (GAC) as a catalyst. The catalyst was characterized by means of N2 adsorption-desorption isotherm, mercury intrusion porosimetry (MIP), elemental analysis, X-ray fluorescence spectroscopy (WDXRF), X-ray diffraction (XRD), thermal gravimetry and differential temperature analyses coupled mass spectrometry (TGA-DTA-MS). Results indicate that the highest efficiency in terms of TOC removal was achieved during CWPO performed at optimal operational conditions (stoichiometric dose of H2O2; TOC removal ~ 82%) followed by PMS/GAC (initial PMS concentration 100 mg L-1; TOC removal ~73.7%) and PDS/GAC (initial PDS concentration 100 mg L-1; TOC removal ~ 67.9%) after 5 min of contact time. Full consumption of oxidants was observed in all cases for CWPO and PDS/GAC at contact times of 2.5 min, while for PMS/GAC it was 1.5 min. In general, for 18 out of 22 target PhACs, very high removal efficiencies (> 92%) were achieved in all tested processes (including adsorption) performed at optimal operational conditions during 5 min of contact time. However, moderate (40 - 70%) and poor (< 40%) removal efficiencies were achieved for salicylic acid, ofloxacin, norfloxacin and ciprofloxacin, which can be possibly attributed to insufficient contact time. Despite high efficiency of all studied processes for PhACs elimination from urban wastewater effluent, CWPO seems to be more promising for continuous operation.

Combining sun-based technologies (microalgae and solar disinfection) for urban wastewater regeneration.

Solar disinfection (SODIS) of urban wastewater can be a suitable technology for improving the microbiological quality of reclaimed water as a complement to other extensive and environmentally friendly technologies such as microalgae biotreatment. The objective of this work is to evaluate the feasibility of incorporating the SODIS technology at the end of a pilot scale urban wastewater treatment plant (WWTP) where the processes are based on microalgae biotechnology and comprising three Upflow Anaerobic Sludge Blanket (UASB, 20m3 each one) reactor, six High Rate Algal Ponds (HRAP, 32m2 each one), and a Dissolved Air Flotation (DAF, 1m3) unit. E. coli concentration was monitored at the effluent of the different units (UASB, HRAP, DAF) of the pilot WWTP. The efficiency of the SODIS process was studied for the inactivation of three of the commonly employed indicator microorganisms (Escherichia coli, Enterococcus spp. and Clostridium perfringens) using a compound parabolic collector (CPC) for five months under various conditions of irradiance and temperature. E. coli and Enterococcus spp. were more effectively disinfected by the SODIS unit (2.9 and 2.5 logarithms of reduction on average, respectively) than by the HRAP (2 and 1.1) or the DAF (0.9 and 0.1). On the contrary, the DAF technology achieved better reduction rates of C. perfringens (1.7) than the SODIS (0.9) and the HRAP (0.1). No regrowth of any microorganisms was detected during dark storage after the SODIS treatment. Incorporating a SODIS unit after the non-conventional WWTP processes substantially increases the possibilities for reuse of the treated water after receiving a cumulative UV radiation dose of 25W·h/m2 (50min of normalized time of solar illumination). The surface requirement of the SODIS equipment would be 3.5 times smaller than the HRAP's surface.

Enhancement of aerobic microbial degradation of polychlorinated biphenyl in soil microcosms.

This article reports the results of various biodegradation experiments on polychlorinated biphenyl (PCB)-contaminated sandy soil employing a mixed culture of acclimatized bacteria. Following the optimization of different variables without chemical pretreatment, the elimination rate achieved of Aroclor 1242 in slurry-phase reactors was 61% after four months of treatment, with the presence of biphenyl as cosubstrate being the most important factor affecting PCB biodegradation. The biodegradation occurred as a first-order process, and it proved most effective in respect to dichlorinated biphenyls (100% removal), followed by trichlorinated (92%) and tetrachlorinated biphenyls (24%). The results also showed that the degradability of PCBs in soil may be enhanced by an advanced oxidation pretreatment (Fenton reaction), producing almost 100% elimination of PCBs at the end of the integrated chemical-biological process and 72% mineralization of the intermediates generated during the chemical pretreatment.

Molecular structure and biodegradation kinetics of linear alkylbenzene sulphonates in sea water.

The present paper describes the results of the application of the biodegradation test proposed by the United States Environmental Protection Agency (USEPA) "Biodegradability in sea water" Office of Prevention, Pesticides, and Toxic Substances (OPPTS) 835.3160, to Linear Alkylbenzene Sulphonate (LAS), the synthetic surfactant with the highest consumption volume on a world-wide basis. High performance liquid chromatography (HPLC) has been employed for the separation and quantification of the different homologues and isomers of the surfactant. Water from the Bay of Cádiz (South-West of the Iberian peninsula) has been used as test medium. The results indicate how both lag and t (50) time shows a significant linear relationship with the length of the alkyl chain of the homologue; the effect of this is that the homologues of longer chain length not only begin to degrade first but also degrade at a faster rate. Regarding the isomeric composition, it is observed that as the percentage of biodegradation increases, there is an increase in the proportion of internal isomers, in comparison with the isomeric relationships of the original test substance.

Biodegradation kinetics of linear alkylbenzene sulphonates in sea water.

This article reports the primary biodegradation kinetics of linear alkylbenzene sulphonates (LAS) in sea water from the Bay of Cadiz (South West of the Iberian Peninsula). The authors used the biodegradation test guideline proposed by the Office of Prevention, Pesticides, and Toxic Substances of the United States Environmental Protection Agency; 835.3160 "Biodegradability in sea water" in its shake flask variant. High performance liquid chromatography (HPLC) has been employed for the analysis of the surfactant material. The surfactant shows a primary biodegradation kinetic in accordance with a logistic model, the kinetic parameters t (50) and lag time were calculated by means of a easy quantitative procedure introduced. Mean values of 6.15 +/- 0.45 and 6.67 +/- 0.6 days were obtained for t (50) and lag time, respectively. These results indicate that although LAS has a high primary biodegradation rate in sea water, it biodegrades slower than in similar tests conducted in river water.