An in vitro system to investigate IOL: Lens capsule interaction.

Posterior capsule opacification (PCO) is the most common complication associated with intraocular lens (IOL) implantation. Unfortunately, current in vitro models cannot be used to assess the potential of PCO due to their failure to simulate the posterior curvature of the lens capsule (LC) and IOL, a factor known to affect PCO pathogenesis in clinic. To overcome such a challenge, a new system to study IOL: LC interaction and potentially predict PCO was developed in this effort. It is believed that the interactions between an IOL and the lens capsule may influence the extent of PCO formation. Specifically, strong adhesion force between an IOL and the LC may impede lens epithelial cell migration and proliferation and thus reduce PCO formation. To assess the adhesion force between an IOL and LC, a new in vitro model was established with simulated LC and a custom-designed micro-force tester. A method to fabricate simulated LCs was developed by imprinting IOLs onto molten gelatin to create simulated three dimensional (3D) LCs with curvature resembling the bag-like structure that collapses on the IOL post implantation. By pushing the LC mold vertically downward, while measuring the change in position of the bending bar with respect to its start position, the adhesion force between the IOLs and LCs was measured. An in vitro system that can measure the adhesion force reproducibly between an IOL and LC with a resolution of ~1 µN was established in this study. During system optimization, the 10% high molecular weight gelatin produced the best LC with the highest IOL: LC adhesion force with all test lenses that were fabricated from acrylic foldable, polymethylmethacrylate (PMMA) and silicone materials. Test IOLs exerted different adhesion force with the 3D simulated LCs in the following sequence: acrylic foldable IOL > silicone IOL > PMMA IOL. These results are in good agreement with the clinical observations associated with PCO performance of IOLs made of the same materials. This novel in vitro system can provide valuable insight on the IOL: LC interplay and its relationship to clinical PCO outcomes.

Reduced Graphene-Oxide-Doped Elastic Biodegradable Polyurethane Fibers for Cardiomyocyte Maturation.

Conductive biomaterials offer promising solutions to enhance the maturity of cultured cardiomyocytes. While the conventional culture of cardiomyocytes on nonconductive materials leads to more immature characteristics, conductive microenvironments have the potential to support sarcomere development, gap junction formation, and beating of cardiomyocytes in vitro. In this study, we systematically investigated the behaviors of cardiomyocytes on aligned electrospun fibrous membranes composed of elastic and biodegradable polyurethane (PU) doped with varying concentrations of reduced graphene oxide (rGO). Compared to PU and PU-4%rGO membranes, the PU-10%rGO membrane exhibited the highest conductivity, approaching levels close to those of native heart tissue. The PU-rGO membranes retained anisotropic viscoelastic behavior similar to that of the porcine left ventricle and a superior tensile strength. Neonatal rat cardiomyocytes (NRCMs) and human-induced pluripotent stem cell-derived cardiomyocytes (hiPSC-CMs) on the PU-rGO membranes displayed enhanced maturation with cell alignment and enhanced sarcomere structure and gap junction formation with PU-10%rGO having the most improved sarcomere structure and CX-43 presence. hiPSC-CMs on the PU-rGO membranes exhibited a uniform and synchronous beating pattern compared with that on PU membranes. Overall, PU-10%rGO exhibited the best performance for cardiomyocyte maturation. The conductive PU-rGO membranes provide a promising matrix for in vitro cardiomyocyte culture with promoted cell maturation/functionality and the potential for cardiac disease treatment.

Spatial distribution and network morphology of epicardial, endocardial, interstitial, and Purkinje cell-associated elastin fibers in porcine left ventricle.

Cardiac extracellular matrices (ECM) play crucial functional roles in cardiac biomechanics. Previous studies have mainly focused on collagen, the major structural ECM in heart wall. The role of elastin in cardiac mechanics, however, is poorly understood. In this study, we investigated the spatial distribution and microstructural morphologies of cardiac elastin in porcine left ventricles. We demonstrated that the epicardial elastin network had location- and depth-dependency, and the overall epicardial elastin fiber mapping showed certain correlation with the helical heart muscle fiber architecture. When compared to the epicardial layer, the endocardial layer was thicker and has a higher elastin-collagen ratio and a denser elastin fiber network; moreover, the endocardial elastin fibers were finer and more wavy than the epicardial elastin fibers, all suggesting various interface mechanics. The myocardial interstitial elastin fibers co-exist with the perimysial collagen to bind the cardiomyocyte bundles; some of the interstitial elastin fibers showed a locally aligned, hinge-like structure to connect the adjacent cardiomyocyte bundles. This collagen-elastin combination reflects an optimal design in which the collagen provides mechanical strength and elastin fibers facilitate recoiling during systole. Moreover, cardiac elastin fibers, along with collagen network, closely associated with the Purkinje cells, indicating that this ECM association could be essential in organizing cardiac Purkinje cells into "fibrous" and "branching" morphologies and serving as a protective feature when Purkinje fibers experience large deformations in vivo. In short, our observations provide a structural basis for future in-depth biomechanical investigations and biomimicking of this long-overlooked cardiac ECM component.

Using models to advance medicine: mathematical modeling of post-myocardial infarction left ventricular remodeling.

The heart is an organ with limited capacity for regeneration and repair. The irreversible cell death and corresponding diminished ability of the heart to repair after myocardial infarction (MI), is a leading cause of morbidity and mortality worldwide. In this paper, a new mathematical model is presented to study the left ventricular (LV) remodeling and associated events after MI. The model accurately describes and predicts the interactions among heart cells and the immune system post-MI in the absence of medical interventions. The resulting system of nonlinear ordinary differential equations is studied both analytically and numerically in order to demonstrate the functionality and performance of the new model. To the best of our knowledge, this model is the only one of its kind to consider and correctly apply all of the known factors in diseased heart LV modeling. This model has the potential to provide researchers with a predictive computational tool to better understand the MI pathology and develop various cell-based treatment options, with benefits of lowering the cost and reducing the development time.

Investigating the Transient Regenerative Potential of Cardiac Muscle Using a Neonatal Pig Partial Apical Resection Model.

Researchers have shown that adult zebrafish have the potential to regenerate 20% of the ventricular muscle within two months of apex resection, and neonatal mice have the capacity to regenerate their heart after apex resection up until day 7 after birth. The goal of this study was to determine if large mammals (porcine heart model) have the capability to fully regenerate a resected portion of the left ventricular apex during the neonatal stage, and if so, how long the regenerative potential persists. A total of 36 piglets were divided into the following groups: 0-day control and surgical groups and seven-day control and surgical groups. For the apex removal groups, each piglet was subjected to a partial wall thickness resection (~30% of the ventricular wall thickness). Heart muscle function was assessed via transthoracic echocardiograms; the seven-day surgery group experienced a decrease in ejection fraction and fractional shortening. Upon gross necropsy, for piglets euthanized four weeks post-surgery, all 0-day-old hearts showed no signs of scarring or any indication of the induced injury. Histological analysis confirmed that piglets in the 0-day surgery group exhibited various degrees of regeneration, with half of the piglets showing full regeneration and the other half showing partial regeneration. However, each piglet in the seven-day surgery group demonstrated epicardial fibrosis along with moderate to severe dissecting interstitial fibrosis, which was accompanied by an abundant collagenous extracellular matrix as the result of a scar formation in the resection site. Histology of one 0-day apex resection piglet (briefly lain on and accidentally killed by the mother sow three days post-surgery) revealed dense, proliferative mesenchymal cells bordering the fibrin and hemorrhage zone and differentiating toward immature cardiomyocytes. We further examined the heart explants at 5-days post-surgery (5D PO) and 1-week post-surgery (1W PO) to assess the repair progression. For the 0-day surgery piglets euthanized at 5D PO and 1W PO, half had abundant proliferating mesenchymal cells, suggesting active regeneration, while the other half showed increased extracellular collagen. The seven-day surgery piglets euthanized at 5D PO, and 1W PO showed evidence of greatly increased extracellular collagen, while some piglets had proliferating mesenchymal cells, suggesting a regenerative effort is ongoing while scar formation seems to predominate. In short, our qualitative findings suggest that the piglets lose the full myocardial regenerative potential by 7 days after birth, but greatly preserve the regenerative potential within 1 day post-partum.

In vitro comparison of harvesting site effects on cardiac extracellular matrix hydrogels.

Cardiac extracellular matrix (cECM) derived hydrogel has been investigated to treat myocardial infarction through animal studies and clinical trials. The tissue harvesting site commonly selects porcine left ventricle (LV) because heart attack majorly takes place in LV. However, little is known about whether the region of cardiac tissue harvesting is critical for downstream applications. In this work, in vitro studies to compare cECM hydrogels derived from adult porcine whole heart (WH), LV, and right ventricle (RV) were performed. The cECM from WH has similar chemical composition compared with cECM from LV and RV. All three types of cECM hydrogels share many similarities in terms of their microstructure, gelation time, and mechanical properties. WH-derived cECM hydrogels have larger variations in storage modulus (G') and complex modulus (G*) compared with the other two types of cECM hydrogels. Both human cardiomyocytes and mesenchymal stem cells could maintain high cell viability on all hydrogels without significant difference. In terms of above results, the cECM hydrogels from WH, LV and RV exhibited similarity in material properties and cell response in vitro. Thus, future fabrication of cECM hydrogels from WH would increase the yield, which would decrease processing time and production cost.

Current advances in biodegradable synthetic polymer based cardiac patches.

The number of people affected by heart disease such as coronary artery disease and myocardial infarction increases at an alarming rate each year. Currently, the methods to treat these diseases are restricted to lifestyle change, pharmaceuticals, and eventually heart transplant if the condition is severe enough. While these treatment options are the standard for caring for patients who suffer from heart disease, limited regenerative ability of the heart restricts the effectiveness of treatment and may lead to other heart-related health problems in the future. Because of the increasing need for more effective therapeutic technologies for treating diseased heart tissue, cardiac patches are now a large focus for researchers. The cardiac patches are designed to be integrated into the patients' natural tissue to introduce mechanical support and healing to the damaged areas. As a promising alternative, synthetic biodegradable polymer based biomaterials can be easily manipulated to customize material properties, as well as possess certain desired characteristics for cardiac patch use. This comprehensive review summarizes recent works on synthetic biodegradable cardiac patches implanted into infarcted animal models. In addition, this review describes the basic requirements that should be met for cardiac patch development, and discusses the inspirations to designing new biomaterials and technologies for cardiac patches.

Heart valve tissue-derived hydrogels: Preparation and characterization of mitral valve chordae, aortic valve, and mitral valve gels.

Heart valve (HV) diseases are among the leading causes of death and continue to threaten public health worldwide. The current clinical options for HV replacement include mechanical and biological prostheses. However, an ongoing problem with current HV prostheses is their failure to integrate with the host tissue and their inability grow and remodel within the body. Tissue engineered heart valves (TEHVs) are a promising solution to these problems, as they are able to grow and remodel somatically with the rest of the body. Recently, decellularized HVs have demonstrated great potential as valve replacements because they are tissue specific, but recellularization is still a challenge due to the dense HV extracellular matrix (ECM) network. In this proof-of-concept work, we decellularized porcine mitral valve chordae, aortic valve leaflets, and mitral valve leaflets and processed them into injectable hydrogels that could accommodate any geometry. While the three valvular ECMs contained various amounts of collagen, they displayed similar glycosaminoglycan contents. The hydrogels had similar nanofibrous structures and gelation kinetics with various compressive strengths. When encapsulated with NIH 3 T3 fibroblasts, all the hydrogels supported cell survivals up to 7 days. Decellularized HV ECM hydrogels may show promising potential HV tissue engineering applications. © 2018 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater 107B: 1732-1740, 2019.

Epicardial prestrained confinement and residual stresses: a newly observed heart ventricle confinement interface.

The heart epicardial layer, with elastin as the dominant component, has not been well investigated, specifically on how it contributes to ventricular biomechanics. In this study, we revealed and quantitatively assessed the overall status of prestraining and residual stresses exerted by the epicardial layer on the heart left ventricle (LV). During porcine heart wall dissection, we discovered that bi-layered LV surface strips, consisting of an epicardial layer and cardiac muscle, always curled towards the epicardial side due to epicardial residual stresses. We hence developed a curling angle characterization technique to intuitively and qualitatively reveal the location-dependency and direction-dependency of epicardial residual stresses. Moreover, by combining prestrain measurement and biaxial mechanical testing, we were able to quantify the epicardial prestrains and residual stresses on the unpressurized intact LV. To investigate the potential mechanical effect of epicardial prestraining, a finite-element (FE) model has been constructed, and we demonstrate that it is the prestraining of the epicardial layer, not the epicardial layer alone, providing an additional resistance mechanism during LV diastolic expansion and ventricular wall protection by reducing myocardial stress. In short, our study on healthy, native porcine hearts has revealed an important phenomenon-the epicardial layer, rich in elastin, acts like a prestrained 'balloon' that wraps around the heart and functions as an extra confinement and protection interface. The obtained knowledge fills a gap in ventricular biomechanics and will help design novel biomimicking materials or prosthetic devices to target the maintenance/recreation of this ventricle confinement interface.