Symmetry-breaking charge transfer in a zinc chlorodipyrrin acceptor for high open circuit voltage organic photovoltaics.

Low open-circuit voltages significantly limit the power conversion efficiency of organic photovoltaic devices. Typical strategies to enhance the open-circuit voltage involve tuning the HOMO and LUMO positions of the donor (D) and acceptor (A), respectively, to increase the interfacial energy gap or to tailor the donor or acceptor structure at the D/A interface. Here, we present an alternative approach to improve the open-circuit voltage through the use of a zinc chlorodipyrrin, ZCl [bis(dodecachloro-5-mesityldipyrrinato)zinc], as an acceptor, which undergoes symmetry-breaking charge transfer (CT) at the donor/acceptor interface. DBP/ZCl cells exhibit open-circuit voltages of 1.33 V compared to 0.88 V for analogous tetraphenyldibenzoperyflanthrene (DBP)/C60-based devices. Charge transfer state energies measured by Fourier-transform photocurrent spectroscopy and electroluminescence show that C60 forms a CT state of 1.45 ± 0.05 eV in a DBP/C60-based organic photovoltaic device, while ZCl as acceptor gives a CT state energy of 1.70 ± 0.05 eV in the corresponding device structure. In the ZCl device this results in an energetic loss between E(CT) and qV(OC) of 0.37 eV, substantially less than the 0.6 eV typically observed for organic systems and equal to the recombination losses seen in high-efficiency Si and GaAs devices. The substantial increase in open-circuit voltage and reduction in recombination losses for devices utilizing ZCl demonstrate the great promise of symmetry-breaking charge transfer in organic photovoltaic devices.

Very low band gap thiadiazoloquinoxaline donor-acceptor polymers as multi-tool conjugated polymers.

Here we report on the synthesis of two novel very low band gap (VLG) donor-acceptor polymers (Eg ≤ 1 eV) and an oligomer based on the thiadiazoloquinoxaline acceptor. Both polymers demonstrate decent ambipolar mobilities, with P1 showing the best performance of ∼10(-2) cm(2) V(-1) s(-1) for p- and n-type operation. These polymers are among the lowest band gap polymers (≲0.7 eV) reported, with a neutral λmax = 1476 nm (P2), which is the farthest red-shifted λmax reported to date for a soluble processable polymer. Very little has been done to characterize the electrochromic aspects of VLG polymers; interestingly, these polymers actually show a bleaching of their neutral absorptions in the near-infrared region and have an electrochromic contrast up to 30% at a switching speed of 3 s.

Photocurrent enhancement from diketopyrrolopyrrole polymer solar cells through alkyl-chain branching point manipulation.

Systematically moving the alkyl-chain branching position away from the polymer backbone afforded two new thieno[3,2-b]thiophene-diketopyrrolopyrrole (DPPTT-T) polymers. When used as donor materials in polymer:fullerene solar cells, efficiencies exceeding 7% were achieved without the use of processing additives. The effect of the position of the alkyl-chain branching point on the thin-film morphology was investigated using X-ray scattering techniques and the effects on the photovoltaic and charge-transport properties were also studied. For both solar cell and transistor devices, moving the branching point further from the backbone was beneficial. This is the first time that this effect has been shown to improve solar cell performance. Strong evidence is presented for changes in microstructure across the series, which is most likely the cause for the photocurrent enhancement.

Anomalous Charge Transport in Conjugated Polymers Reveals Underlying Mechanisms of Trapping and Percolation.

While transport in conjugated polymers has many similarities to that in crystalline inorganic materials, several key differences reveal the unique relationship between the morphology of polymer films and the charge mobility. We develop a model that directly incorporates the molecular properties of the polymer film and correctly predicts these unique transport features. At low degree of polymerization, the increase of the mobility with the polymer chain length reveals trapping at chain ends, and saturation of the mobility at high degree of polymerization results from conformational traps within the chains. Similarly, the inverse field dependence of the mobility reveals that transport on single polymer chains is characterized by the ability of the charge to navigate around kinks and loops in the chain. These insights emphasize the connection between the polymer conformations and the transport and thereby offer a route to designing improved device morphologies through molecular design and materials processing.

Percolation, Tie-Molecules, and the Microstructural Determinants of Charge Transport in Semicrystalline Conjugated Polymers.

Semiconducting polymers play an important role in a wide range of optical and electronic material applications. It is widely accepted that the polymer ordering impacts charge transport in such devices. However, the connection between molecular ordering and device performance is difficult to predict due to the current need for a mathematical theory of the physics that dictate charge transport in semiconducting polymers. We present an analytical and computational description of semicrystalline conjugated polymer materials that captures the impact of polymer conformation on charge transport in heterogeneous thin films. We first develop an analytical theory for the statistical behavior of a polymer chain emanating from a crystallite, predicting the average distance to the first kink that would trap a charge. This analysis is used to define the conditions where percolation would lead to efficient transport through a semicrystalline material. We then establish a model that predicts the multiscale charge transport. This model is used to identify the speed limits of charge transport at short and long time scales for varying fraction of crystallinity. This work provides a rational framework to connect molecular organization to device performance.