Bragg Curve Detection of Low-Energy Protons by Radiophotoluminescence Imaging in Lithium Fluoride Thin Films.

Lithium fluoride (LiF) crystals and thin films are utilized as radiation detectors for energy diagnostics of proton beams. This is achieved by analyzing the Bragg curves in LiF obtained by imaging the radiophotoluminescence of color centers created by protons. In LiF crystals, the Bragg peak depth increases superlinearly with the particle energy. A previous study has shown that, when 35 MeV protons impinge at grazing incidence onto LiF films deposited on Si(100) substrates, the Bragg peak in the films is located at the depth where it would be found in Si rather than in LiF due to multiple Coulomb scattering. In this paper, Monte Carlo simulations of proton irradiations in the 1-8 MeV energy range are performed and compared to experimental Bragg curves in optically transparent LiF films on Si(100) substrates. Our study focuses on this energy range because, as energy increases, the Bragg peak gradually shifts from the depth in LiF to that in Si. The impact of grazing incidence angle, LiF packing density, and film thickness on shaping the Bragg curve in the film is examined. At energies higher than 8 MeV, all these quantities must be considered, although the effect of packing density plays a minor role.

In Vivo Radiobiological Investigations with the TOP-IMPLART Proton Beam on a Medulloblastoma Mouse Model.

Protons are now increasingly used to treat pediatric medulloblastoma (MB) patients. We designed and characterized a setup to deliver proton beams for in vivo radiobiology experiments at a TOP-IMPLART facility, a prototype of a proton-therapy linear accelerator developed at the ENEA Frascati Research Center, with the goal of assessing the feasibility of TOP-IMPLART for small animal proton therapy research. Mice bearing Sonic-Hedgehog (Shh)-dependent MB in the flank were irradiated with protons to test whether irradiation could be restricted to a specific depth in the tumor tissue and to compare apoptosis induced by the same dose of protons or photons. In addition, the brains of neonatal mice at postnatal day 5 (P5), representing a very small target, were irradiated with 6 Gy of protons with two different collimated Spread-Out Bragg Peaks (SOBPs). Apoptosis was visualized by immunohistochemistry for the apoptotic marker caspase-3-activated, and quantified by Western blot. Our findings proved that protons could be delivered to the upper part while sparing the deepest part of MB. In addition, a comparison of the effectiveness of protons and photons revealed a very similar increase in the expression of cleaved caspase-3. Finally, by using a very small target, the brain of P5-neonatal mice, we demonstrated that the proton irradiation field reached the desired depth in brain tissue. Using the TOP-IMPLART accelerator we established setup and procedures for proton irradiation, suitable for translational preclinical studies. This is the first example of in vivo experiments performed with a "full-linac" proton-therapy accelerator.

Influence of a Solid Surface on PNIPAM Microgel Films.

Stimuli-responsive microgels have attracted great interest in recent years as building blocks for fabricating smart surfaces with many technological applications. In particular, PNIPAM microgels are promising candidates for creating thermo-responsive scaffolds to control cell growth and detachment via temperature stimuli. In this framework, understanding the influence of the solid substrate is critical for tailoring microgel coatings to specific applications. The surface modification of the substrate is a winning strategy used to manage microgel-substrate interactions. To control the spreading of microgel particles on a solid surface, glass substrates are coated with a PEI or an APTES layer to improve surface hydrophobicity and add positive charges on the interface. A systematic investigation of PNIPAM microgels spin-coated through a double-step deposition protocol on pristine glass and on functionalised glasses was performed by combining wettability measurements and Atomic Force Microscopy. The greater flattening of microgel particles on less hydrophilic substrates can be explained as a consequence of the reduced shielding of the water-substrate interactions that favors electrostatic interactions between microgels and the substrate. This approach allows the yielding of effective control on microgel coatings that will help to unlock new possibilities for their application in biomedical devices, sensors, or responsive surfaces.

Photoluminescence from a homogeneous volume source within an optical multilayer: analytical formulas.

A theoretical model for light emission from a homogeneous volume source, such as an optically active layer, within a multilayer is demonstrated. The role of an external linearly polarized optical pump is taken into account. The resulting formulas for the radiated powers are fully analytical. They are applied to investigate the effect of a plane-wave pump in a basic λ/2 cavity and to calculate the photoluminescence polar diagrams of color centers from three resonating thin-film lithium-fluoride-based microstructures.

Superficial and Shroud-like coloration of linen by short laser pulses in the vacuum ultraviolet.

We present a survey on five years of experiments of excimer laser irradiation of linen fabrics, seeking a coloration mechanism able to reproduce the microscopic complexity of the body image embedded onto the Shroud of Turin. We achieved a superficial, Shroud-like coloration in a narrow range of irradiation parameters. We also obtained latent coloration that appears after artificial or natural aging of linen following laser irradiations that, at first, did not generate any visible effect. Most importantly, we have recognized photochemical processes that account for both coloration and latent coloration.

Photo-induced gratings in thin color center layers on lithium fluoride.

We study the recording of permanent Bragg gratings on surface-colored lithium fluoride (LiF) crystals by using the interference pattern of a continuous-wave UV argon-ion laser operating at 244 nm. Gratings with spatial periodicity ranging from 400 to 1000 nm are written by using a phase-mask interferometer and are stable for several months after the writing process. Absorption and photoluminescence spectra show the bleaching of primary F and F -aggregate laser-active color centers as a result of the process. Confocal microscopy is used to determine the pitch and the profile of the fluorescent gratings. The UV laser-induced optical bleaching in highly colored LiF ultrathin layers is responsible for the periodic spatial modulation of absorption and photoemission properties that characterize the gratings. In the colored surface layer, a reduction of as much as 50% of the initial color-center-induced refractive-index increase has been estimated in the bleached areas.