Event-related potential evidence of dysfunction in automatic processing in abstinent alcoholics.

The preattentive automatic processing of 63 alcoholics and 27 controls was evaluated with an auditory inattentive event-related oddball paradigm. We examined the mismatch negativity and the N2-P3 complex. Results showed significantly greater amplitude for N2, P3 and the N2-P3 complex for controls but no individual lead (Fz, Cz, Pz) differences by group. A group-by-lead interaction was found for N2 and for the N2-P3 complex. There were no significant latency differences between groups; however, a significant age-by-group interaction effect on latency was greatest at the Cz electrode. Results reflect a possible aberration of automatic processing in alcoholics because of a defect in the mnemonic template necessary to match with an infrequent deviant stimuli. We also found suggestive evidence of a relative weakness of frontal cortical organization in alcoholics. Future studies are suggested that would help clarify these differences in alcoholics.

Spirometric reference values from a sample of the general U.S. population.

Spirometric reference values for Caucasians, African-Americans, and Mexican-Americans 8 to 80 yr of age were developed from 7,429 asymptomatic, lifelong nonsmoking participants in the third National Health and Nutrition Examination Survey (NHANES III). Spirometry examinations followed the 1987 American Thoracic Society recommendations, and the quality of the data was continuously monitored and maintained. Caucasian subjects had higher mean FVC and FEV1 values than did Mexican-American and African-American subjects across the entire age range. However, Caucasian and Mexican-American subjects had similar FVC and FEV1 values with respect to height, and African-American subjects had lower values. These differences may be partially due to differences in body build: observed Mexican-Americans were shorter than Caucasian subjects of the same age, and African-Americans on average have a smaller trunk:leg ratio than do Caucasians. Reference values and lower limits of normal were derived using a piecewise polynomial model with age and height as predictors. These reference values encompass a wide age range for three race/ethnic groups and should prove useful for diagnostic and research purposes.

Biological fate of a polydisperse acrylate polymer in anaerobic sand-medium transport.

Soluble polyacrylate (PA), a polydisperse mixture of polyacrylate polymers, is strongly adsorbed and biodegradable. Biotic fate studies were carried out with once-through columns containing sand colonized with anaerobic biomass previously grown in a methanogenic fluidized bed. A fraction of soluble PA having a weight-average molecular weight of 16,700 and a range of molecular weight from 10(3) to 10(5) was biologically removed and mineralized to CO2. Due to its polydisperse nature, the breakthrough curve had a gradual increase to an apparent steady-state removal of approximately 60% near one day when the liquid detention time was 21 minutes. Modeling successfully explained the observed breakthrough result when the fraction was divided into components having a wide range of retardation factors (R): about 25% was strongly adsorbed (R = 200 and 500), 45% was moderately adsorbed (R = 50 and 100), and 30% was weakly adsorbed (R = 1-10). In this study, in which active biomass already was present from utilization of a primary substrate (glucose here), equilibrium adsorption increased the time to breakthrough, which also reduced the exiting concentration by increasing the substrate contact time.

Estimating factors to convert Chinese 'Total Dust' measurements to ACGIH respirable concentrations in metal mines and pottery industries.

Historical data on the dust exposures of Chinese workers in metal mines (iron/copper, tin, tungsten) and pottery industries are being used in an ongoing joint Chinese/United States epidemiological study to investigate the exposure-response relationship for the development of silicosis, lung cancer, and other diseases. The historical data include 'total dust' concentrations determined by a Chinese method. Information about particle size distribution and the chemical and mineralogical content of airborne particles is generally not available. In addition, the historical Chinese sampling strategy is different from a typical American eight-hour time-weighted average (TWA) sampling strategy, because the Chinese samples were collected for approximately 15 minutes during production so the sample could be compared to their maximum allowable concentration (MAC) standard. Therefore, in order to assess American respirable dust exposure standards in light of the Chinese experience, factors are needed to convert historical Chinese total dust concentrations to respirable dust concentrations. As a part of the joint study to estimate the conversion factors, airborne dust samples were collected in 20 metal mines and 9 pottery factories in China during 1988 and 1989 using three different samplers: 10mm nylon cyclones, multi-stage 'cassette' impactors, and the traditional Chinese total dust samplers. More than 100 samples were collected and analysed for each of the three samplers. The study yielded two different estimates of the conversion factor from the Chinese total dust concentrations (measured during production processes) to respirable dust concentrations. The multivariate analysis of variance (MANOVA) reveals that, with a fixed sampling/analysis method, conversion factors were not statistically different among the different job titles within each industry. It also indicates that conversion factors among the industries were not statistically different. However, the two estimates consistently showed that conversion factors were the lowest in the pottery industry. Average conversion factors were then calculated for each of the estimates across the industries studied. A pooled mean conversion factor, 0.25+/-0.04, was then derived for all the job titles and industries. Respirable dust levels were estimated from the historical 'total dust' concentrations collected between 1952 and 1992 by adopting the American standard.

Estimating historical respirable crystalline silica exposures for Chinese pottery workers and iron/copper, tin, and tungsten miners.

Collaborative studies of Chinese workers, using over four decades of dust monitoring data, are being conducted by the National Institute for Occupational Safety and Health (NIOSH) and Tongji Medical University in China. The goal of these projects is to establish exposure-response relationships for the development of diseases such as silicosis or lung cancer in cohorts of pottery and mine workers. It is necessary to convert Chinese dust measurements to respirable silica measurements in order to make results from the Chinese data comparable to other results in the literature. This article describes the development of conversion factors and estimates of historical respirable crystalline silica exposure for Chinese workers. Ambient total dust concentrations (n>17000) and crystalline silica concentrations (n=347) in bulk dust were first gathered from historical industrial hygiene records. Analysis of the silica content in historical bulk samples revealed no trend from 1950 up to the present. During 1988-1989, side-by-side airborne dust samples (n=143 pairs) were collected using nylon cyclones and traditional Chinese samplers in 20 metal mines and nine pottery factories in China. These data were used to establish conversion factors between respirable crystalline silica concentrations and Chinese total dust concentrations. Based on the analysis of the available evidence, conversion factors derived from the 1988-1989 sampling campaign are assumed to apply to other time periods in this paper. The conversion factors were estimated to be 0.0143 for iron/copper, 0.0355 for pottery factories, 0.0429 for tin mines, and 0.0861 for tungsten mines. Conversion factors for individual facilities within each industry were also calculated. Analysis of variance revealed that mean conversion factors are significantly different among facilities within the iron/copper industry and within the pottery industry. The relative merits of using facility-specific conversion factors, industry-wide conversion factors, or a weighted average of the two are discussed. The exposure matrix of the historical Chinese total dust concentrations was multiplied by these conversion factors to obtain an exposure matrix of historical respirable crystalline silica concentrations.